P = 80 kPa T = 380 K Maj = 2.8 Normal shock - L = 3 m

Q: . Determine the aircraft Mach no. flies with the same Mach no. at elevations of 8700m (T=-55 C°) and…

A: In the above problem Mach number of aircraft is same and we are required to calculate mach no. of…

Q: Q.2. Air flows through a constant-area duct is connected to a reservoir at a temperature of 500°C…

A:

Q: What is the characteristic aspect of Rayleigh flow? What are the main assumptions associated with…

A: Characteristics: Rayleigh flow is considered as frictionless, i.e., there is no relative resistance…

Q: Air enters a 12-cm-diameter adiabatic duct at Ma1 = 0.4, T1 = 550 K, and P1 = 200 kPa. The average…

A: Given data: The average friction factor is, f = 0.021 The Mach number at the duct inlet is, Ma1=0.4…

Q: Oil with ? = 876 kg/m3 and ? = 0.24 kg/m·s is flowing through a 1.5-cm-diameter pipe that discharges…

A: Given data Determine the flow rate of oil through the pipe if the pipe is (a) horizontal (b)…

Q: Can a turbine rotation really reach supersonic speed? What is the usual cut-out speed for wind…

A: Question 1 solution:-  ( i ) The turbine pieces are spinning quite fast, thus its blade tips may be…

Q: The velocity and temperature of the flow ahead of a normal shock wave are 1215 m/s and 300 K,…

A: Write the given data.

Q: Can the Mach number of a fluid be greater than 1 after a normal shock wave? Explain.

A: Normal shock wave: The normal shock waves for supersonic flow are most likely to occurs in the…

Q: Air is heated as it flows subsonically through a 10 cm × 10 cm square duct. The properties of air at…

A: Write the given data:

Q: Consider a normal shock wave in air where the upstream flow properties are u1 = 690 m/s, T1 = 288 K,…

A:

Q: Air flows with negligible friction through a 6-in-diameter duct at a rate of 9 lbm/s. The…

A: Given data: The diameter of the duct is d=6 in. The mass flow rate of air is m=9 lbm/s. The…

Q: Nitrogen enters a duct with varying flow area at 400 K, 100 kPa, and a Mach number of 0.3. Assuming…

A: Given data as per question intitial temperature = 400 k initial pressure = 100 kpa Mach no. = 0.3…

Q: Consider a normal shockwave in air where the upstream flowproperties are u1 = 680 m/s, T1 = 288 K,…

A: Given data: The upstream velocity is, U1 = 680 m/s. The upstream temperature is, T1 = 288 K. The…

Q: Helium is heated as it flows subsonically through a 10 cm × 10 cm square duct. The properties of…

A:

Q: What is the effect of heating the fluid on the flow velocity in subsonic Rayleigh flow? Answer the…

A: Rayleigh flow is defined as a non-adiabatic, frictionless flow which passes through a fixed area…

Q: Consider a normal shock wave in air where the upstream flow properties are u1 = 660 m/s,…

A: Given data:      Upstream flow properties      u1 =660m/s      T1 =288K      P1=1 atm=0.101 mpa…

Q: Air enters a 5.5-cm-diameter adiabatic duct with inlet conditions of Ma1 = 2.2, T1 = 250 K, and P1 =…

A: Write the values of pressure ratio and temperature ratio at duct inlet corresponding to the Mach…

Q: Air enters a compressor with a stagnation pressure of 100 kPa and a stagnation temperature of 35°C,…

A: Given: The initial stagnation pressure of the air is P1=100 kPa. The final stagnation pressure of…

Q: Air flowing at 8 psia, 480 R, and Ma1 = 2.0 is forced to undergo a compression turn of 15°.…

A: From Prandtl-Meyer function relation,…

Q: A gas initially at a supersonic velocity enters an adiabatic diverging duct. Discuss how this…

A: Part (a) The relation between change in velocity and the change in the area comprising Mach number…

Q: Air is heated as it flows subsonically through a duct. When the amount of heat transfer reaches 67…

A: Given data Amount of heat transfer = 67kJ/kg Velocity of air V2=680 m/sec static pressure P2=270ka…

Q: How do oblique shocks occur? How do oblique shocks differ from normal shocks?

A: When an object moves through a medium, the molecules of the medium get deflected. When the velocity…

Q: Air enters a 12-cm-diameter adiabatic duct with inlet conditions of V1 = 150 m/s, T1 = 500 K, and P1…

A: Write the formula to calculate the speed of sound at the inlet. c1=kRT1 Here, T1 is the inlet…

Q: what is the jet velocity?

