Q2:- The pressure of the gas corresponding to various volumes V is measured, given by the following data in the table, by used curve fitting method and equation p = av +- find the pressure at v = 8 cm3 v(cm3 ) p(kg/cm2) 7 1 2 4 7.66 9.25 3 6.5 11

Q2:- The pressure of the gas corresponding to various volumes V is measured, given by the following data in the table, by used curve fitting method and equation p = av +- find the pressure at v = 8 cm3 v(cm3 ) p(kg/cm2) 7 1 2 4 7.66 9.25 3 6.5 11

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter9: Mass And Mass-related Variables In Engineering

Section: Chapter Questions

Problem 37P

See similar textbooks

Related questions

Q: Consider a cylinder of specific gravity SG < 1 floating vertically in water (SG = 1), as in the…

A: Solution- The given values are as follows,The cylinder's diameter is D. h is the height of the…

Q: 1.- In the following figure the liquid of A and B is water and the liquid of the manometer is oil…

Q: 1. The cylinders are piled in a rectangular ditch as shown. Neglecting friction, determine the…

A: Answer:- In this question we will use equation of equilibrium to find out the value…

Q: Consider the parallel springs shown in the accompanying figure. Realizing that the deflection of…

A: Springs are elastic members which upon loading get distorted and after removal of load they regain…

Q: PROBLEM I - The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

Q: For the system shown in the sketch, if or =-12 psi and oa -20 psi, then calculate a. Erl b. Eat…

A: NOTE : Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: The mass flow of air as it flows through the circular duct is defined by the equation below where p…

Q: A differential U-tube manometer is used to measure the change in pressure between two points in a…

Q: The system shown in the figure is used to accurately measure the pressure changes when the pressure…

A: Given S=1.26pgpw=1.26⇒ρglycerine=1260 kgm3

Q: Q1. The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

A: We have to determine the value of pressure difference ∆P=PB - PA according to the given data and…

Q: 100 mm 75 mm 25 mm 75 mm

Q: In the figure shown, determine the weight that can be carried by the 1.5 kN force acting on the…

A: To determine the weight that the piston can carry. Given, Load acting on the piston (F) = 1.5 kN…

Q: 25. Which of the following cannot be the value of absolute pressure of a fluid at any point? a) 0 b)…

A: Absolute zero pressure is the refrence used for measurement of absolute pressure. Absolute zero…

Q: 21. For the figure below, the specific gravity of unknown fluid is equal to ......... a. 1.271 b.…

A: Asked: To determine the specific gravity of the unknown fluid. Given (from the figure): Specific…

Q: 1. Consider a tanker truck as shown in the figure. The truck accelerates 4 m/s2. It is fully filled…

Q: A 60-N sledge hammer shown in the figure strikes the 90 N wood block which is at rest on the coil…

A: Total force delivered by the hammer to springP=static+dynamic static force =wt of hammer=60 NDynamic…

Q: In the figure (a) shown, fluid A is alcohol with SG = 0.79, fluid B is mercury, z = 450 mm, y = 900…

Q: 2.16. A horizontal drum, a cross-section of which is shown below, is being filled with benzene…

A: a} Consider the given data V=Lr2cos-1r-hr-r-hr2-r-h2at h=0V=Lr2cos-1r-0r-r-0r2-r-02…

Q: In the figure below, a fluid with a specific gravity of 0.77 is flowing. The mass flow rate is…

A: Given data, Specific gravity = 0.77 Mass flow rate = 18.5 kg /s Diameter of nozzle = 4.87 cm θ =…

Q: In the system shown in figure find the ratio A1/A2 if the change in pressure at B by 0.5 psi gives 1…

Q: 3. In Francis empirical expression for discharge, the relation between head of water and discharge…

A: correct option:-(b) Q is directly proportional to the H^1.5

Q: 1. A liquid flows through an orifice located in the side of a tank as shown in the Figure below. A…

A: Given formula for discharge is: Q = 0.61A2gh

Q: A tank contains gasoline and glycerine with open piezometer tubes attached as shown. The depths of…

Q: 3. In Francis empirical expression for discharge, the relation between head of water and discharge…

A: Francis turbine is a type of water turbine. It is a type of inward flow reaction turbine

Q: 3. In Francis empirical expression for discharge, the relation between head of water and discharge…

A: Introduction- A diameter of the compression point of discharge should not be less than the diameter…

Q: 21. For the figure below, the specific gravity of unknown fluid is equal to a. 1.271 b. 1.35 C. 2.25…

Q: V Figure 3

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: Situation 2: As shown in the figure, two blocks are connected by a light, flexible cord passing over…

Q: 19. A distance was measured on an 8% slope and found to be 2620.30 m. What is the horizontal…

Q: f the pressure gage shown in the figure indicates a pressure of 6.5 x 10 N/m2 (6.5 bar) what are the…

A: Calculate the pressure at point B as follows: Starting from pressure gauge to the right side top of…

Q: Q1) A hinged gate with a parabolic shape is given below. Calculate the force F needed to keep the…

A: The given figure is shown below:

Q: THE CIRCULAR TROUGH AS SHOWN IN THE FIGURE IS FILLED WITH WATER UP TO THE BRIM. USING THE THEOREM OF…

Q: 1- Figure Q1 shows water discharged from a tank with velocity v (m/s). The velocity can be…

A: Using the Bisection method to calculate the head which gives velocity 22m/s as per the equation,

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: 1. Consider a tanker truck as shown in the figure. The truck accelerates 4 m/s2. It is fully filled…

A: Solution: Given: a = 4 m/s2 ρ=726 kg/m3 Free body diagram: Assume the imaginary liquid surfaces of…

Q: 5. A liquid flows through an orifice located in the side of a tank as shown in the Figure below. A…

Q: Refer to the the flow shown in the figure. The velocity before the contraction is 1.51 m/s. Given: h…

A: We have to asked the height of fluid in the manometer in meters.

