Q#2: For the two-gear system shown in following figure; a) Calculate Gear Ratio b) If the speed of Driver Gear is 30 revolutions per minute (rpm) then what will be speed of Driven Gear? c) Among two gears (driven gear and driver gear), which gear has highest speed in revolutions per minute.? d) What should be number of teeth on Driven gear to move with speed of 4 times than that of Driver Gear?

Q#2: For the two-gear system shown in following figure; a) Calculate Gear Ratio b) If the speed of Driver Gear is 30 revolutions per minute (rpm) then what will be speed of Driven Gear? c) Among two gears (driven gear and driver gear), which gear has highest speed in revolutions per minute.? d) What should be number of teeth on Driven gear to move with speed of 4 times than that of Driver Gear?

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter38: Manual Transmissions And Transaxles

Section: Chapter Questions

Problem 4RQ: Define the purpose of the final drive gears.

See similar textbooks

Similar questions

what is the equation of the addendum and dedendum in helical gears
Two mating 20°, 8-pitch, spur gears have 14 and 42 teeth. Will they interfere?
State an equation tha relate the number of teeth of gear D, B and C.
Define the purpose of the final drive gears.
A spur gear has a pitch diameter, Pd of 3. Calculate its Addendum.
2-) Answer the following questionsa-) The number of teeth that the gear wheels will have at least in order not to be cut from under the profile is called the limit tooth number. Calculate the theoretical minimum number of teeth the pinion gear can have by considering the reference profile without profile slip in evolvent gears, taking the clutch angle of 250.b-) If a gear system is dimensioned according to surface pressure calculations and controlled according to strength, how can a comment be made about the hardness of the gear wheel. Give examples of what the material of this gear wheel could be (3 pieces).
A gear box conta8he 3 sizes of gears, 8 tooth, 32 tooth and 64 teeth. What is the gear ratio when the 8 tooth gear drives the 64 tooth gear?
Write a gear ratio equation between 2 gears for number of teeth, torque, angular velocity, aswell diameter. You have 2 straight gears 1 and 2 in mesh
What will the number of pairs of teeth in contact if arc of contact is 31.4mm module is equal to 5
Plz answer this in 40 min, i need the answer ASAP,thx mechanical engineering Determine from the image below: 1. Types of gears in below gearbox. 2. module 3. surface width (tooth width), and 4. Outer diameter of pinion and gear.
The radial distance between the top of one gear tooth and the bottom of another gear tooth when two gears are in mesh is known as ______________________. working depth circular pitch total depth clearance
A spur gear system compose of 45 tooth driving gear. The driver and the driven gear are rotating at 75 RPM and 150 RPM respectively. Calculate the number of teeth of the driven gear. Calculate the center to center distance between the gears if Pd is equal to 10.