A:

Q: Nitrogen enters a duct with varying flow area at 400 K, 100 kPa, and a Mach number of 0.5. Assuming…

A: Given data: The temperature at the inlet of the duct, T1 = 400 K. The pressure at the inlet of the…

Q: Determine the stagnation temperature and stagnation pressure of air that is flowing at 36 kPa, 238…

A: Given data as per the question The pressure of air =36 kpa The temperature of air =238 k velocity of…

Q: Consider subsonic Fanno flow accelerated to sonic velocity (Ma = 1) at the duct exit as a result of…

A: Given, Initially, the flow is the subsonic flow. The Mach number for Sub-sonic flow is less than…

Q: Consider supersonic flow of air through a 7-cm-diameter duct with negligible friction. Air enters…

A: Given Data Properties of air  R = 0.287 Kj/Kg-K CP = 1.005 Kj/Kg-K K=1.4 Inlet condition Ma1 = 1.8,…

Q: Air is cooled as it flows through a 30-cm-diameter duct. The inlet conditions are Ma1 = 1.2, T01 =…

A: Given, Ma1 = 1.2, T01 = 350 K, P01 = 240 kPa  Ma2 = 2.0 diameter of duct (d) = 30 cm

Q: Combustion gases with an average specific heat ratio of k=1.33 and a gas constant of R=0.280 kJ/kgK…

A: Write the given information.

Q: Air flows through a 6-in-diameter, 50-ft-long adiabatic duct with inlet conditions of V1 = 500 ft/s,…

A: Given, D1 = 6 in L1 = 50 ft V1 = 500 ft/s T01 = 650 R P1 = 50 psia f = 0.02

Q: The compressed air requirements of a textile factory are met by a large compressor that draws in 0.6…

A: Properties of air at 60 degrees Celsius are: The roughness of the galvanized steel pipe is Given…

Q: Argon gas enters a constant cross-sectional area duct at Ma1 = 0.2, P1 = 320 kPa, and T1 = 400 K at…

A: Given data M1=0.2P1=320 kPaT1=400 K

Q: For an ideal gas flowing through a normal shock, develop a relation for V2/V1 in terms of k, Ma1,…

A: Given Volume V2 and V1 Mass entity Ma1 and Ma2 Constant term k To find Mathematical relation between…

Q: What is the effect of friction on the entropy of the fluid during Fanno flow?

A: According to the Second law of thermodynamics, entropy must always increase for Fanno flow.

Q: What is the effect of heat gain and heat loss on the entropy of the fluid during Rayleigh flow?

A: Rayleigh flow is basically friction less, non adiabatic flow through a constant area duct.

Q: Q.1. Air flow adiabatically in a constant area duct. At the inlet of the duct, the Mach number,…

A: Given Data : At Inlet Mach Number Mi = 0.6 Pressure Pi = 150 KPa Temperature Ti =300 K Duct Length…

Q: Starting with the differential form of the energy equation, show that the flow velocity increases…

A: When fluid in Rayleigh flow with subsonic velocity is heated, the Mach number of the fluid increases…

Q: Is it possible to accelerate a gas to supersonic velocity in a converging nozzle

A: As we know that the value of Mach number can be maximum as unity at the smallest area of the nozzle.

Q: Are the isentropic relations of ideal gases applicable for flows across (a) normal shock waves, (b)…

A: (a) For a normal shock wave the isentropic relation for the ideal gas can not be applied. (b) Across…

Q: Show that if the gas flows are ultra-relativistic both upstream and downstream of a hydrodynamic…

A: given; lets take upstream velocity =u1lets take downstream velocity =u2

Q: Consider supersonic Fanno flow that is decelerated to sonic velocity (Ma = 1) at the duct exit as a…

A: The flow at the duct exit remains sonic. The mass flow rate must remain constant since upstream…

Q: Air enters a 7-m-long section of a rectangular duct of cross section 15 cm × 20 cm made of…

A:

Q: Air (y = 1.4 and R = 0.287 kJ/kg.K) enters a constant-area insulated duct with a Mach number of…

A:

Q: how and why the stagnation enthalpy is defined? How does it differ from ordinary static enthalpy

A: The stagnation enthalpy h0 is defined as the sum of static enthalpy and kinetic energy. It is…

Q: What will happen to the entropy of a flow across a shock? O It will stay the same O It will decrease…

A:

Q: abcdefghikimnopqrstuvwxyz abcdefghjklmnopqrstuvwxyz abcdefghijklmnop yz A converging nozzle has a…

A: