Potassium chloride liquid is available in vials of 20 mEg/15mL concentration. The patient needs 50 mEg two times a day. Compute for the amount of potassium chloride needed per dose in milliliters. Amount of Potassium chloride in milliliters for every dose = How many vial/s is/are needed for the patient in a day? = "Note: Give your final answer in 2 decinal pla ces. Iodicate the unit.

Potassium chloride liquid is available in vials of 20 mEg/15mL concentration. The patient needs 50 mEg two times a day. Compute for the amount of potassium chloride needed per dose in milliliters. Amount of Potassium chloride in milliliters for every dose = How many vial/s is/are needed for the patient in a day? = "Note: Give your final answer in 2 decinal pla ces. Iodicate the unit.

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter2: Analyzing Data

Section: Chapter Questions

Problem 114A

See similar textbooks

Similar questions

A patient is to be given 4.6 mg of a heart medication in exactly 260 mL of D5W (dextrose solution) to be infused at a rate of 20585 micrograms per hour. Calculate the flow rate in mililiters per hour
The physician of patient AJ (50 kg, M) admitted in your hospital ordered that the patient receives 0.25 mL of drug A per kg of body weight. This must be mixed with 250 mL of D5W. The IV admixture must be administered over a six-hour period only using a drip set capable of delivering 15 drops per mL. Your pharmacy has stocks of 2.0% w/v of drug A solution (density of drug A: 1.2 g/mL). Answer all questions below. 1. How many mL of drug A must the patient receive to obtain the needed dose? 12.5 mL B. 25.0 mL C. 50.0 mL D. 75 mL 2. From the pharmacy’s stocks of drug A solution, how many mL must be added to 250 mL D5W to prepare the IV admixture? 250 mL B. 500 mL C. 750 mL D. 1000 mL 3. What is the total volume of the admixture that will be administered to the patient? 262.50 mL B. 500 mL C. 750 mL D. 1000 mL 4. Given the capability of the hospital’s IV set, how many drops of the admixture should be administered to the patient? 3,936.5 drops B. 7,500 drops C. 11,250 drops D.…
If an IV is mixed so that each 150mL contains 550mg of the drug lidocaine how many minutes will it take for 780mg of lidocaine to be administered if the rate is set at 9.0 mL/min
A post surgical parents weight 165.0lb and is prescribed a painkiller that has an administration label reading Given 3.00 mg/kg of body weight every 4-6h. How many milligrams of painkiller should presented every 4-6 h?
Given that an IV is mixed so that each 150. mL of the solution contains 500. mg of the drug lidocaine and the rate of infusion is set at 300. mL/hr. How many minutes will it take for 0.75 g of lidocaine to be administered?
Infusion Rates for Dextrose (D5W). A 5% dextrose solution (mg per 100 mL of solution ) is given intravenously. Suppose a total of 1.5 L of the solution is given over a 12-hour period. a. What is the flow rate in units mL/hr? In units of mg (of dextrose)/hr b. If each milliliter of the solution is equivalent to 15 drops (this drop factor is expressed as 15 gtt/mL, where the abbreviation gtt comes from the Latin guttta, for drop), what is the flow rate in units of gtt/hr? c. During the 12-hour period, how much dextrose is delivered? I do not have the answers for this. Answer this as best as you can. This is for Math 140 Statistic and Probability. Please watch grammar, do not leave words out, use short answers. Thank you.
(a) To identify a liquid substance, a student determined itsdensity. Using a graduated cylinder, she measured out a 45-mLsample of the substance. She then measured the mass of thesample, finding that it weighed 38.5 g. She knew that the substancehad to be either isopropyl alcohol (density 0.785 g/mL)or toluene (density 0.866 g/mL). What are the calculated densityand the probable identity of the substance? (b) An experimentrequires 45.0 g of ethylene glycol, a liquid whose densityis 1.114 g/mL. Rather than weigh the sample on a balance, achemist chooses to dispense the liquid using a graduated cylinder.What volume of the liquid should he use? (c) Is a graduatedcylinder such as that shown in Figure 1.21 likely to afford theaccuracy of measurement needed? (d) A cubic piece of metalmeasures 5.00 cm on each edge. If the metal is nickel, whosedensity is 8.90 g/cm3, what is the mass of the cube?
The usual dose of digoxin for rapid digitalization is a total of 1.0 mg, divide into two or more portions at intervals of 6 to 8 hours. How many milliliters of digoxin elixir containing 50mcg/mL would provide this dose?
If you want to deliver 300. mL of a 5.0% glucose solution over a 2.0 hour time period using an IV drip that delivers 18 gtt per milliliter, what flow rate in drops (gtt) per minute is needed for the IV? Select the correct menu items to show how to set up the calculation using dimensional analysis. After setting up the problem, select the final answer from the menu. (Hint: To end with a volume unit over a time unit (gtt/min), you need to start your calculation with a volume unit over a time unit.)
You are asked to prepare an injection containing 1 vial of vaccine. The vial contains 12.5 mg of Tice BCG, and is then diluted to 50 mL with sterile physiological saline. What is the final concentration in weight per volume?units - % w/v
A certain antihistamine is often prescribed for allergies. Atipical dose for 100 pound person is 22mg every six hours. Complete parts a) and b) below. a) following this dosage, how many 12.3 mg chewable tablets would be taken in a week? b) this antihistamine also comes in a liquorfirm with a concentration of 12.3 mg/5ml. Following the prescribed dosage, how much liquid antihistamine should a 100 pound person take in a week. a) A 100 pound person could tske ___ tablets in a week. b) a 100 pound person could take ___ ml in a week.
An internist asks you to give 5 mcg per kg of body weight of a medication to a 264 lb patient. The medication is available in solution form as 0.3 mg per 2 cc. How many cc should you give?