P = 200 kPa T = 550 K Ma, = 0.8 Maj = 0.4
Q: What does the "compressibility effect " mean? What is the influence of air compressibility on the…
A: The study of high-speed aerodynamics is a subset of aeronautics. Because the compressibility effects…
Q: The shock wave photograph of a wedge structure is given. By using this photograph determine the Mach…
A: Given Wedge To find The Mach number from the photograph
Q: additional Air (K 1.4) flows into a constant-area insulated duct with a Mach number of 0.20. For a…
A: INTRODUCTION: The Mach number is defined as the ratio of the fluid velocity to the sound speed. The…
Q: Q.2. Air flows through a constant-area duct is connected to a reservoir at a temperature of 500°C…
A:
Q: What is the characteristic aspect of Rayleigh flow? What are the main assumptions associated with…
A: Characteristics: Rayleigh flow is considered as frictionless, i.e., there is no relative resistance…
Q: What is the difference between Inlet velocity and superficial velocity?
A: given: What is the difference between Inlet velocity and superficial velocity?
Q: Can the Mach number of a fluid be greater than 1 after a normal shock wave? Explain.
A: Normal shock wave: The normal shock waves for supersonic flow are most likely to occurs in the…
Q: Air (y = 1.4 and R = 0.287 kJ/kg K) enters a constant-area insulated duct with a Mach number of…
A:
Q: On a T-s diagram of Rayleigh flow, what do the points on the Rayleigh line represent?
A: Rayleigh flow refers to a frictionless and non-adiabatic flow of ideal gas through a constant area…
Q: Air is heated as it flows subsonically through a 10 cm × 10 cm square duct. The properties of air at…
A: Write the given data:
Q: Consider a normal shock wave in air where the upstream flow properties are u1 = 690 m/s, T1 = 288 K,…
A:
Q: Air flows with negligible friction through a 6-in-diameter duct at a rate of 9 lbm/s. The…
A: Given data: The diameter of the duct is d=6 in. The mass flow rate of air is m=9 lbm/s. The…
Q: What is the effect of heating the fluid on the flow velocity in subsonic Rayleigh flow? Answer the…
A: Rayleigh flow is defined as a non-adiabatic, frictionless flow which passes through a fixed area…
Q: Consider a normal shock wave in air where the upstream flow properties are u1 = 660 m/s,…
A: Given data: Upstream flow properties u1 =660m/s T1 =288K P1=1 atm=0.101 mpa…
Q: b) Air flows through a cylindrical duct at a rate of 2.3 kg/s. Friction between air and the duct and…
A: Given: For air, The mass flow rate, m = 2.3 kg/s The inlet temperature, T1 = 450 K The inlet…
Q: Air (y = 1.4 and R = 0.287 kJ/kg· K) enters a constant-area insulated duct with a Mach number of…
A:
Q: Air enters a 5.5-cm-diameter adiabatic duct with inlet conditions of Ma1 = 2.2, T1 = 250 K, and P1 =…
A: Write the values of pressure ratio and temperature ratio at duct inlet corresponding to the Mach…
Q: 15. Determine the aircraft Mach no. flies with the same Mach no. at elevations of 8100m (T=-44 C°)…
A: The Mach number of the flight at 8100 meters can be expressed as,
Q: Air enters a compressor with a stagnation pressure of 100 kPa and a stagnation temperature of 35°C,…
A: Given: The initial stagnation pressure of the air is P1=100 kPa. The final stagnation pressure of…
Q: Compressed air from the compressor of a gas turbine enters the combustion chamber at T1 = 700 K, P1…
A: Given, T1 = 700 K P1 = 600 kPa Ma1 = 0.2. Mach number is less than 1. So the flow is subsonic.…
Q: Air flowing at 32 kPa, 240 K, and Ma1 = 3.6 is forced to undergo an expansion turn of 15°. Determine…
A: Given, P1 = 32 kPa, T1 = 240 K Ma1 = 3.6 δ= 15° The deflection angle is equal to the wedge…
Q: Air is heated as it flows subsonically through a duct. When the amount of heat transfer reaches 67…
A: Given data Amount of heat transfer = 67kJ/kg Velocity of air V2=680 m/sec static pressure P2=270ka…
Q: Nitrogen flows from a reservoir in which its velocity is negligible and its temperature is 22°C. The…
A:
Q: Is it possible to accelerate a gas to a supersonic velocity in a converging nozzle? Explain
A: We have a standard equation, dAA=dpρV21-M2 The above equation is both for nozzle and diffuser, For a…
Q: A centrifugal compressor has an impeller tip speed of 360 m/s. Determine the absolute Mach number of…
A:
Q: AQ2) Air (y = 1.4) flows into a constant-area insulated duct with a Mach number of 0.20. For a duct…
A:
Q: Solve for the ratio of the initial to final speed of sound if an air expands isentropically from…
A:
Q: Q4-Air enters a 12-cm-diameter adiabatic duct at M1=0.4, TI-550 K, and P1= 200 kPa. The average…
A:
Q: what is the jet velocity?
