At a particular spot on a soap bubble (n = 1.33), you see yellow light at 575 nm. İf that is from the second longest (m = 2) possible wavelength, how thick is the bubble at that point IN NANOMETERS? (Hint: If you leave the wavelength in nm, the answer will be in nm. No conversion necessary.) (Unit = nm)

At a particular spot on a soap bubble (n = 1.33), you see yellow light at 575 nm. İf that is from the second longest (m = 2) possible wavelength, how thick is the bubble at that point IN NANOMETERS? (Hint: If you leave the wavelength in nm, the answer will be in nm. No conversion necessary.) (Unit = nm)

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 86AP: How far apart must two objects be on the moon to be distinguishable by eye if only the diffraction...

See similar textbooks

Similar questions

For an aperture of width 1mm and using light of wavelength of 633 nm, estimate the distance from the aperture at which the Faunhofer approximation would be appropriate. a. Under the Fraunhofer condition, what would be the angle of the first minimum? b. If the screen is 1m away, how far from the central maximum would the first minimum be located?
Solve the following, if the radio wave transmitted at an angle of incidence 68 degrees, with a wavelength of 6mm.I. Find the critical density II. Find Maximum usable frequency if Nmax = 2xN Critical
Two radio antennas separated by d = 275 m simultaneously broadcast identical signals at the same wavelength. A car travels due north along a straight line at position x = 548 m from the center point between the antennas, and its radio receives the signals. If the car is at the position of the 3rd maximum after that at point O when it has traveled a distance y = 403 m northward, what is the wavelength of the signals? Note: Do not use the small-angle approximation in this problem. To continue enter the result in m. Round your answer to 0 decimal places
For sodium light of wavelength 5893Å, calculate thickness of quarter wave plate. Given ne = 1.553 and no = 1.544.
What minimum path length is needed to introduce a phase shift of 205° in light of wavelength 566 nm? (Give your answer in nm.) What phase shift will that path difference you calculated in part (a) introduce in light of wavelength 799 nm? (Give you answer in degree.)
in a single slit, why does the central maximum is the brightesr and has the highest intensity?
A crystal sample of bacteriorhodopsin, a light-sensitive protein found in halobacteria that responds to light energy, has crystal planes separated by 0.20 nm. If a beam of 12keV x rays illuminates a sample, what angles will give diffraction maxima of the first, second and third order? Express your answers in degrees separated by commas in ascending order.
When x - ray incident to the layer of Aluminum , and the transmitted intensity was 10 % from the original incident ray when the thickness of Aluminum was 2 cm , if the density of Aluminum is (2.7gm/cm .^3) , then the Half: Value Layer equal to 1.626 cm. O 0.601 cm . O 3.108 cm. O Please I need an answer within 30 minutes
What is the full width of the central bright spot when 6 nm goes through a slit that is 8 micrometers wide and to a screen 457 m away? Use the small angle approximation.
Choose the correct answer from the given bullet points: Which of the following parts is the primary determinant of an instrument's wavelength range or limit? Monochromator Source Beam splitter detector answer: 2. Which of the following parts is responsible for the ability of an instrument to measure transmitted light from the reference and sample cells simultaneously? Source Beam splitter diffraction grating Prism answer: 3. Which of the following situations will not lead to a negative absorbance reading? light pass through the opaque side of the blank cuvette and transparent side of the sample cuvette light passes through the transparent side of the blank cuvette and opaque side of the sample cuvette the instrument was not properly calibrated with the blank solution the sample and blank solutions were swapped answer: 4. Path length refers to the Length of the sample holder Distance that the light traveled to pass through the sample Distance between the light source and the…
Light of wavelength 633 nm is incident on a pair of identical stits of width 0.2mm and center-to-center separation of 2mm. The diffraction pattern is observed on a screen at distance 5m. Calculate the spacing between zeros of intensity (in mm to 2 d.p.); and which is the lowest-numbered peak (counting up from zero at the centre) which has less than half the intensity of the zeroth peak: (Hint: sinc(?/2)=2/?(pi/2)=2/pi). The spacing is: and the number of the peak with less than half central intensity is:
If X-ray diffraction peaks corresponding to the firstthree orders (m= 1,2 and 3) are measured, can both theX-ray wavelength λ and lattice spacing d be determined?Prove your answer