One hundred circumferential aluminum fins of rectangular profile are mounted on a 1.0-m tube having a diameter of 2.5 cm. The fins are 1 cm long and 2.0 mm thick. The base temperature is 180°C, and the convection environment is at 20°C with h=50 W/m2 · °C. Calculate the total heat lost from the finned-tube arrangement over the 1.0-m length.

Q: Hot water is flowing at an average velocity of1.5 m/s through a cast iron pipe (k = 52 W/m·K) whose…

A: In order to proceed with the problem some assumptions need to be taken into consideration. Heat…

Q: Pulverized coal particles are used in oxy-fuel combustion power plants for electricity generation.…

A:

Q: At winter design conditions, a house is projected to lose heat at a rate of 60,000 Btu/h. The…

A: Given data     heat loss at a rate of =60000 Btu/h.     internal heat gain=6000 Btu/h.To determine…

Q: Hot square plate (1 m ×1 m) is to be cooled by attaching aluminum circular pin fins (D=0.25 cm, L= 3…

A: Given:- Plate=(1×1)m2D=0.25 cmL=3 cmd=0.6 cmTb=100°CT∞=30°Ch=35 W/m. °C. To find:-Total rate of heat…

Q: An electric generator at a power plant produces energy by passing superheated steam from a high…

A: Carnot cycle produce energy by utilizing the below four processes. Process of Isentropic…

Q: Clothing made of several thin layers of fabric with trapped air in between, often called ski…

A: Consider the thermal circuit shown below for the 5 layered jacket. Here, The total resistance for…

Q: Consider a steam pipe of length 15 ft, inner radius 2 in., outer radius 2.4 in., and thermal…

A:

Q: .A journal bearing is to be used for a centrifugal pump where the shaft diameter is 50 mm and the…

A: Given that, Shaft diameter = D = 50 mm Bearing length = L = 80 mm Ambient temperature = T∞=20 °C…

Q: Calculate the thermal resistance due to convection for the following situations:a. w arm water with…

A: Given Data: a. w arm water with h = 200 W⁄m2 .Kb. warm air with h = 10 W⁄m2 .Kc. warm moving air…

Q: If q" w = 5000 and the convection heat transfer coefficient at the pipe outlet is 1000 W/m2K,…

A:

Q: Convective heat transfer coefficient is 15 W/(m*K), surface area of the fin is 2 m^2, the…

A: Given Data The Convective heat transfer coefficient, h= 15 W/(m*K) The surface area of the fin, A= 2…

Q: What are the best possible solutions to increase the heat transfer rate of a body?

A: There are three modes of heat transfer; Conduction, convection and radiation. For these all modes we…

Q: H.W. Q: An aluminum pan whose thermal conductivity is 237 W/m-°C has a flat bottom with diameter 20…

A: Heat transfer by conduction is given by Fourier's law Q=-kAlA dTdx the temperature gradient decrease…

Q: Which of the following provides the basis of convection heat transfer? Group of answer choices…

A:

Q: QUESTION 7 As in the previous question, steam is flowing inside a 10-cm-diameter, long pipe whose…

A:

Q: A 1.5 cm diameter ball bearing at a temperature of 100 C is cooled by passing water at 27 C and a…

A: Given: temperature of the bearing→Tb=100°C Temperature of the water→Tw=27°C Velocity of the…

Q: Calculate the heat losses per unit length in a horizontal tube with an outside diameter of 15 cm, if…

A: Outside diameter of tube, d=15 cm=0.15 mSurface temperature of tube, Ts=400 KSurrounding air…

Q: A tube having a cylindrical shape of length equals to 100 m and diameter equals to 13 cm passes…

A: Length of the cylinder = 100m diameter of the cylinder =13cm surface temperature =110c room…

Q: A pipe carrying steam of 5 cm inside diameter and 6.5 cm outside diameter is covered with a 2.75 cm…

A:

Q: The walls of the refrigerated storage room are 10 m long and 3 m high and constructed with 90 mm…

A: Given: The thermal conductivity of concrete block is kc=0.935 W/m°C=0.935 W/mK, The thermal…

Q: Steam at 230°C is flowing through a steel pipe (k = 15W/m °C) whose inner and outer diameters are 90…

A:

Q: Fluid flows over a plane surface 1m by 1m with a bulk temperature of 50 °C. The temperature of the…

A:

Q: The cylinders that come out of the heat treatment furnace are cooled in a stagnant air environment…

A:

Q: 7-28 A transformer that is 10-cm long, 6.2-cm wide, and 5-cm high is to be cooled by attaching a…

A:

Q: Cold conditioned air at 12°C is flowing inside a 1.5-cm-thick square aluminum (k = 237 W/m·K) duct…

A: Given data: The given temperature of the cold conditioned air is: Ti=12 C The thickness of the…

Q: An electric generator at a power plant produces energy by passing superheated steam from a high…

A:

Q: Steam passes into tubes in a heating system whose outer diameter is 3 cm and whose wall is held at a…

A: Given Data: The outer diameter of the tube is, D1=3 cm=3 cm×m100 cm=0.03 m. The temperature of the…

Q: Over the outside part of the room window, the wind is blowing with a speed of 10 m/sec. Due to this…

A:

Q: A long copper rod of diameter 2.0 cm is initially at a uniform temperature of 100°C. It is now…

A: Given: diameter = 2cm Ti = 100 deg C T = 25 deg C Tinf = 13 deg C cp = 0.385 kJ/kgK = 385 J/kgK

Q: shape of a cylindrical tube with a  length of 35.0 m and an inner radius of 2.50 m. Its walls are…

A:

Q: Water is to be heated from 10°C to 80°C as it flows through a 2-cm-internal-diameter, 7-m-long tube.…

A: Given:Ti=10°C =283 KTe=80°C =353 KVolume flow rate,V=8 L/minV=8*10-360 =1.33*10-4 m3/sd=2 cm =0.02…

Q: Consider a steam pipe of length 15 ft, inner radius 2 in., outer radius 2.4 in., and thermal…

A:

Q: When a long section of a compressed air line passes through the outdoors, it is observed that the…

A:

Q: A transformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10…

A:

Q: A 1.5-m long, copper rod is removed from a heat- treatment oven at 550°C and immersed in a 55°C…

A: Given data Length of copper rod = 1.5 mTemperature of the surface of copper rod = 550 °CTemperature…

Q: An average person body surface is approximately 2.0 m². Its skin temperature is 33°C. The convection…

A: Find convective heat transfer .

Q: It is common knowledge that the temperature of air rises as it is compressed. An inventor thought…

A: The given statement is the Perpetual motion machine of 2nd kind which states that the machine will…

Q: A transformer that is 1.5 m long, 0.062 m wide, and 0.05 m high is to be cooled by attaching a 1.5-m…

A:

Q: H.W. Q:A hot surface at 100°C is to be cooled by attach- ing 3-cm-long, 0.25-cm-diameter aluminum…

A: Given data:

Q: Steam passes into tubes in a heating system whose outer diameter is 3 cm and whose wall is held at a…

A:

Q: Two pin fins are identical, except that the diameter of one of them is twice the diameter of the…

A: (a) The effectiveness of a fin can be expressed as, The ratio of effectiveness can be calculated…

Q: Required information A cylindrical fuel rod (k = 30 W/m K) of 2 cm in diameter is encased in a…

A: Given:Surface temperature of rod, Ts=200o CTs=200o C or 473 KEgen˙=100 MW/m3d= 2 cmr=1 cm or 0.01…

Q: 7-34 An array of power transistors, dissipating 5 W of power each, are to be cooled by mounting them…

A: Determine the average film temperature by using the information given in the question. Here, Ts is…

Q: A tube having a cylindrical shape of length equals to 30 m and diameter equals to 10 cm passes…

A: Length of the tube, L= 30m Tube diameter, d= 10 cm = 0.1 m Outer surface temperature of tube,…

Q: A 12-m-long and 5-m-high wall is constructed of two layers of 1-cm-thick sheetrock (k = 0.17 W/m·K)…

A: Given Data: The dimension of the wall is: 12m X 5 m The thermal conductivity of wood stud is: h…

Q: 0.5 W of heat passes from the bottom of a silicon chip (k = 130 W/m-K) and then dissipated to the…

A:

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.