A:
Q: How does the parameter Ma* differ from the Mach number Ma?
A: the parameter Ma* differ from the Mach number Ma
Q: Q.1. Air flow adiabatically in a constant area duct. At the inlet of the duct, the Mach number,…
A:
Q: Determine the stagnation temperature and stagnation pressure of air that is flowing at 36 kPa, 238…
A: Given data as per the question The pressure of air =36 kpa The temperature of air =238 k velocity of…
Q: Nitrogen flows from a reservoir in which its velocity is negligible and its temperature is 22°C. The…
A: Given: T = 22 + 273 = 295 K M = 2
Q: Combustion gases with an average specific heat ratio of k=1.33 and a gas constant of R=0.280 kJ/kgK…
A: Write the given information.
Q: Air flows through a 6-in-diameter, 50-ft-long adiabatic duct with inlet conditions of V1 = 500 ft/s,…
A: Given, D1 = 6 in L1 = 50 ft V1 = 500 ft/s T01 = 650 R P1 = 50 psia f = 0.02
Q: Argon gas enters a constant cross-sectional area duct at Ma1 = 0.2, P1 = 320 kPa, and T1 = 400 K at…
A: Given data M1=0.2P1=320 kPaT1=400 K
Q: For an ideal gas flowing through a normal shock, develop a relation for V2/V1 in terms of k, Ma1,…
A: Given Volume V2 and V1 Mass entity Ma1 and Ma2 Constant term k To find Mathematical relation between…
Q: Air enters a 5-cm-diameter, 4-m-long adiabatic duct with inlet conditions of Ma1 = 2.8, T1 = 380 K,…
A: Take the properties of air to be k = 1.4, cp = 1.005 kJ/kg-K, and R = 0.287kJ/kg-K. The average…
Q: The Airbus A-340 passenger plane has a maximum takeoff weight of about 260,000 kg, a length of 64 m,…
A: Given data: The temperature at the cruising altitude, T = -60°C. Maximum cruising speed, Vmax = 945…
Q: Air Is flowing isentropically through a converging duct wl)lcJ,,is fed from a. large reservoir where…
A: Stagnation point: The point at which the velocity of the fluid becomes zero. When the fluid is…
Q: What is the effect of heat gain and heat loss on the entropy of the fluid during Rayleigh flow?
A: Rayleigh flow is basically friction less, non adiabatic flow through a constant area duct.
Q: Are the isentropic relations of ideal gases applicable for flows across (a) normal shock waves, (b)…
A: (a) For a normal shock wave the isentropic relation for the ideal gas can not be applied. (b) Across…
Q: When an airplane is flying at a constant speed relative to the ground, is it correct to say that the…
A: Mach number is given by the relation Mach number=Velocity of the aircraftSpeed of sound Now…
Q: Show that if the gas flows are ultra-relativistic both upstream and downstream of a hydrodynamic…
A: given; lets take upstream velocity =u1lets take downstream velocity =u2
Q: Air (y = 1.4 and R = 0.287 kJ/kg · K) enters a constant-area insulated duct with a Mach number of…
A: Stagnation Point: The point at which the velocity of the flow is zero is known as the stagnation…
Q: How is the Mach number of a flow defined? What does a Mach number of 2 indicate?
