Problem: Pressure in the tank is measured by a multitube manometer. Using the manometer indications, calculate the pressure force acting in the top cover of the tank. Hz=180 mm, hị=120 mm, h=300 mm, D=400 mm.

Problem: Pressure in the tank is measured by a multitube manometer. Using the manometer indications, calculate the pressure force acting in the top cover of the tank. Hz=180 mm, hị=120 mm, h=300 mm, D=400 mm.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Related questions

Q: A steel cylinder at sea level contains air at a high pressure. Attached to the tank are two gauges,…

A: Let the pressure inside the steel cylinder is P0. At the sea level the pressure reading will be, The…

Q: Find the distance h seen on the Mercury U manometer for the values given in the above water tank.

A: Consider the level a-a in the mercury column as shown below. Given that pressure of air as shown in…

Q: Problem 3: For the tank shown in the figure below, determine the reading of the bottom pressure gage…

A: Given Specific gravity, sg = 0.95 Therefore, density = 0.95 x 1000 kg/m3…

Q: Figure 2 shows an invertedU-tube manometer used to measure the difference in pressure between water…

A: As per given question we have Determine the pressure difference between A and B in a u-tube…

Q: Q8:Find the value of the hydrostatic force and the direction and the position of (c.p.) on the…

Q: Assuming the specific weight of the air to be 12N/cu.m, what is the approximate height of Mt.…

Q: 6. A closed cylindrical tank that is 8 ft in diameter and 24 ft long is completely filled with…

Q: g the experiment on the mination of surface tension s by the capillary rise meth n among the…

A: Ans: Methanol

Q: Figure Q2 shows two tanks which contain the solvent used for plastic manufacturing. Tank A contains…

Q: Capillary rise in the glass tube used for measuring water level is not tổ exceed 0.5 mm. Determine…

A: To find: The minimum size of glass tube. Given: The water level not exceed to 0.5 mm. The surface…

Q: The gauge pressure of the air in the tank shown in below figure is 85 kPa. Determine the…

Q: 4. If atmospheric pressure is 97.75kPa and the gage attached to the tank reads 188 mmHg vacuum, find…

A: (4.)

Q: The total weight of the plunger and load is 30 kN, the plunger diameter is D=200 mm. Neglecting…

Q: The bottle of champagne (SG = 0.96) in Fig. isunder pressure, as shown by the mercury-manometer…

A: Step 1 Given data

Q: Figure Q2 shows two tanks which contain the solvent used for plastic manufacturing. Tank A contains…

Q: The pressure at the base of the mountain is 750mm of Hg and at its top is 600 mm of Hg. If the…

A: Given data: The height of Hg column at the base of the mountain is hb = 750 mm. The height of Hg…

Q: A U-tube differential manometer is connected to two pipes at A and B. Pipe A Contains oil of density…

Q: Derive the formula used in determining experimental hydrostatic force using the center of pressure…

A: In this experiment, when the quadrant is immersed by adding water to the tank, the hydrostatic force…

Q: Find the capillary raise of the water in the tube of diameter 2mm, which is immersed vertically in…

Q: ?What is the total force lifting the tank

Q: A pipe contains oil (density = 850 kg/m 3) at a gauge pressure of 200 kN/m 2 . Calculate the…

Q: The initial reading differential manometer shown is exposed to the atmosphere at end B. a) Calculate…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

A: Consider the U-tube manometer according to the given queston as shown below, The manometer is…

Q: The system consists of a pipe with a diameter of 0.05m and a length of 4 m, and a hemisphere (radius…

Q: Q- Two water tanks are connected to each other through a mercury manometer with inclined tube as…

A: Given data Pressure difference between two tanks (PA - PB )= 20 KPa

Q: Problem 2 (30 points): The manometer shown is closed to the atmosphere. The pressure at point A is…

A: Given: The pressure at point A is PA=9000 Pa. The pressure at point B is PB=8000 Pa. The dimension…

Q: Q-3 Three different liquids with properties as indicated fill the tank and manometer tubes as shown…

Q: The standpipe is connected at C to the field storage tank with oil, and the system is open to the…

A: Hydrostatic law gives the relation of pressure with depth as: P=ρgh where, ρ is the density of…

Q: Vessel A, at elevation 2.438 m, contains water under 103.4 kPa pressure. Vessel B, at elevation…

A: The manometer is used to measure the fluid pressure. It is most accurate while measuring low fluid…

Q: A- For the figure (1-A) determine the pressure difference between pipes A and B. take z;=0.45 m,…

Q: Q 9: A U-tube differential manometer is connected to two pipes at A and B. Pipe A Contains oil of…

Q: A beaker is filled with a liquid up to a height h. If A and B are two points, one on the free…

Q: The field storage tank is filled with oil. The standpipe is connected to the tank at C and open to…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: 2. Given the two compartment vessel as shown in the figure. Gage A reads 85 psig, gage B inside the…

A: GIVEN :- Pressure in gauge- A : PA=85 psig Pressure in gauge-B :PB=25 psig barometer reading :…

Q: . Problem:Pressure in the tank is measured by a multitube manometer. air Using the manometer…

