Q2- What is the magnitude of the potential difference across the 20-2 resistor? 10 (2 11 V 10 22 a. 3.2 V b. 7.8 V C. 11 V d. 5.0 V e. 8.6 V 5.092 www 2002 10 (2

Q: 1. Sketch the output waveform for the following: a.) + 1kQ2 +8 V Si V₂ 4 V -8 V 16

A:

Q: 1. Using KCL, write the write the expression ²3↑ V3 a V4 + Vs Is Vs+ V1_ is 16 d 2. Using KVL. Write…

A:

Q: 1. A wye-connected load with ZA= 12 /45, ZB= 15 / 30 and Zc= 10 /0 is connected to a four-wire, 208…

A:

Q: Question 3: For the electrical network shown in Figure 3, solve the following: i) Sketch the…

A: To sketch the frequency response of the system. To Determine the output yt given the system is…

Q: RF carrier 10 KV at 1 MHz is amplitude modulated and index is 0.6. Peak voltage of the signal is?…

A: Given: Amplitude modulated carrier voltage, Vc=10 kV Modulation index, μ=0.6 Peak voltage of the…

Q: Q1): For the circuit shown in fig.(1), the switch moves from position a to position b at t=0, by…

A: Given: Switch moves from position A to B. Required: Current i(t) and vL(t) using Laplace transform…

Q: Task 1 Students are required to do a calculation using nodal analysis and mesh analysis for the…

A: Given here a electrical circuit and asked to find nodal voltages and mesh currents.

Q: Q2:.For the four pole filter, determine the capacitive values required to produce a critical…

A: Filters are circuits that allow signals of varying frequencies to pass through.  The cutoff…

Q: At 50Hz operation a single phase transformer has eddy current loss of 100 W, Its eddy current loss…

A:

Q: Problem 3 Find the overall susceptance across terminal a-b when Vs = -2 sin(4t + 310°) V. ΖΩ 4 H ΖΩ…

A:

Q: . Compute the value of C which results in resonance for the circuit shown below wher f=2500/pie Hz…

A: In this question,  We need to determine the value of capacitance C  If resonance frequency = 2500/π…

Q: The frequency of emf in the stator of a 4 pole, 3 phase induction motor is 50 Hz and that in the is…

A: In this question we will find slip and speed of motor....

Q: Example 5.1 A LPF circuit consisting of a resistor of 2 k in series with a capacitor of 0.1uf is…

A: A LPF circuit consisting of a resistor of 2 k in series with a capacitor of 0.1uf is connected…

Q: A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulating frequencies equal to…

A: Given, Carrier wave of frequency, fc=2.5 GHz Modulated with two modulating frequency, 1 kHz and 2…

Q: H.W z²+z X(z)= 3 (2-1) ³² (2-²)

A:

Q: R1 ww m degree V R2 sine Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and…

A:

Q: (2) An 8 bit successive approximation analog to digital converter has full scale reading of 2.55 V…

A: For the given 8 bit successive approximation ADC we need to calculate the conversion time for 2 volt…

Q: 0.45 +1 A unity feedback control system has G(s)=- S(S+ 0.6) a) Time response specification and time…

A:

Q: Q4) a Design a 4 input averaging amplifier.

A:

Q: Sketch the Output waveform for the following

A: Sketch the Output waveform for the following circuit :   We know:For Si diode:VDon=0.7 Volt…

Q: Q1. For the forward transfer function plot the root locus K 15² +1$+$ G(s) = Ls+b s(s+3)(s+6) 154…

A: Given,For a unity feedback control system,The forward transfer function is,Gs=Kss+3s+6

Q: Find the fourier transform for x(t) = d/dt[u(t-3)-u(-t-3)]

A: It is given that: xt=ddtut-3-u-t-3

Q: A coil of resistance 20hms and inductance 200uH is in parallel with a variable capacitor. The…

A: The value of capacitor can be calculated by using the frequency of resonance and the current can be…

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

A: Given voltage and current equations and asked to find the RMS value of voltage and average power…

Q: A 12-stage impulse voltage generator has a capacitor C. The wave front resistance equal to 0.6kΩ and…

