Q#4: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to the atmosphere. The water level is 3 m above the outlet. The tank air pressure above the water level is 300 kPa (absolute) while the atmospheric pressure is 100 kPa. Neglecting frictional effects, determine the initial discharge rate of water from the tank. -Air

Q#4: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to the atmosphere. The water level is 3 m above the outlet. The tank air pressure above the water level is 300 kPa (absolute) while the atmospheric pressure is 100 kPa. Neglecting frictional effects, determine the initial discharge rate of water from the tank. -Air

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A hydraulic pump is required to deliver a flow rate of 1000 liters per minute with a discharge pressure of 20 bar. If the efficiency of the pump is 70%, determine the required power of the pump.
PAY ATTENTION TO THE QUESTION : What is the resulting flow rate in the system if three pumps are used in parallel? (a) 0.483 m^3/s (b) 0.364 m^3/s (c) 0.333 m^3/s (d) 0.563 m^3/s 1. The Head -flowrate curve for a centrifugal pump is given by: HP = 28 -30Q2 Where, HP is in meter and Q is in m3/s . This pump is used to pump water for a system with the following (H-Q) curve: HS = 8 + 150Q2 Where, HS is in meter and Q is in m3/s . IT SAYS : if theee pumps are used in parallel PAY ATTENTION Multiple choice choose correct answer
Solve energy balance problems for common steady-flow devices such as nozzles, compressors, turbines, throttling valves, mixing chambers, and heat exchangers.
1) Interpret solar power in the context of environmental impact.2. What is the rigid dichotomy between windmill and diesel-driven pumps?3. For a normal windmill-driven pump at 3 m/s wind speed, the yield at a 10 m Head is typically 0.12 liters/s per m2 of rotor area, value windmills in the context of yield.
Water from a reservoir is pumped over a hill through a 450 mm diameter and an absolute pressure of 1.0 kg/cm^2 is maintained at the summit. Water discharge is 30 m above the reservoir. The quantity pumped is 0.5 m^3/s. frictional losses is discharge and suction pipe, and pump is equivalent to 1.5 m. The speed of the pump is 800 rpm. Determine the following: A. Water power of the pump B. New value of discharge if the speed of the pump is increased to 1000 rpm C. New value of head if the speed of the pump is increased to 1000 rpm D.New value of power if the speed of the pump is increased to 1000 rpm
a fan draws 1.42m3 per second of air at a static pressure of 2.54 cm of water through a duct 300 mm diameter and discharges it through a duct of 275 mm diameter. Determine the static fan efficiency if total fan is 75% and air is measured at 25 degree celsius and 760 mm Hg
A centrifugal pump rotates at n. = 750 rpm. Water enters the impeller normal to the blades (?1 = 0°) and exits at an angle of 35° from radial (?2 = 35°). The inlet radius is r1 = 12.0 cm, at which the blade width b1 = 18.0 cm. The outlet radius is r2 = 24.0 cm, at which the blade width b2 = 16.2 cm. The volume flow rate is 0.573 m3 /s. Assuming 100 percent efficiency, calculate the net head produced by this pump in cm of water column height. Also calculate the required brake horsepower in W
The Head -flowrate curve for a centrifugal pump is given by: HP = 28 -30Q2 Where, HP is in meter and Q is in m3/s . This pump is used to pump water for a system with the following (H-Q) curve: HS = 8 + 150Q2 Where, HS is in meter and Q is in m3/s . What is the resulting flow rate in the system if three pumps are used in series? (a) 0.56 m^3/s (b) 0.48 m^3/s (c) 0.33 m^3/s (d) 0.36 m^3/s HINT: what is the resulting Flow-rate in the system if three pumps are used in series ? Choose correct option above
At the bottom of a pressurized water tank is a mouth with a diameter of 5 cm, where water is discharged into the atmosphere. The water level is 2 m above the outlet. The tank air pressure above the water level is 300 kPa (absolute) and the atmospheric pressure is 100 KPA. Determine the initial rate of water discharge (volumetric flow rate) from the tank, neglecting the effects of friction.
4. