PART A: Standardization of a Sodium Hydroxide Solution Mass of KHP = 0.2 g %3D Molar mass of KHP = 204.44 g/mol %3D V; NaOH = 30 ml Vf NaOH = 50 ml Moles of KHP [ Select] Volume of NaOH (ml) [ Select] Concentration of NaOH [ Select] Question 2 12 pts PART B: Molar Concentration of an monoprotic Acid Solution Volume of acid 30 ml Concentration of NaOH = 0.1 M V NaOH = 20 ml V NaOH = 30ml > >

PART A: Standardization of a Sodium Hydroxide Solution Mass of KHP = 0.2 g %3D Molar mass of KHP = 204.44 g/mol %3D V; NaOH = 30 ml Vf NaOH = 50 ml Moles of KHP [ Select] Volume of NaOH (ml) [ Select] Concentration of NaOH [ Select] Question 2 12 pts PART B: Molar Concentration of an monoprotic Acid Solution Volume of acid 30 ml Concentration of NaOH = 0.1 M V NaOH = 20 ml V NaOH = 30ml > >

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 80AP

See similar textbooks

Similar questions

A batch of 500 ?? of ??? dissolves in water to form a saturated solution at 350 ? (77 °?) where the solubility is 30% by weight of ??? in water. The solution cools at 293 ? (20 °?) at which the solubility is 25.4% by weight. Determine the number of crystals obtained if 3.5% of the original water evaporates on cooling. Also, determine the capacity of the container in which this solution is cooled if it is 1.20 times the volume of the solution. The density of the solution is ???? ??/??
A 100-liter empty jar was spiked with 20 mg of TCE (C2HCl3) under room temperature condition. The jar was then closed tightly. What is the concentration (in atm.) of TCE in the air at 25 C? (TCE: MW: 131.4 g/mol; TCE solubility in water (Cs) = 1100 mg/L; Pv (pure liquid at 25oC) = 10^-1.01 atm. KH = 10^1.03 L atm mol-1; KOW = 102.42). if the jar was half filled with water and half filled with air, what were the concentrations of TCE in both air and water at 25C?
A solid sample contains unknown amounts of potassium and magnesium chloride and moisture. 1.193 g of the sample is dissolved in water and the solution is diluted to 250.00 mL. 25.0 mL of the sample is allowed to pass through an H + -saturated cation exchanger, the eluate consuming 22.03 mL of a 0.100 M NaOH solution. The moisture content of the sample was determined to be 5.22%. Calculate the % by weight of potassium and magnesium chloride in the sample.
A spent 1.0 percent caustic soda solution (ρNaOH = 8.42 lb/gal) with a volumetric flow rate of 3.0gpm is to be neutralized using either sulfuric acid or hydrochloric acid. First, determine the massflow rate (lb/day) of NaOH in the spent caustic soda solution, and then use that value todetermine the stoichiometric amounts (lb/day) of:1. H2SO4 required for neutralizing the OH− ions contributed by the spent caustic soda.[Hints: (1) write the balanced chemical equation for the acid-base reaction betweenNaOH and H2SO4, and use it to establish the stoichiometric weight ratio H2SO4 : NaOH.]2. HCl required for neutralizing the OH− ions contributed by the spent caustic soda. [Hints:(1) write the balanced chemical equation for the acid-base reaction between NaOH andHCl and use it to establish the stoichiometric weight ratio HCl : NaOH.]
Solution and explanation for Percentage Yield and Theoritical Yield for this data (Synthesis of Aspirin) Salicylic acid - 1.950 g Labeled watch glass - 50.664 g Labeled watch glass & piece of filter paper together - 50.872 g filter paper only - 0.208 g Where the data is from: https://youtu.be/tLXljLxRZ0U Room temperature - filter paper, watch glass and aspirin - 53.088 g
Answers should be in 4th decimal places An automobile antifreeze mixture is made by mixing equal volumes of ethylene glycol (SG=1.114; MW = 62.07 g/mole) and water at 20oC. The density of the mixture is 1.070 g/mL. Express the concentration of ethylene glycol asa) Volume percentb) Mass percentc) Molarityd) Molalitye) Mole fraction
An aqueous waste stream that has a maximum concentrationof 0.50 M H₂SO₄ (d=1.030 g/mL at 25C) will be neutralized by controlled addition of 40% caustic soda (NaOH; d=1.430 g/L) before it goes to the process sewer and then to the chemical plant waste treatment facility. However, a safety re-view finds that the waste stream could meet a small stream of animmiscible organic compound, which could form a flammable vapor in air at 40.°C. The maximum temperature of the causticsoda and the waste stream is 31°C. Could the temperature in-crease due to the heat of neutralization cause the vapor to ex-plode? Assume the specific heat capacity of each solution is 4.184 J/gK.
A salt solution (30% Na2CO3) weighing 1ton iscooled to 20C where the salt crystallizes asdecahydrate. What will be the crystal yield ifthe solubility is 21.5 kg anhydrous Na2CO3/100kg water? (assume that 3% of the totalsolution is lost by evaporation)
Gypsum (CaSO4) is a common percipitant in water desalination. CaSO4 <=> Ca2+ + SO42- where Ksp=10-4.6. Assuming that: [Ca2+]=2x10-2 M; [SO42-]=2x10-3M: a) Find Qsp or IAP for the given water b) Find the solubility index (SI) and determine whether CaSO4 is under, super, or at saturation in water. Feel free to make any assumptions you wish, as long as they're stated.
A powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr.What is the %purity of the sample to the nearest whole number?
what is the correct volume of 2.5M PhMgBr in THF is needed to completely react with 1.5ml of methyl benzoate?you do not need to consider and excess and should calculate (and choose) the minimum amount as required by the reaction stoichiometry Enter your answer to one decimal place with the proper unit of measurement.
A sample may contain any combination of sodium hydroxide, sodium carbonate and sodium bicarbonate with inert matter. A 3.00g sample requires 57.57ml of 0.5N hydrochloric acid to reach phenolphthalein endpoint and a total of 105.4ml of acid was used until the methyl orange endpoint was reached. What is the percentage inerts in the mixture? What is the percentage sodium bicarbonate in the mixture? What is the percentage sodium hydroxide in the mixture? What is the percentage sodium carbonate in the mixture?