A: n= 12 Wave front resistance, R1 =0.6 kilo-ohm = 600 ohm Wave tail resistance, R2 =7019 ohm Wave…

Q: The phase angle of the system G(S) = (a) 0° and 90° (b) 0° and -90° s+5 ; varies between S²+8s+9 (c)…

A: In this question,  We need to choose the correct options What is variation of angle of given system.…

Q: - A shunt generator gave the following results in the O.C.C test at rated speed 2 3. 4 6 8 10 Field…

A:

Q: Balanced 3 Phase Supply CC PC S B A NB N The 3-phase load consumes a totál power of 42 kW at 0.4…

A:

Q: thyristors. What will be the firing angle of the thyristors when a load has 67% of its maximum…

A: In single phase ac voltage controller circuit consists of two thyristors are connected in anti…

Q: H.W: Determine the response for the following system. and find ess and Tsystem. VL)=2464) | K=10₂…

A:

Q: In the given electrical circuit, the resistance R(in 2) required to deliver the power of 96 kW to…

A: Given circuit, Power deliver to 15 Ω resistor, P15Ω=96 kW

Q: /losz resistance in parallel with 5011 Capacitance the Current throgh the Capacitar is: (c(+) = 2…

A:

Q: A // water treatment plant is used to process 30000 m²/d. The rapid mixing tank is to have a…

A: Given data, The Volume of the tank is 30000 m3/d  Detention time is 1 min The value of the G is…

Q: The frequency and waveform of a digital signal is best determined using which of the following…

A: The spectrum analyzer measures the size of the input signal compared to the frequency within the…

Q: In an Amplitude Modulated (AM) wave with 100% modulation (ma), the carrier is suppressed. The…

A: Given, In an AM wave with modulation, ma=100%=1

Q: A. The i(t) though a 24 mH inductor is shown in Fig. 2.2a. Find and plot v(t) and the energy stored…

A: The voltage across the inductor can be calculated by using the general expression and the waveform…

Q: The frequency of the supply to the stator of a 4-pole induction motor is 60 Hz and the rotor…

A: Speed is calculated as given below

Q: -A 6-pole, wave-wound a long-shunt compound generator delivers a load current of 50 A at 500V and…

A:

Q: c) For the circuit shown in fig.(3), the supply voltage is v(t) = 50+ 40 sin(wt) + 30 sin(3wt-30) +…

A: In this question we need to find power factor of the given circuit

Q: Q2-100 KVA, (6600/330) ,single-phase transformer, the primary connected to supply voltage 100 V and…

A:

Q: Design synchronous 3-bit up counter with the following sequence 0, 1, 3, 4, 5, 7, 0 by using J-K…

A:

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

A:

Q: Q1) For the circuit shown in fig.(*), the supply voltage is v(t) = 50+ 40 sin(wt) + 30 sin(3wt-30) +…

A: In this question we need to find a power factor of the given circuit.

Q: Example 4.6: A varactor has a maximum capacitance of 80 pF and is used in a tuned circuit with a 100…

A: Given data,  Capacitance (C) =80pF  Inductor (L) =100μH

Q: Q. Determine the binary output code of a 3-bit flash ADC for the analog input signal in figure…

A: Given analog signal      For this analog signal the corresponding binary output is deduced in below…

Q: A 40 - Ω resistor is connected in series to a parallel combination of a 60 - Ω resistor and a 30 - Ω…

A:

Q: 1. Calculate the power gain in decibels for each of the following cases. a. Po 100 W, P₁ = 5 W.

A: Given, Output power, Po=100 W Input power, Pi=5 W

Q: Question 3: Find the total response of the system described by the following differential equation…

A: Given here an equation and asked to find the total response.

Q: B-Given the Fourier transform X(f) of x(t), How would you obtain Fourier transform of x² (t)?

A: In this question we need to discuss how to calculate Fourier transform of the given signal.

Q: 21: Assume that V is a function of y and at y =2, V=5 volt and at y = 4, V = 10 volt. a) Fi. cis. 30…

A: Given data, ρν = 30μcm3      εr = 3

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.