P S*: States S* -S*: Process A*: Area QS3 $1 $2 A1 Fluid goes through four state changes S1, S2, S3 and S4 and three process S1-S2, S2-S3, S3-S4 as shown in the P-v diagram below. Answer the following: a. Which process(es) is/are isothermal? b. Which process(es) is/are isochoric? c. What does area A1 represent? d. Which process(es) has/have zero work ? Edit View Incort Format Tools Table S4

P S: States S -S: Process A: Area QS3 $1 $2 A1 Fluid goes through four state changes S1, S2, S3 and S4 and three process S1-S2, S2-S3, S3-S4 as shown in the P-v diagram below. Answer the following: a. Which process(es) is/are isothermal? b. Which process(es) is/are isochoric? c. What does area A1 represent? d. Which process(es) has/have zero work ? Edit View Incort Format Tools Table S4

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An air bubble rises from the bottom of a well where the temperature is 25oC, to the surface where the temperature is 27o If the depth of the well is 5m and the atmospheric pressure is 101.325kPa, determine the following: Initial pressure inside the air bubble (P1). Volume of air bubble at state 1. Volume of air bubble at state 2. Percent increase in volume of the bubble.
As measured by NASA’s Viking landers, the atmosphereof Mars, where g ≈ 3.71 m/s 2 , is almost entirely carbondioxide, and the surface pressure averages 700 Pa. The temperatureis cold and drops off exponentially: T ≈ T o e - Cz ,where C = 1.3E-5 m - 1 and T o = 250 K. For example,at 20,000 m altitude, T ≈ 193 K. ( a ) Find an analyticformula for the variation of pressure with altitude.( b ) Find the altitude where pressure on Mars has droppedto 1 pascal.
For first law thermodynamics , Q-W = E where E is the change in total energy. My question is when should we use q-w = h2-h1 when h is the change in epecific enthalpy and q-w = u2-u1 and u isthe change in specific internal energy?
Here, a liquid's density is to be determined by a 1-cm diameter cylindrical hydrometer whose division marks are non visable. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the 'liquid x', and it is observed that the mark for water has risen 0.85 cm above the liquid–air interface. In this case, the height of the originalwater mark is 12.7 cm. As such, how would I determine the density of the liquid?
For a gas, which of the following does not vary with temperature? - the gas soecific weight - the gas dynamic viscosity - the gas specific volume - the gas constant R - the gas density
Water pressurized with a gas in a cylindrical tankare available. It is measured as l1 = 60 cm, l2 = 40 cm and l3 = 30 cm.Atmospheric pressure: Patm = 100 kPa ; Relative densities are: Dsu = 1, Poil = 0.85 and Pluc = 13.6. What is the difference between the pressure of the gas in the tank and the pressure at point A? a) 47.09 kPa B) -26.23 kPa NS) -6.20 kPa D) -52.81 kPa TO) 73.77 kPa 22
Steam undergoes constant volume process: T1=150 Degrees celcius, X=90%, until P2 =0.30 MPa. Determine, Q, Change in h, T2.
An air bubble rises from the bottom of a well where the temperature is 25oC, to the surfacewhere the temperature is 27oC. If the depth of the well is 5m and the atmospheric pressure is101.325kPa, determine the following:a. Initial pressure inside the air bubble (P1). b. Volume of air bubble at state 1. c. Volume of air bubble at state 2. d. Percent increase in volume of the bubble.
The system in Fig. is open to 1 atm on the rightside. ( a ) If L = 120 cm, what is the air pressure in containerA ? ( b ) Conversely, if p A = 135 kPa, what is thelength L ?
A hollow cylinder 80 cm long in diameter, one end closed, is immersed vertically with its closed end being held 7.50 m below the water surface. The cylinder is at first full of water, but compressed air is admitted from beneath in the immersed position until it has displaced two thirds of water. Patm-101.5 kPa. Find the total absolute pressure of air in the cylinder kPa. 7.5 m 0.8 m 0.6 0.3 Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: kPa abs Decimal Places required in the final answer: 3
A U-tube mercury manometer is used to measure the pressure at a pointon the wing of a wind-tunnel model. One side of the manometer isconnected to the model, and the other side is open to the atmosphere.Atmospheric pressure and the density of liquid mercury are1.01 × 105 N/m2 and 1.36 × 104 kg/m3, respectively. When thedisplacement of the two columns of mercury is 20 cm, with the highcolumn on the model side, what is the pressure on the wing?
A closed container contains 1.5m high of water, 2.5m high of oil (SG= 0.8), an unknown liquid (SG= 1.25) whose height is 1.6m, and the pressure at the top of the mixture is 17 KPa. Determine the pressure head at the bottom of the container in millimeters of mercury (SG= 13.6)