Pulley 10,000 lb Water 15 ft h 60°

Q: A) A thin 4-ft-wide, right-angle gate with negligible mass is free to pivot about a frictionless…

A:

Q: Gate AB in Fig. (4) is 1.2 m long and 0.8 m into the paper. Neglecting atmospheric-pressure effects,…

A: Given dataLendth of the gate L AB = 1.2mTo determine the force on the gate and it's center of…

Q: 1 Calculate the resultant of hydrostatic force on the gate. What vertical force P is necessary to…

A: Hydrostatic pressure is only function of depth, not an area but hydrostatic force is a function of…

Q: The tank of water in Fig.  is 12 cm wide into the paper.If the tank is accelerated to the right in…

A: Given data *The length of the water tank, L = 24 cm *The height of the water tank, d = 9 cm *The…

Q: A rectangular car is 3m long by 1.5m wide and 1.5m deep. If friction is neglected, and the car rolls…

A:

Q: Problem 3 A gate is 1.5m in width and hinged at point A. Another point on the gate, B, is resting…

A:

Q: watersurface. 1-3 m hinged gate P 3 m

A:

Q: Q:-A quarter circle gate AB of 1.5 m radius and 3 m wide, hinge at B, find the vertical force F…

A: Solution: To find horizontal force Fx h¯=1+1.52=1.75m Then, Fx=ρgAh¯Where A=Projected area…

Q: A rectangular gate which is inclined 90-degrees with respect to the horizontal and has a 3.5 m width…

A:

Q: A) Gate AB in Fig. (4) is 6 m wide and weights 2 tons. It is hinged at B and rests against a smooth…

A:

Q: As water rises up to a height of 150 cm above the hinge of the rectangular gate, the gate will open…

A:

Q: al cm and a thickness of 0.1 mm floats on a fluidic surface and bends the surface 3. A thin metal…

A:

Q: 1. Gate AB in Fig. is 6 m wide into the paper, hinged at A, and restrained by a stop at B. The water…

A:

Q: The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to the floor…

A:

Q: Watersurface. -3 m hinged. gate P 3 m

A: Given data:-specific weight of water, ω=9810N/m3weight of gate, W=800NNow,length of the gate,…

Q: A block of steel ( s.g. = 7.85 ) will "float" at a mercury-water interface as shown in the figure.…

A:

Q: Calculate the force F required to hold the gate in a closed position (Fig. 2.53), if R = 0.6 m.…

A:

Q: 1. Gate AB in Fig. below is 15 ft long and 8 ft wide into the paper and is hinged at B with a stop…

A: Length of the gate, L=15 ftWidth of the gate, w=8 ftThickness of the gate, t=1 in =112ftWater…

Q: Gate AB in Figure is 4 m long and 2.5 m wide into the paper and is hinged at B with a stop at A. The…

A:

Q: A sliding gate of height 1.4m and width 2.8m lies in vertical plane that weighs 25kN. When the gate…

A:

Q: If the wall AB shown is 48 meter long calculate the total force (in the uhlt of KN) on the wall due…

A:

Q: The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as…

A: Given data: The angle of each side is θ = 45o. The width of the each side is x = 0.75 m. The length…

Q: Q5: The rectangular gate AB has a length of L and width 2L and weight W, hinged at B, find P to…

A:

Q: A vertical sliding gate is being submerged in a 10 meter water. The gate is 5m wide and 9 m high and…

A:

Q: 1 Calculate the resultant of hydrostatic force on the gate. What vertical force P is necessary to…

A: Given,  Weight of the gat e, W =800 N Width of the gate, b =1.6 m

Q: Example: Figure-shows-a-rectangular sluice gate AB, 3-m wide and-4.5 m long hinged at A. It is kept…

A: Given:-AB=3mL=4.5mWeight=525 kNTo find:-Height of water h

Q: Gate AB in the Figure is 6 ft wide into the paper, hinged at A, and restrained by a stop at B.…

