Q2) A silicon crystal having a cross-sectional area of 0.001cm? and a length of 10 cm is connected at it s ends with 10v battery at temperature 300°K, when the current is 100mA. Find the resistivity and the conductivity?

Q2) A silicon crystal having a cross-sectional area of 0.001cm? and a length of 10 cm is connected at it s ends with 10v battery at temperature 300°K, when the current is 100mA. Find the resistivity and the conductivity?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: A noncontributory semiconductor has some holes in room temperature. What causes these holes? Please…

A: OPTION D THERMAL ENERGY

Q: the electron and hole mobilities in silicon at 320 K are 0.13 and 0.029, and assuming hole and…

Q: B) The conductivity for n-side is 1500 s/m and for p-side is 400s/m in pn junction, while the…

A: Given : Barrier potential is proportional to the doping concentration and temperature. Vt =…

Q: Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is…

Q: 12. If the conductivity of the pure Germanium change with temperature according the fol- lowing…

A: Given data: σ=e-4350T

Q: A voltage of 8 V is applied over a silicon specimen that is 78 mm in length. The electron mobility…

Q: Q3. G/ When a silicon material is doped with Arsenic (As) that has 5 valance *:electrons, the doped…

A: Silicon material has four valence electrons and it bond to pentavalent like Arsenic (As) material,…

Q: Silicon is doped with a phosphorus concentration of 2×1016/cm3. What are NA and ND? What are the…

Q: 5. Consider P-type silicon with n, = 100 cm-3 and NA = 4 x 104 cm-3. (a) Find the concentrations of…

A: Given ni = 1010 and NA = 4*1014 then find for electron and hole concentrations for p type material ?…

Q: (11) The mobility of free electrons and holes in pure germanium are 3,800 and 1,800 cm2 /V-s,…

Q: Q2) A silicon crystal having a cross-sectional area of 0.001cm and a length of 10 cm is connected at…

A: According to guidelines we need to solve the value of resistivity and the conductivity with the help…

Q: Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is…

A: Here i have found the concentration of electrons in n type si and concentration of holes in p type…

Q: Calculate the thermal-equilibrium of electron concentrations per cubic centimeter in a compensated…

Q: A Si semiconductor at T=300 K is initially doped with donors at a concentration of Ng=5 x 1015 cm3.…

A: Given data:ND=5×1015/cm3J=50A/cm2R=10KΩV=5 VEMAX=100V/cmWe know that:J=IAWhere, I=current through…

Q: Q3:- A bar of p-type silicon, has a cross-sectional area A =106 cm? and a length L= 1.2x103 cm. For…

Q: A silicon semiconductor has a shape of a rectangular bar with a cross sectional area of 1x10-6cm2…

Q: 2. The concentration of donor impurity atoms in silicon is Nd = 1015 cm-3. Assume an electron…

A: The conductivity of a semiconductor lies in between conductor and insulator. The conduction in a…

Q: A particular silicon semiconductor device requires an n-type semiconductor at 300 K with a…

Q: 1 (a) Suppose in a donor doped semiconductor at a particular temperature, EF is 0.015 eV above than…

A: d is correctconcept: in n-typeas T→ OKEF lies avove EDAand at some intermediate temp. Ef-Edand at…

Q: Q2) A silicon crystal having a cross-sectional area of 0.001cm and a length of 10 cm is connected at…

Q: Question #3.2 Consider a compensated n-type silicon at 300K having a conductivityo=16 /NCm and…

Q: Q:- A current of (2 HA) passing through an intrinsic silicon bar has (3 mm) length and (50 x 100…

A: Given: Current, I=2 μA Length, L=3 mm Cross sectional area, A=50×100 μm2 Resistivity, ρ=2.3×105 Ω·cm…

Q: Find the resistivity of intrinsic silicon at 400 K and classify it as an insulator, semiconductor,…

Q: Question 4 If a pure ("intrìnsic") semiconductor material is heated, the thermal energy liberates…

A: In pure intrinsic semiconductor, the concentration of electrons is equals to concentration of holes.…

Q: In a boron-doped silicon layer with impurity concentration of 2.8×10" cm-3, find the hole and…

A: T=27oC The impurity concentration is the concentration of the acceptor since boron is electron…

Q: Q3:- A bar of p-type silicon, has a cross-sectional area A = 10° cm and a length L= 1.2x10 cm. For…

A: The given data's are, Cross sectional area A=106 cm2, The length is L=1.2×103 cm, The applied…

Q: A Germanium semiconductor at 300k is doped with 2. 5*10^15 cm^-3 arsenic atoms and 1.8*10^15 cm^-3…

A: The arsenic atoms are 15th group element and boron is 13th group element. The arsenic atom will give…

Q: An n-type semiconductor sample has an electron density of 6.25 x 10 ^ 18 / cm ^ 3 at 300K. If the…

Q: In a P-type semiconductor, the Fermi level is 0.3 ev above the valance band at a room temperature of…

A: Fermi level in P-Type semiconductor lies near to valence band. Fermi level EF in P-Type…

Q: Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is…

Q: Explain with the help of band structure diagrams why the following operations can result in the…

