Start your trial now! First week only $4.99!*arrow_forward*

Question

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: 8. Problem 4.8: Using superposition, find V, in the following circuit. 4Ω Vo 1Ω 3Ω 5Ω 3 V

A: To find the value of voltage Vo in the below circuit by superposition theorem:

Q: The load ZL in the circuit of Figure consistsof a 25-Ω resistor in series with a 0.1-H inductor.Ass...

A: The impedance of the inductance is, The expression of the load is,

Q: Problem jD.2 E, S0.2 j0.1 le J0.4 ee M.2 Eliminate nodes 3 and 4 from the circuit and find Ybus and ...

A: Click to see the answer

Q: Sketch the continous time signal u(2t+3)

A: Write the expression for the unit step signal, Now, draw the graph of the unit step signal versus t...

Q: a single phase 11 KV line with the length of 15 kilometre is to transmit 500kva the inductive reacta...

A: Assuming the power factor to be 0.8 lagging because it seems that there is a typo while mentioning t...

Q: What is the voltage VIN (in volts) needed to saturate the transistor below, given: V = 10 V, R3 = 98...

A: Click to see the answer

Q: In a series resonant RLC circuit, a 1000 ohm resistor, a 10 mH inductor and a 5 micro F capacitor is...

A: If a series resonant circuit consists of a resistor of resistance R, an inductor of inductance L and...

Q: 4. Draw the Bode magnitude plot of (Same for all of you). KG(s) = (s+5)(s+ 200) Explain how you come...

A: Given transfer function is -

Q: Solve,

A: Referring to the given figure, there is a bridge attached with the circuit in series with the resist...

Q: 25-2: For the following master-slave structure of two edge-triggered flip-flops, D and T, complete t...

A: The diagram of Flip-Flop is: Both flip-flops have the same clock pulse. The signal A is input to D ...

Q: 1. An infinitely long filamentary wire carries a current of I A along z-axis in the +z direction. Ca...

A: (a) Let P be the point at which the magnetic field is to be calculated. Write the coordinates of the...

Q: 7 In the circuit shown in Figure P5.67, assume that DC steady-state conditions exist for t < 0. Dete...

A: It is given that the switch is closed and the circuit is under DC steady-state condition for t = 0-....

Q: b) Find the power delivered by the 9V battery. R7 1kO R4 1к0 R6 1kO .9V V2 R5 1kQ

A: Given circuit is -

Q: A 10 hp single phase motor is connected to 240 volts. The motor nameplate indicates a NEMA code B, a...

A: Given values are -

Q: Determine the value of W816. Please submit asap. I have to upload the solution at the earliest.

A: The twiddle factor is a very important parameter in digital signal processing. For N point discrete ...

Q: Rs Vs R2: Figure P5.47 8 For the circuit of Figure P5.47, assume Vs 100 V, Rs = 4 k2, R¡ = 2 k2, R2 ...

A: To find the voltage across capacitor (vc) of the following circuit:

Q: Find out the Fourier transform of X(t)=e-atu(t).

A: For any continuous-time signal x(t), the Fourier transform is defined as In this case, the expressi...

Q: What will be the rms electric field at 30 m away from a transmitter which is transmitting 20 W power...

A: If P is the transmitted power by the transmitter, then the value of the RMS electric field (E) at r ...

Q: If the ripple parameter of a Chebyshev filter is 0.884, find out the value of the beta parameter.

A: The beta parameter is needed to determine the pole positions of the Chebyshev filter. It can be expr...

Q: 23-10: Derive the output logic equation F(x3,X2,X1,Xo) from the following circuit. Note that the pri...

A: Given the priority of priority encoder as follow: It indicates that the values of x0, x3 and x1 doe...

Q: For an operational amplifier, the differential gain and the common mode gain is 5555 and 5 respectiv...

A: An operational amplifier is basically a differential amplifier. This means that the differential gai...

Q: Convert the following single precision IEEE 754 binary numbers to decimal: 010000101111000110010000...

A: According to IEEE 754 single-precision binary number notation, the leftmost bit (MSB) is the sign bi...

Q: 1. A three phase, 10 pole, 60 cycle IM has a full load slip of 0.075. What is the speed of: a. the r...

A: The synchronous speed of the induction motor is given by the expression as shown below: Plugging th...

Q: 2 Determine vc(t) for t > 0. The voltage across the capacitor in Figure P5.32 just before the switch...

A: The initial voltage across the capacitor is -7 V. Draw the circuit after the switching operation.

Q: Find the z-transform of x(n)=(n-1)(0.3)(n-3)cos(π(n-1)/4)u(n-2). (Find the ROC also).