Q: Three different fluids, water, oil (SG = 0.83), and unknown fluid, fill the tank and manometer tube…

Q: A pressurized tank contains water with some air above it. As shown on figure below. Multi-fluid…

Q: 3. An open manometer, shown in figure, is installed to measure the pressure in a pipe carrying an…

Q: In figure 6, compute the pressure difference between m and n, in pounds per square inch, when: (a)…

Q: Oil 45 kPa SG = 0.72 75 cm Air Water 30 cm Mercury SG= 13.6

A: Specific gravity of oil ,SGo=0.72Specific gravity of mercury ,SGm=13.6Depth of oil = 75cm=0.75mDepth…

Q: 2. What is the relationship between volume and pressure? 3. Calculate the volume if it is v1=1.5 L,…

Q: A cylindrical container whose weight is titet Ibf is inverted and pressed into the water, as shown…

Q: 1.9 Apply the grid method to calculate the density of an ideal gas us- ing the formula p = p/RT.…

A: Given data:P=35 psiR=1716 ft-lbf/slug-°RT=100 °F

Q: (Q1a) For the compound manometer shown in Figure 1, determine the absolute pressure in pipe A (in…

Q: Situation 2: As shown in the figure, two blocks are connected by a light, flexible cord passing over…

Q: Three different fluids, water, oil (SG - 0.83), and unknown fluid, fill the tank and mancmeter tube…

A: We know that, Pressure at any point, P = γh Where, γ = Unit gravity h = Height from…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

Q2:- The pressure of the gas corresponding to various volumes V is measured,
given by the following data in the table , by used curve fitting method and
equation p = av + find the pressure at v = 8 cm3
v(cm3 )
p(kg/cm2) 7
4
7.66 9.25
1
3
5
6.5
11

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A closed tank contains compressed air and oil (SG = 0.90) as is shown in FIGURE FMVP-1. A U-tube manometer using mercury (SG = 13.6) is connected to the tank. The column heights are h1 = 36 in., h2 = 6 in, and h3 = 9 in. Determine the pressure reading of the gage in psi. a. 439.92 b. 5279.04 c. 3.055 d. 7132.32
3. A vertical piston-cylinder device on the left containing a gas has a mass of 40 kg and a cross-sectional area of 0.012 m². The local atmospheric pressure is 95 kPa, and the gravitational acceleration is 9.81 m/s². Determine the absolute pressure (kPa) inside the cylinder. (2 decimal)
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8
In figure 3 compute the pressure head difference between m and n, in feet of fluid A, when: A. Fluid A is gasoline (sp gr 0.715), the gage liquid is mercury, and z = 47.77 in B. Fluid A is oil (sp gr 0.908), the gage liquid is water, and z = 27.77 in C. Fluid A is sea water (w = 64.0), the gage liquid has a specific gravity of 2.95, and z = 57.77
Fluid mechanics- Bernoulli's Equation along a streamline: The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure tap at station 1. The velocity at station 2 is twice that at station 1. Air with a density of 1.2kg/m3 flow through the duct. A water manometer is connected between the stagnation probe and the pressure tap, and a deflection of 10cm is measured. What is the velocity at station 2?
The water speed coming out on the pipe from a cylindrical tank shelter as in the image beside is (in the picture) known g = 9.81 m / s² H is the initial high water (m), l is the length of the pipe (M), t is the time passing. Determine the high H needed to produce water speed v = 5 m/s at t = 2.5 seconds for pipe length L = 4 m, calculate 1. BISECTION 2. False position for initial guess XL = 0 and XU = 2 m Calculate up to £ = 1%
Show complete and detailed solution. Show FBD of the figure. What is the smallest mass of B to make the system in equilibrium while neglecting the friction between the string and the ramp? Mass of Block A = 45kg Coefficient of Block A, Block B, and Ramp C = 0.10
For the figure ,point A is (30 cm) below the surface of liquid , What is the pressure. * a_17.658 kpa b_17.658 kpa (vacume) c_176.58 kpa d_Option 4
A closed cylindrical tank 1.845m high and 0.945m in diameter contains water of height 1.35m. When the angular velocity is constant at 20rad/sec , If it is rotated at 15rad/sec and the air has a pressure of 200kPa what is the minimum pressure at the bottom of the tank in KPa? CHOICES a.) 220.48 b.) 22.48 c.) 202.48 d.) 248.22
The object W1 in the figure is at an angle of 45 to the horizontal It is based on its frictionless surface at point B. Point A is articulated (fixed support) and ground friction Since (μ = 0.3) body W2 is a surface What should be the weight of W1 that will cause it to start? W2= 26 [kN]sin45=cos45=0.7
Consider a hydraulic jack being used in a car repair shop, as in the figure. The pistons have an area of Ap= 0,8 cm? and A= 0.04 m2, Hydraulic oil with a specific gravity of 0.870 is pumped in as the small piston on the left side is pushed up and down, slowly raising the larger piston on the right side. A car that weighs 13,000 N is to be jacked up. At the beginning, when both pistons are at the same elevation (h= 0), calculate the force F+ in newtons required to hold the weight of the car. 1. What height of mercury column will cause a pressure of 680 kPa? Use sg of mercury equals to 13.6 2. Determine the pressure in a vessel of mercury, specific gravity 13.6, at a point 20 cm below the surface. Express the answer in kN/m2.
The differential manometer shown in figure 4 is used to measure pressure difference between pipe A and B. Pipe A is conveying water while pipe B is conveying air. If the pressure at B is 12kPa calculate the pressure at A. Figure 4. (a) 35kPa (b) 12kPa (c) 23kPa (d) 24kPa