Q2) Choose the correct answer for only 15 (fifteen) of the following. is about 67% of the total forces. A) Longitudinal force. 1) In turning operation, the E) thrust force. B) Radial force. C) feed force. D) cutting force. (c) 2) Which one of the following materials has the lowest hardness: (a) aluminum oxide, (b) cubic boron nitride, f) none of the previous answers. high-speed steel, (d) titanium carbide, or (e) tungsten carbide 3) Which one of the following operations is generally capable of the closest tolerances: (a) broaching. (b) drilling. (c) end milling, (d) planning, or (e) shaping. F) none of the previous answers. AL

Q2) Choose the correct answer for only 15 (fifteen) of the following. is about 67% of the total forces. A) Longitudinal force. 1) In turning operation, the E) thrust force. B) Radial force. C) feed force. D) cutting force. (c) 2) Which one of the following materials has the lowest hardness: (a) aluminum oxide, (b) cubic boron nitride, f) none of the previous answers. high-speed steel, (d) titanium carbide, or (e) tungsten carbide 3) Which one of the following operations is generally capable of the closest tolerances: (a) broaching. (b) drilling. (c) end milling, (d) planning, or (e) shaping. F) none of the previous answers. AL

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

can you solve the question please and explain it
put very detailed answer
Can you solve the question and explain it
Is it possible to solve the question as soon as possible and with all the points?
Explain also
Can you please write the steps clearly as to how the answer came
Answer it correctly please and explain your answer. I will rate accordingly.
After greetings, How to solve this problem and what’s the final answer? AND THANK YOU VERY MUCH.
(USCS units) A turning operation is performed using a rake angle of 15°. Cutting speed = 200 ft/min, feed= 0.012 in/rev, and depth of cut = 0.100 in. The chip thickness ratio measured after the cut = 0.48. Determine (a) chip thickness after the cut, (b) shear angle, (c) friction angle, (d) coefficient of friction, and (e) shear strain (USCS units) The turning operation in the previous problem involves a work material whose shear strength = 52,000 lb/in2. Based on your answers to the previous problem, compute (a) shear force, (b) cutting force, (c) thrust force, and (d) friction force.
Asap please Please give correct answer with clean hand writing and explain step by step. Note:- are you sure then atten question.
answer would be appreciated
Please explain how to arrive at the answer, thank you