A: Ans (a) The conductivity of semiconductors is increased by adding an appropriate amount of suitable…

Q: 1- In your own words, describe the classification of materials according to conductivity, with…

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: 10. A silicon diode has a saturation current of 10 nA at 25t. If it operates over a temperature…

Q: the electron and hole mobilities in silicon at 320 K are 0.13 and 0.029, and assuming hole and…

Q: 1 (a) Why Ge material has a lower Vbi than Si at T = 300 K and GaAs has a higher Vbi than Si at T =…

A: Built in voltage given by vbi = (kT/q) loge(NaNd/ni2) Here ni is intrinsic concentration T is…

Q: Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is…

A: In a doped semiconductor bar, the electron and hole concentrations are not equal. The concentration…

Q: The intrinsic carrier density at 300 K is 1.5x10^10/cm^3 in silicon. For n-type silicon doped to…

A: The given semiconductor is n-type, the majority carrier will be the electrons. The electron density…

Q: Q1/Fill in the following blanks and explain the solution steps in d 2-Approximately in a pure…

A: There are two types of charge carriers in a semiconductor these are holes and electrons whereas in a…

Q: Q2) A silicon crystal having a cross-sectional area of 0.001cm- and a length of 10 cm is connected…

A: In this question , we have to find out resistivity and conductivity of silicon crystal..Given values…

Q: Using the second approximation with VT=0.7V for both diodes, what are the states of D1 and D2…

A: When power supply 1 of 7 V is on and power supply 2 is off then no current flows flows through the…

Q: A uniform piece of n-type Silicon (Si) is 20 nm long and 1 V voltage is applied across it. If the…

Q: a) Explain the band structure of an electrical conductor (metal), a semiconductor, and an insulator…

A: b) P-type semiconductor P-type semiconductor is formed by adding trivalent elements i.e .B, Al ,Ga…

Q: 1) A silicon crystal having across section area of (0.001cm²) and a length of (10°cm) is connected…

Q: 7. For a certain semiconductor compensated semiconductor N,2x10 cm', N-6 10' cm'and n-10" cm. At an…

Q: Figure Q4 shows the silicon wafer. This silicon has been added with the two elements as listed in…

A: Fig: Given silicon wafer Although si concertation of silicon wafer is 1x 1018 atoms /cm3 .…

Q: Q2. Explain how doping a pure silicon crystal with donor impurity atoms makes more charge carriers…

A: When a small quantity of impurity in a semiconductor is added than the impurity contributes either…

Q: the electron and hole mobilities in silicon at 320 K are 0.13 and 0.029, and assuming hole and…

A: We need to find out conductivity for given semiconductor

Q: Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is…

Q: A bar of p-type silicon, has a cross-sectional area A = 10.6 cm and a length L=1.2*10^ -3 cm. For an…

Q: Question 3-) Silicon is doped with Np = 4 x 1015 impurity atoms/cm?. Assume the electron and hole…

A: The formula to calculate the resistivity of a material is σ=qNDμn+nIμp…

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

Q2) A silicon crystal having a cross-sectional area of 0.001cm
and a length of 10 cm is connected at it s ends with 10v battery at
temperature 300°K, when the current is 100mA. Find the resistivity
and the conductivity?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where R1 and R2 are the resistances at temperatures T1 and T2, respectively, and is known as the temperature coefficient of resistance. If a copper wire has a resistance of 55 at 20C, find the maximum permissible operating temperature of the wire if its resistance is to increase by at most 20. Take the temperature coefficient at 20C to be =0.00382.
What is CEMF?
How is a solid-state diode tested? Explain.
What is a proton? Where does it normally exist in an atom, and what is its charge?
For residential water heaters, the Consumer Product Safety Commission suggests a maximum temperature setting of ___________ F (_____________ C). Some states have laws stating a maximum temperature setting of ____________ F (________________ C).
Describe briefly the method a dry cell battery uses to produce voltage.
Semiconductors are ____________. conductors insulators half conductors none of the above
At what temperature will intrinsic silicon become a conductor based on the deﬁnitions in Table ? Assume that μn=120 cm2/V·s and μp = 60 cm2/V·s. (Note that silicon melts at 1430 K.)
A silicon semiconductor has a shape of a rectangular bar with a cross sectional area of 1x10-6cm2 and a lenght of 0.1 cm. How do i calculate the current through the semiconductor if a basis of 5 volts is applied across its length?
Density of state of copper The Density of state for copper 8.9 gm/cm^3 Q1)Find and explain: a-The fermi level is located at........b-The energy gap = Q2)Choose and explain: a-The boud gap is (small-big)b-This means that copper is a(conductor-semiconductor-)
A silicon sample is doped with 5.0×1019 donor atoms/cm3 and 5.0 × 1019 acceptor atoms/cm3. (a) What is its resistivity? (b) Is this an insulator, conductor, or semiconductor? (c) Is this intrinsic material? Explain your answers.
Figure Q4 shows the silicon wafer. This silicon has been added with the two elements as listed in Table Q3. Identify the majority charge carrier in each extrinsic silicon wafer and justify your answer with illustrations.