Answered: Q1: A conductive wire has a resistivity…

Q1: A conductive wire has a resistivity of (0.649x10-8(2.m)) at room temperature are (5.8x10») conduction electron/ms.Calculate the mobility, resistivity and relaxation time of electrons.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 20RQ: What is a proton? Where does it normally exist in an atom, and what is its charge?

See similar textbooks

Related questions

Q: An ideal rectifying contact is formed by depositing gold (m = 5.10 cV) on an Np - 10-/cm doped…

Q: A slice of intrinsic silicon bar is 3 mm long and has a rectangular cross-section 50 µm x 10 µm. At…

A: Given values are - L=3mm=3×10-3mA=50μm×10μmI=2μAρ=2.30×105ohm-cm=2.30×103ohm-m

Q: (a) Ideally, a cylindrical wire with radius, p = 2.3 cm and length h = 155 cm (along az) has 50z0…

A: Given values are - ρ=2.3cm=0.023mh=155cm=1.55mρv=-50εoρCm3t=2×10-12secIm=50A

Q: Question 4-) The linear electron-concentration profile shown in the figure below has been…

A: The given electron concentration profile is shown below: It is given that: no=1017 /cm3W=4…

Q: The Nyquist plot for simplified Randles cell assumes that a 1 cm? electrode experiences 1mm uniform…

A: We can say that by the Nyquist plot we can see from the figure from the real axis and the imaginary…

Q: Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is…

Q: -3 Germanium doped with 1024 m Al atoms is a semi-conductor at room temperature and each Al atom…

A: The Al-SI bond create a holes and this hole act as a positive charge carrier. So the material…

Q: What type of a material would have a very small band gap or band overlap and need a very small…

A: We will list the bandgap for all the given options . Smaller the band gap lower will be the energy…

Q: Q6: Determine the probability f (E) for electrons occupied in conduction band at 300°K, considering…

Q: Compare and contrast the temperature dependence of the electrical conductivities of a intrinsic…

A: we need to compare the temperature dependence of the electrical conductivity of intrinsic…

Q: A typical Cu wire might have 2 X 1021 free electrons in 1 cm of its length. Suppose that the drift…

A: Given that the wire has 2 x 1021 free electrons length = 1 cm drift velocity is 0.05 cm/s

Q: A silicon sample is supporting an electric ﬁeld of −1500 V/cm, and the mobilities of electrons and…

A: Electric field, E = -1500V/cm Mobility of electrons, µe = 1000 cm2/V.s Mobility of holes, µp = 400…

Q: 4. Define the continuity equation, then discuss the relaxation time in dielectric and conducting…

A: Continuity Equation: Continuity equation states that if charge is moving out of a differential…

Q: Q9: Find the length of copper wire of diameter (1mm) which will have a resistance of (IKN) and…

A: Given: For a copper wire, The diameter is d=1 mm Resistance is R=1 KΩ Conductivity is σ=5.8×107 S/m…

Q: The materials which behave like perfect insulators at low temperatures & at higher temperatures,…

A: there are mainly three types of materials they are conductors , insulators and semi conductors .…

Q: H.W5: If the ratio of mopility of electrons to mopility of holes is 3:1 and the condicutivity of…

A: Here i have derived the answer. Ni=intrinsic carrier concentration. P=Na= acceptor concentration.

