Q1 A plow located on the front of a truck scoops up a liquid slush at the rate of 12 ft/s and throws it off perpendicular to its motion, 0 = traveling at a constant speed of 14 ft/s, determine the resistance to motion caused by the shoveling. The specific weight of the slush is y, 90°. If the truck is 5.5 lb/ft.

Q1 A plow located on the front of a truck scoops up a liquid slush at the rate of 12 ft/s and throws it off perpendicular to its motion, 0 = traveling at a constant speed of 14 ft/s, determine the resistance to motion caused by the shoveling. The specific weight of the slush is y, 90°. If the truck is 5.5 lb/ft.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 1.28 Mg MINI accelerates at 6 m/s² starting from rest. If the drag resistance on the MINI due to the wind is FD = 10v N, where v is the speed in m/s, determine the power supplied to the motor when t = 5 s. The motor has a running efficiency of € = 0.68.
Determine the width of a a.) apron conveyor b.) flight conveyor without skirts whose capacity is 56 tons per hour at a speed of 50 fpm handling solids with an average density of 50 pounds per cubic foot.
Escalator steps move with a constant speed of 0.6 m/s. If the steps are 125 mm high and 250 mm in length, determine the power of a motor needed to lift an average mass of 150 kg per step. There are 32 steps. if the escalator is not moving, determine the constant speed at which a man having a mass of 80 kg must walk up the steps to generate 100W of power-the same amount that is needed to power a standard light bulb.
A jogger with mass m = 55 kg uses energy at a rate of P = 802 W when she jogs on horizontal ground at a constant speed of s = 3.5 m/s. The efficiency of her “human engine” however, is e = 0.27. (In other words, the power used for locomotion is e = 0.27 times the total power.) Q) Write an expression for the rate of energy expenditure whenshe jogs at the same constant speed up a slope of 4.99 degrees. Assume whatever frictional or drag forces are the same in each case. Your answer should be in terms of the symbols given in the problem statement and g(9.80 m/s^2)
The wind has deposited sand on a platform so that the intensity of the load isapproximately w = 0.5x^3 N / m. simplify the distributed load to a resulting force and specify its magnitude and location from A.
A wind turbine has a rotor blade diameter of 10 m. If the turbine receives a maximum wind speed of 3.4 m/s, determine the maximum power available at the turbine. Assume ρ = 1.293 kg/m^3.
A large tank open to the atmosphere is filled with water to a height of 5 m from the outlet tap. A tap near the bottom of the tank is now opened, and water flows out from the smooth and rounded outlet. Determine the maximum water velocity (in m/s) at the outlet. Round your answer to 1 decimal place.
A river reach had a flood wave passing through it. At a given instant the storage of water in the reach was estimated as 15.5 ha.m. What would be the storage in the reach after an interval of 3 hours if the average inflow and outflow during the time period are 14.2 m3/sec and 10.6 m3/sec respectively.
A motorboat and its load weigh 980 kg. Assume that the propeller force is constant and equal to 24 kg, and the water resistance is numerically equal to 1.5v kg, where v is the speed at any instant time in m/sec. If the boat starts from rest, determine its speed at the end of 10 seconds. Answer is 2.23 m/s
A circular tank of diameter 3 m contains water up to a height of 4 m. The tank is provided with an orifice of diameter of 0.4 m at the bottom. Find the time taken by water to fall from 4 m to 2m. Take Cd= 0.60include your free body diagrama.84.7 seconds b.47.8 seconds c.24.8 seconds d.43.8 seconds
A student pilot taxiing a Cessna 172 - Skyhawk is brought to a full stop with a total distance of four hundred fifty meters from a speed of 21 knots. (a)Determine the frictional energy absorbed by the breaks. (b) Consider that the stopping force is brought by a constant force resisting the motion, what is the force? Note: The kinetic energy of rotation of the wheel is negligible. Given: mpilot = 170lbs mairplane = 757 kg
A plow located on the front of a locomotive scoops up snow at the rate of 10 ft^3/s and stores it in the train. If the locomotive is traveling at a constant speed of 12 ft/s, determine the resistance to motion caused by the shoveling. The specific weight of snow is gs = 6 lb/ft^3