A: Mach number⇒Mach number is defined as the ratio of speed of body to speed of sound in surrounding…
Q: Air (y = 1.4 and R = 0.287 kJ/kg.K) enters a constant-area insulated duct with a Mach number of…
A:
Q: abcdefghikimnopqrstuvwxyz abcdefghjklmnopqrstuvwxyz abcdefghijklmnop yz A converging nozzle has a…
A:
Air enters a 12-cm-diameter adiabatic duct at Ma1 = 0.4, T1 = 550 K, and P1 = 200 kPa. The average friction factor for the duct is estimated to be 0.021. If the Mach number at the duct exit is 0.8, determine the duct length, temperature, pressure, and velocity at the duct exit.
Step by step
Solved in 4 steps with 10 images
- N2O expands isentropically through a duct from p1 =200 kPa and T1 = 250°C to a downstream section wherep2 = 26 kPa and V2 = 594 m/s. Compute (a) T2; (b) Ma2;(c) To; (d ) po; (e) V1; and (f ) Ma1.A turbine of 9000 B.H.P. is working under a head of 25 mand runs at 100 R.P.M.- What will be the type of turbine ? Whatshould be its speed and power, when it is working under a head of16 m?( See I have Attached Solution Too ,That I have recieved Earlier but It seems to be Wrong , I think W =P(Vs+Vc) Can anybody Clarify it.) An engine cylinder is 127mm in diameter, and the piston stroke is 508mm long, the clearance volume is 0.001m3, and the pressure constant is 735kPa. What is the work done in the cylinder during a single stroke? A) 3.995 kJ B) 2.530 kJ C) 8.576 kJ D) 5.287 kJ
- 3.) An air conditioning duct is rectangular in cross section (15 x 30 in.) and has air at 15 psia and 40oF flowing through it with a velocity of 24ft/sec. Determine the convective coefficient.Q3. A new 187 MW hydropower station is to be built at a site where the available head is estimated at 307 m. The generators require the turbine to rotate at 17 rad/sec. The only available turbines are Francis turbines with KN (the non-dimensional parameter to classify turbine ) equal to 0.07 .Determine the number of turbines required.Define the Under steady-flow conditions?
- Calculate the mixing ratio (w) and saturation mixing ratio (ws) if T=35c and Td=10c. Assume p=1 atmosphere (1013.25 hPa. Use temperature appropriate values of lv.In this problem should we add the friction losses in Bernoullis equation ? also, shouldnt we divide by gc=32.17? Please help, I'm confused The initial condition of air in an air compressor is 100 Kpa and 25 degrees Celcius and discharges air at 725 Kpa. The bore and stroke are 276 mm and 186 mm respectively with 3 % clearance runningat 6 rev/sec.1.1 Illustrate the PV diagram 1.2 Discuss the processes in PV diagram 1.3 Solve the volumetric effieciency
- fan ventilates at 500rev/min, the airflow is measyured at 150cubic meters/second. the ventilation pressure is 0.40kPa while thepressure along fan is0.85kPa.the mine requires 100cubic meters/second of air flow on an off day.efficiency=0.75. 1.new slow down speed required on an off day 2. Annual savings in electricty if the costs is R0.63/kWh 3. Comment on any savings in the maximum demand. 4. methods for reduction of speed on off-day.2. A hydro-electric plant having 50 km2 reservoir area and 100 m head is used to generate power. The energy utilized by the consumers whose load is connected to the power plant during a five hour period is 13.5 x 106 kW-hr. The over-all generation efficiency is 75 %. Find the fall in the height of water in the reservoir after the 5 hour period. show Complete Solution/s (i.e. transformations, equivalent formula, etc).A pump increases the pressure of water from 100 kPa to 900 kPa to an elevation of 35 m. The inlet and outlet diameters are identical. The net head of the pump is (a) 143 m (b) 117 m (c) 91 m (d) 70 m (e) 35 m