Q2. Determine all forces acting on body A for the system shown infigure 2. Body A weighs 200 N and the cylinder B weighs 50 N. assumeall the contact surfaces are smooth.24ringCable7r= 0.5 m30A0.5 mB2 m1 m30Figure (2)

Given that: WA=200 N WB=500 N We need to determine all forces acting on A in the given diagram:

Answered: Q2. Determine all forces acting on body…

Q2. Determine all forces acting on body A for the system shown in figure 2. Body A weighs 200 N and the cylinder B weighs 500 N. assume all the contact surfaces are smooth.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter4: Dynamics: Force And Newton's Laws Of Motion

Section: Chapter Questions

Problem 11CQ: (a) Give an example of different net external forces acting on the same system to produce different...

See similar textbooks

Similar questions

What can you say about the velocity of a moving body that in dynamic equilibrium? Draw a sketch of such a body using clearly labeled arrows to represent all external forces on the body.
A weight lifter stands on a bathroom scale. He pumps a barbell up and down. What happens to the reading on the scale as he does so? What If? What if he is strong enough to actually throw the barbell upward? How does the reading on the scale vary now?
1. A 0.540-kg bucket rests on a scale. Into this bucket you poursand at the constant rate of 56.0 g/s. If the sand lands in thebucket with a speed of 3.20 m/s, (a) what is the reading of thescale when there is 0.750 kg of sand in the bucket? (b) What isthe weight of the bucket and the 0.750 kg of sand?Explain and labled.
2. Barry carries his tray of food to his favorite cafeteria table for lunch. The 0.50 m long trayhas a mass of 0.20 kg and holds a 0.40 kg plate of food 0.20 m from the right edge.Barry holds the tray by the left edge with one hand, using his thumb as the fulcrum, andpushes up 0.10 m from the fulcrum with his finger tips.a. How much upward force must his finger tips exert to keep the tray level? b. How might Barry make the tray easier to carry if he chooses to use only one hand?
A 0.540-kg bucket rests on a scale. Into this bucket you poursand at the constant rate of 56.0 g>s. If the sand lands in the bucketwith a speed of 3.20 m>s, (a) what is the reading of the scale whenthere is 0.750 kg of sand in the bucket? (b) What is the weight ofthe bucket and the 0.750 kg of sand?
1. During a rescue operation, a 5300-kg helicopter hovers above a fixed point. The helicopter blades sendair downward with a speed of 62 m/s. What mass of air must pass through the blades every second to produce enough thrust for the helicopter to hover?Explain and labled.
Understanding the details of timing and forces in motion can improve the performance of athletes, including dancers. Consider the forces involved in a ballet jump called a sauté demi plié. P9.84a shows the sequence of moves in the jump. The dancer starts upright, then quickly bends her knees, moving downward. After she reaches the bottom of this dip, she extends her legs, pushing herself upward. After this upward push, she leaves the ground, beginning a short period of time in the air. P9.84b is a slightly idealized graph of the net force on a 42 kg dancer executing this move. What is the approximate net impulse on the dancer, from the moment she begins bending her knees to the instant she leaves the floor?A. 15 kg • m/s2 B. 30 kg • m/s2C. 60 kg • m/s2 D. 90 kg • m/s2
Understanding the details of timing and forces in motion can improve the performance of athletes, including dancers. Consider the forces involved in a ballet jump called a sauté demi plié. P9.84a shows the sequence of moves in the jump. The dancer starts upright, then quickly bends her knees, moving downward. After she reaches the bottom of this dip, she extends her legs, pushing herself upward. After this upward push, she leaves the ground, beginning a short period of time in the air. P9.84b is a slightly idealized graph of the net force on a 42 kg dancer executing this move. At what time does the dancer reach the lowest point of her motion, when her speed is zero?A. 0.20 sB. 0.40 sC. Between 0.40 s and 0.70 sD. After 0.70 s
Understanding the details of timing and forces in motion can improve the performance of athletes, including dancers. Consider the forces involved in a ballet jump called a sauté demi plié. P9.84a shows the sequence of moves in the jump. The dancer starts upright, then quickly bends her knees, moving downward. After she reaches the bottom of this dip, she extends her legs, pushing herself upward. After this upward push, she leaves the ground, beginning a short period of time in the air. P9.84b is a slightly idealized graph of the net force on a 42 kg dancer executing this move. The sauté demi plié begins with a phase in which the net force on the dancer is negative. During this phase of the jump,A. The normal force of the floor on her is zero.B. The normal force of the floor on her is less than her weight but greater than zero.C. The normal force of the floor on her is equal to her weight.D. The normal force of the floor on her is greater than her weight.
DYNAMICS OR RIGID BODIES (PLEASE WRITE THE COMPLETE SOLUTION. PLEASE WRITE & DRAW THE COMPLETE SOLUTIONS WITH FBD LEGIBLY. NO LONG EXPLANATION NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.USE 9.81m/s2 or 32.2 ft/s2 for accelaration if necessary.)
Determine the magnitude of the force P required to maintain equilibrium for the system shown in Figure Q3a.
A cord passing over a pulley connects two masses, as shown, where m1 = 3.40 kg and m2 = 6.30 kg. Assume the pulley and surfaces are frictionless, and the cord is massless and does not stretch. a) What is the acceleration of each block? b) What is the tension in the cord?