Q: Why Intrinsic Semiconductor materials are the bad conductors of electricity? Elaborate the process…

A: Intrinsic semiconductors are chemically very pure and have no lattice defects. So there are no free…

Q: What semiconductor materials would be more suitable for a single junction pv device for ground or…

A: GIVEN: Graph between normalized absorbance and wavelength FIND: Based on data, suggest a…

Q: 5. A certain material has diffusion coefficients Dn = 32 cm?/s and Dp = 10 cm²/s. The free electron…

Q: Neglecting losses and fringing effects and assuming the substrate of a stripline to have a thickness…

A: In this question we will find required width of metal strip in order for stripline to have given…

Q: Q2:- A semiconductor material has electron and hole mobilities µn and µp respectively. When the…

A: The solution is given below

Q: 4. Use this information to answer Question 4-6: Below is the capacitance-voltage curve measured for…

Q: The current density in a copper wire of radius 0.750 mm is uniform. The wire's length is 5.00 m, the…

A: Given values are - r=0.75mm=0.75×10-3mL=5mV=0.2VoltElectron densityn=8.10×1028m-3 Given that wire is…

Q: What length of around copper wire of diameter 1mm will have a resistance 1K ohm if copper…

A: According to the question we have: R=1KΩ, σ=60Ω-m, d=1mm=10-3m The value of length is calculated as:…

Q: This question is about electrical conductivity: 1. How are electrical properties different for…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: conducting line on an IC chip is (2.8 mm) long, and has a rectangular cross-section (1x 4 um). A…

A: Given data: l=2.8 mmA=4 μmIl=5 mAVl=100 mVμe=500 cm2/V.sec

Q: Consider a material where the probability of a hole occupying a state in the middle of the valence…

A: In this question, We need to choose the correct options

Q: Indicate a total of 8 factors that determine the breakdown strength in liquid insulators; Explain…

A: The liquids are easily contaminated, and may contain impurities in the form of solids, other…

Q: In a n-type semiconductor, the electron concentration increases linearly along the x-axis from 10^16…

A: Given: In a n-type semiconductor, the electron concentration increases linearly along the x-axis…

Q: A) A solid specimen of dielectric, diclectric constant of 4.5, shown in the figure has an internal…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: There is a p-type semiconductor box. As the voltage at both ends of the box continued to increase,…

A: P-Type semiconductor That type semiconductor device which containing more number of holes as the…

Q: Q2] A copper wire of 3mm diameter with conductivity of 5.8x10 (2.m)', and electron mobility of…

A: Given: d=3mmσ=5.8×107?m-1μ=0.0032m2V.sE=30×10-3Vm The charge density is computed as the ratio of…

Q: b) Calculate the drift velocity of electrons in silicon at room temperature and when the magnitude…

A: In this question we will find drift velocity of electrons...

Q: Q2:- A semiconductor material has electron and hole mobilities µa and µp respectively. When the…

A: We need to find out conductivity .

Q: What is the purpose of designing bushings as capacitor bushings?

A: You have asked independent questions. We are authorized to answer one question at a time. Since you…

Q: 3-At a temperatures near room temperature, the temperature dependence of the conductivity for…

A: Calculate the value of temperature independent constant by taking natural logarithms on both sides.…

Q: The electron number density in a semiconductor varies from 1020 m-3 to 1012 m-3 linearly over a…

A: Given data, μе = 0.135 m2V-1s-1 , The temperature(T) is 300 K. The distance(x) is 4μm

Q: Q2 (i) In the context of semiconductors, (a) explain why an intrinsic semiconductor has higher…

A: Intrinsic semiconductors have very low conductivity at the room temperature. Hence, extra charge…

Q: A one cm3 sample of a hypothetical material with conductivity of 108 (Ohm-meter) 1 is formed into a…

A: The resistance of the material is calculated as shown below: σ=108…

Q: QI. In a P-type germanium, n, = 2x10" electrons/m' and the density of boron 4x102 atoms/m. The…

A: For the given data conductivity is calculated before and after adding of boron

Q: An ideal photo-diode of unit quantum efficiency, at room temperature, is illuminated with 8 mW of…

A: The total current is given by the standard diode equation,

Q: Consider plane electrodes with a solid insulator between them. Find the electric field strength at…

A: To find the breakdown voltage at that field

Q: The intrinsic resistivity of Germanium at room temperature is 0.47 Q-cm. The electron and hole…

A: Given parameters are: Intrinsic Resistivity of Germanium,ρ=0.47Ω-cm=0.47×10-2Ω-m Electron…

Q: Consider germanium Ge and GaAs material. Which material has lower intrinsic carrier concentration ni…

Concept explainers

Electric field

A physical field present around an electrically charged particle that exerts a force on all other charged particles is called an electric field. The charged particles present in the field either repel or attract. From electric charges or time-varying magnetic fields, the electric field originates. One of the manifestations of electromagnetic force which is one of the four fundamental forces present in nature are the electric fields and magnetic fields.