A: Given, Gate AB is 6ft wide into the paper (w=6ft) Gate AB is hinged at A Gate AB is restrained by a…

Q: Consider the slanted plate AB of length L in Fig. .( a ) Is the hydrostatic force F on the plate…

A: No, the hydrostatic pressure here is not equal to the missing water above the plate. Understand the…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 1.1 meter has water on…

A:

Q: 3. For the gate shown, α = 45°, Y₁ = 1 m, and y₂ = 4 m. Will the gate fall or stay in position under…

A: Please find the solution below

Q: In Fig., gate AB is 5 ft wide into the paper, and stopB will break if the water force on it equals…

A: Given Data Brake force, B=9200 lb Width of gate AB, b= 5ft length of gate AB, l=4 ft Area of the…

Q: An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top, what…

A: Diameter = 4m water is 8m deep find the normal force F

Q: 1 Calculate the resultant of hydrostatic force on the gate. What vertical force P is necessary to…

A: To find : The resultant of hydrostatic force on the gate and value of vertical force P . Given data…

Q: Q1/ The tank of water in Fig. 1 is (12 cm) wide into the paper. If the tank is accelerated to the…

A: Given that: acceleration = 6 m/s2 Width of the tank = 12 cm It is required to determine: (a) Depth…

Q: Problem 3 Wall A gate is 1.5m in width and hinged at point A. Another point on the gate, B, is…

A:

Q: B3. A rectangular plate of width 45 mm, depth =60 mm is vertically placed in water in such a way…

A:

Q: An open cylinder tank, D= 1.0m, h=1.5m, contain water at depth 1.0m. If this tank rotate about its…

A: Given data:

Q: 3. A semicircular 40-ft-diameter tunnel is to be built under a 150-ft-deep, 800- ft-long lake, as…

A:

Q: Q2: Gata AB Fig. below, 6m wide and weight 5 kN, it is hinged at B, determine the water level h,…

A:

Q: - The mass less, 1.2 m wide gate shown in fig. (2.7) pivots about the frictionless hinge (0). It is…

A: Given data: Width of the gate, b = 1.2 m. The magnitude of the counterweight, w= 8900 N. The…

Q: The cover in the figure is hinged at the center O and has a fixed width w = 5 m. The equation of the…

A: Given data, Width of the cover, w = 5 m Equation of the surface, x=y23 Depth, D = 4 m To determine,…

Q: Problem 3 A gate is 1.5m in width and hinged at point A. Another point on the gate. B. is resting…

A: GIVEN :- Width of the gate : b=1.5 m specific gravity of sea water : sg=1.03    SOLUTION :-…

Q: An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top., what…

A:

Q: The parabolic shaped gate with a width of 6 m shown below is hinged at point B. Compute for the…

A: The pressure exerted by the fluid at a point which is located at a depth of h from the surface is…

Q: The rectangular gate CD is 1.8 m wide and 2 m long as shown in the figure below. Water 2.0 m 2.0 m…

A:

Q: Proof that a solid aluminum block of 4 mm x 3 mm x 3 mm, such as shown in Figure QI (a), can float…

A: The surface tension of water at 20 degrees Celsius is 0.072 N/m.

Q: The hemispherical dome in Fig.  weighs 30 kN and isfi lled with water and attached to the fl oor by…

A: Assuming no leakage, the hydrostatic force required equals the weight of missing water,…

Q: What vertical force is needed to keep the 2- m wide (into the paper) cylindrical gate closed as…

A: Given data as per question Radius of cylinder gate =3 ft =0.9144 m Length of cylinder =2 m the…

Q: 3. For the gate shown, α = 45°, Y₁ = 1 m, and y₂ = 4 m. Will the gate fall or stay in position under…

A: To check: whether the gate will stay or fall. Given: The values are α=45°,y1=1 m,y2=4 m and b=1 m.…