A: Consider the given expression,

Q: 1. A control system is defined by the following: -1 0 07 P = 1 1 0 L = [0 1 1] B= 1 o1 (a) Determine...

A: To check the controllability form the controllability test matrix as shown below. If the determinan...

Q: 4 If the switch in the circuit shown in Figure P5.64 is closed at t = 0 and Vs = 12 V C = 130 µF R =...

A: It is known that the inductor behaves as a short circuit and the capacitor behaves as an open circui...

Q: What will be the order of the Chebyshev filter if the ripple factor is 0.885, stop band attenuation ...

A: The order N of a Chebyshev filter can be computed using the following relation: It is to be noted t...

Q: 26. PID controllers produce outputs that that depend on: a) magnitude of the error signal b) duratio...

A: PID Controller: It stands for proportional-integral-derivative controller. All these three control c...

Q: For the ideal transformer shown in Figure P7.46,consider that vS (t) = 294 cos(377t) V. Finda. Prima...

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...

Q: please make every step very very clear with explanation

A: The discrete signal is: The signal is sketched as follows: the discrete-time unit impulse signal is...

Q: The radiation resistance of a dipole antenna is 2 ohm. Estimate the length of the dipole antenna in ...

A: For a dipole antenna, the expression of the radiation resistance (Rr) is given as

Q: 4 Are the filters shown in Figure P6.24 low-pass, high-pass, bandpass, or bandstop (notch) filters? ...

A: Figure 1, Since the capacitor and the resistor are connected in parallel, the voltage across those w...

Q: 24-4: Analyze the following cross-coupled exclusive-OR-exclusive-NOR gates. Include state equations,...

A: From the circuit diagram, write the state equations. Here, G1(t+) and G2(t+) are the next states of...

Q: 4. The Bode plot shown below represents the voltage gain of a particular amplifier. Sketch the input...

A: Consider the input of the amplifier, The input of the amplifier is given. If the magnitude and the ...

Q: A substation receives 6000 kVA at 6 kV, 0.8 p.f. lagging on low voltage side of a transformer from a...

A: The generating station is connected to the substation. The approach to solve this problem will be fi...

Q: Solve question (1).

A: Based on the power supply, the electrical instruments can be classified in three categories: 1. The ...

Q: 2. Given the following circuit, complete the timing diagram. Either describe the resulting values of...

A: Click to see the answer

Q: Find the value of the electric field between the plates of the parallel plate capacitor if the volta...

A: In a parallel plate capacitor system, if V is the applied voltage and if d is the separation between...

Q: 3. A series resonant circuit has 100Q of resistance and 500Q of inductive reactance at 1000HZ. Deter...

A: Write the expression for the inductive reactance, Substitute 500 Ω for XL and 1000 Hz for f,

Q: Describe what a 16-to-1 one-bit multiplexer does. Write a Boolean expression that implements this mu...

A: Multiplexer is a combinational circuit that consist of n selection lines, and 2n data inputs. These ...

Q: What will be the value of the following Williamson's factor W84?

A: In digital signal processing, Williamson's factor or commonly known as the twiddle factor is a very ...

Q: Determine Vx in the circuit of Fig. 3.11.

A: The circuit diagram is: The modified figure is:

Q: The white wire of a cable may be used to connect to a "hot" ungrounded circuit conductor only if ?

A: A "hot" ungrounded cable is the wire that carries major power from the source terminal to the destin...

Q: a 500-up synchronous motor is connected to 2300 volts. The motor is to operate at 90% power factor. ...

A: To find the running current of the synchronous motor of 500 hp which is supplied with 2300 V.

Q: What are the answers to question 2? I put another photo where you can or an explanation to know how ...

A: Question 2: The value of current at R4 Consider the given below circuit,

Q: 8 If we model each winding of a three-phase motor like the circuit shown in Figure P7.68(a) and conn...

A: Calculate the reactance of the inductor, Calculate the impedance of one branch,

Q: What will be the effective isotropic radiated power of an antenna transmitting 25 W of power and the...

A: The effective isotropic radiated power is the product of the power transmitted (PT) by an antenna wi...

Q: Determine the sequence x[n] with z-transform X(2) = (1+2z)(1+3z=1)(1 – z=1).

A: To solve this problem first the given expression will be reduced to a simplified form. After that, t...

Q: 3. Problem 2.22: Find Vo in the following circuit and the power absorbed by the dependent source. 10...

A: To find the value of voltage Vo and power absorbed by the dependent source in the below circuit:

Transcribed Image Text

Q2:- find Vs in the below circuit? R2 R1 1.41kn 1.2ko R5 2k0 R3 Vs=? 3.4kO R7 2.15kn R9 R8 1.23KQ 2.43kn R4 1.15kO 1.32kn R6 +25V R10 1.23kn |=1.51mA