Question

Q1:
A conductive wire has a resistivity of (0.649x10.8(2.m)) at room temperature
are (5.8x10 ) conduction electron/ms.Calculate the mobility, resistivity and
relaxation time of electrons.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

] A copper wire of 3mm diameter with conductivity of 5.8 * 10 '(22.m)', and electron mobility of 0.0032 m² V.Sec. is subjected to an electric field of 30mVm. Find (a) the charge density of free electrons, (b) current flowing in the wire, (c) the electron draft velocity.
An AWG #10 copper wire conductor has an 80.8 mil diameter. A 50-foot length carries a current of 30 Amperes. Find the electric field intensity E within the wire, the voltage drop across the conductor, and the resistance R of the 100-foot length.
5. A long copper wire carries a current of 20A which is evenly distributed in each cross-section of the wire. If the diameter of the wire is 4 mm, and the resistance per unit length is 5 Q2/km, calculate the energy density of the magnetic and electric fields on the surface of the wire!
Conductors A conducting wire is 2 mm in radius and 100 m in length. When a dc voltage of 9 Vis applied to the wire, it results in a current of 0.3 A. Find: The E-field in the wire, The conductivity of the wire.
A copper wire 100 m long must experience avoltage drop of less than 1.5 V when a current of 2.5 A passesthrough it. Given that copper has an electrical conductivity of6.0E7 /(Ὠ-m), compute the minimum diameter of the wire.
Make a comparative chart related to electrical conduction in materials, that is, comparing metals (and other conductors) / semiconductors / superconductors / insulators. Additional, on another page, an application of each of them
A copper wire of 2mm diameter with conductivity of 5.8*10 7S/m and electron mobility of 0.00032m 2 / V-s is subjected to anelectric field of 20mV/m. Find(i) The charge density of free electrons(ii) The current density(iii) The current flowing in the wire(iv) The electron drift velocity
conducting line on an IC chip is (2.8 mm) long, and has a rectangular cross-section (1x 4 um). A current of (5 mA) produces a voltage drop of (100 mV) across the line. Determine the electron concentration given that the electron mobility is (500 cm²/V.Sec.).
a. Determine the ampacity of four heat resistant conductors up to 90 C of #10 gauge copper installed in a rigid tube at 30 C ambient temperature. b. What is the ampacity of a 500 KCMIL THHN insulated aluminum conductor at an ambient temperature of 60 C?
Graphically show the effect of changes in temperature on the resistance of conductors, semiconductors, and insulators.
The wires of our appliances are insulated with a material mixed with rubber, which has a very high resistivity. If a certain wire has a length of 2.5 m and the outer diameter is 5mm and its inner diameter is 0.5mm, what is its resistance? Note that the inner diameter is present to leave a hallow place where conducting wire ( usually copper) is present. Follow the format: Given: Required: Equation: Solution: Answer:
A coil of Nichrome wire is 23.0 m long. The wire has a diameter of 0.400 mm and is at 20.0°C. (a) If it carries a current of 0.600 A, what is the magnitude of the electric field in the wire?(b) If it carries a current of 0.600 A, what is the power delivered to it?(c) If the temperature is increased to 300°C and the potential difference across the wire remains constant, what is the power delivered? A coil of Nichrome wire is 23.0 m long. The wire has a diameter of 0.400 mm and is at 20.0°C. Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error.