Q2:- A potential difference of 15 V is applied longitudinally to a rectangular specimen of intrinsic Ge of length 3cm, width 0.5 cm and thickness 0.2 cm. Calculate : a. Electron and hole drift velocities b. Conductivity of Ge c. The total current Given: intrinsic carrier density= 2.5×10/ m³ ; µ„=0.38 m² /Vs, µp=0.18 m² /Vs; Constants: k=1.38x10-23 J/K =8.62x10$ eV/K, h=6.625x10-34 J.s =4.135x1015 eV.s, kT=0.0259 eV

Q2:- A potential difference of 15 V is applied longitudinally to a rectangular specimen of intrinsic Ge of length 3cm, width 0.5 cm and thickness 0.2 cm. Calculate : a. Electron and hole drift velocities b. Conductivity of Ge c. The total current Given: intrinsic carrier density= 2.5×10/ m³ ; µ„=0.38 m² /Vs, µp=0.18 m² /Vs; Constants: k=1.38x10-23 J/K =8.62x10$ eV/K, h=6.625x10-34 J.s =4.135x1015 eV.s, kT=0.0259 eV

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter29: Introduction To Quantum Physics

Section: Chapter Questions

Problem 62PE: (a) If the position of an electron in a membrane is measured to an accuracy of 1.00 m, what is the...

See similar textbooks

Similar questions

(a) If the position of an electron in a membrane is measured to an accuracy of 1.00 m, what is the electron's minimum uncertainty in velocity? (b) If the electron has this velocity, what is its kinetic energy in eV? (c) What are the implications of this energy, comparing it to typical molecular binding energies?
1- Consider the measurement of pressure in a gas through measurement of its temperature T and density P Let the uncertainties of T and p be oT and op where p is determined from the ideal gas P = pRT. Derive an expression of uncertainty (error) in P and determine 6P / P. Suppose the uncertainty in op is 1% and in OT is 2 ° at T = 27º. 2- A battery supplies a current I to a resistor R with a potential difference E, the percentage uncertainties in E, I and R are known to be identical should the power drawn from the battery W be calculated as E * I or 12 * R . Derive an expression of uncertainty in W.
Question 2 (A) : What is Fermi Deric probability of level above of Fermi level by 0.25 ev if temperature is 289°
If the position of an electron in a membrane is measured to an accuracy of 3.58 µm, what is the electron's minimum uncertainty in velocity (in m/s)? a) If the electron has this velocity, what is its kinetic energy in eV? b) What are the implications of this energy, comparing it to typical molecular binding energies?
Sketch a plot of the current I versus voltage V across an ideal photocell when visible light is incident on the cell. Note that the “amplitude” factor I0 should be assumed to be negative.
If the radius of a calcium ion is 0.19 nm, how much energy does it take to singly ionize it? Give your answer in electron-volts (eV) with precision 0.1 eV. Give your answer to 2 significant digits. (with step pls)
A. If the position of a chlorine ion in a membrane is measured to an accuracy of 1.50 µm, what is its minimum uncertainty in velocity (in m/s), given its mass is 5.86 10-26 kg? B. If the ion has this velocity, what is its kinetic energy in eV? (Compare this with typical molecular binding energies of about 5 eV.)
The Type K thermocouple has a sensitivity of about 41 micro-Volts/℃, i.e. for each degree difference in the junction temperature, the output changes by 41 micro-Volts. If you have a 32-bit ADC, what is the smallest temperature change you can detect if the ADC range is 10 V? Try leaving the answer as a decimal with significant digits: e.g., 0.00004100.
Sketch a plot of the current / versus voltage V across an ideal photocell when visible light is incident on the cell. Note that the "amplitude" factor lo should be assumed to be negative.
if radius of manganese ion is 66ppm nd fluoride ion is 134 ppm then what is the shortest distance between two fluoride ions
A 1 V potential will be applied to a thin layer of nichrome to generate a current (along the long dimension, 5 cm.) The nichrome coats a glass rectangular prism with the dimensions shown. The base of the glass prism will be kept at room temperature, 300K. What will be the steady temperature of the nichrome? The prism has dimensions 5 cm wide, 4 mm high, 1mm thick.
d. Calculate the probability of an electron occupying an energy state that is 0.2 eV above theelectrochemical potential for a material at 110 oK.