Q: Compute the barometric pressure at an altitude of 1000 m, if the pressure at sea level is 101.4 kPa.…

A: Given: The value of altitude , h = 1000 m The pressure at sea level , Ps = 101.4 kPa The value of…

Q: altitude

A: Altitude= 29581.53497

Q: If the atmospheric pressure is 760 mmHg, what is the gas pressure in the manometer: (a) If the…

Q: In the set-up shown, a rectangular gate, ABCD, is used to store layers of oil and water. The weight…

A: Givenweight of the gat w=4kNforce exerted by the stopper on the gate F=30kN

Q: The pressure outside the droplet of water of diameter 0.04 mm is 103.2 kPa (atmospheric pressure).…

Q: The U pipe in the figure has a diameter of 1 cm and stands in balance as shown in the figure. When…

A: Given: Diameter of the tube D=1cm The volume of water added in the right tube V=20cm3 Relative…

Q: In the figure, fluids A and B have specific gravities of 0.75 and 1.00, respectively. If mercury is…

A: Given that, Specific gravity of fluid A, sA=0.75Specific gravity of fluid B, sB=1Specific gravity of…

Q: What is the absolute pressure inside a water drop having radius 1mm and surface tension as 0.1 N/m?…

Q: The value of the pressure gauge A in the B tank is 1.4 bar. The U-type manometer connected to tank B…

Q: Problem 3.- Blaise Pascal doubled Torricelli's barometer using Red wine, with a density of 984kg /…

A: Given data: The density of the wine is ρwine=984 kgm3.

Q: SITUATION The U-tube is filled with water and A is open while B is closed. If the axis of rotation…

A: From the distance x it can be observed that the positive pressure is created because of the rotation…

Q: Assuming specific weight of air to be constant at 12 N/m3, what is the approximate height of Mount…

A: Given Data Specific weight= 12 N/m3 Pb1=654 mm Pb2= 480 mm

Q: The standpipe is connected at C to the field storage tank with oil, and the system is open to the…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Concept explainers

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.

Question

Воздух
. Problem: Pressure in the tank is measured by a multitube manometer.
Using the manometer indications, calculate the pressure force
acting in the top cover of the tank. H=180 mm, hi=120 mm,
h=300 mm, D=400 mm.
+ P.
D
Вода
Ртуть

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Derive the formula used in determining experimental hydrostatic force using the center of pressure apparatus.
The gage pressure of the air in the tank shown in Fig. is measured to be 80 kPa. Determine the differential height h of the mercury column.
ASAP pls dont round off initial values, round off final ans only ty. Calculate the absolute pressure in kPa at a depth of 8 m below the oil's free surface, with a barometric reading of 752 mm Hg.
The pressure difference between point A and point B is to be measured using an inclined mercury (SG 13.6) manometer. The manometer is inclined at 15 degrees. If the reading along the manometer is 4.8 cm, find the pressure drop between A and B. Include a diagram in your solution. Assume the other liquid in the manometer is air, and operating temperature is 25 degrees Celsius.
assuming specific weight of air to be constant at 12 N/m2 . What is the approximate height of Mt. Kanlaon if a mercury barometer at the base of the mountain reads 654mm Hg and at the same time another barometer at the top of the mountain reads 435 mm Hg?
The bottle of champagne (SG = 0.96) in Fig. isunder pressure, as shown by the mercury-manometer reading.Compute the net force on the 2-in-radius hemispherical endcap at the bottom of the bottle.
A manometer inclined at 10° is being used to determine the pressure drop bet points A and B. The fluid in the manometer has 1.6 sg and the other fluid is air, determine the pressure drp if the manometer reading is 6.10cm Assume a pressure of 25C.
A U-tube manometer is connected to a closed tank as shown. The air pressure in the tank is 0.25 psi and the liquid in the tank is oil (SG=0.6) . The pressure at point A is 1 psi. a. Determine the depth z (in feet) of oil in the tank. b. Determine the differential reading, h (in feet), on the manometer.
A cylindrical tank of 1.5 m diameter and height 0,75 m has a hemispherical dome. The tank contains oil of relative density 0.84. The dame is joined to cylinder position by four equally spaced bolts. If pressure gauge at point M, 0.3 m above base of tank read 50 kPa. Determine force each bolt.
Q8: A gasoline line is connected to a pressure gage through a double-U manometer, as shown in Fig. If the reading of the pressure gage is 370 kPa, determine the gage pressure of the gasoline line.
In order to measure the pressure difference between two points in a pipeline carrying water, an inverted U tube is connected to the points, and air under atmospheric pressure is entrapped in the upper portion of the U-tube. If the manometer deflection is 0.8 m and the downstream tapping is 0.5 m below the upstream point, find the pressure difference between the two points
The system consists of a pipe with a diameter of 0.05m and a length of 4 m, and a hemisphere (radius 2 m) opened to the atmosphere, and the weight of the system is 50 kN. The lower part of the system is filled with water and the upper part with oil. The system is fixed to the base with 6 bolts. Calculate the force to be covered by each bolt required to hold the system (Note: oil 6867 N/m3, water = 9810 N/m3). (Please explain the answer)..........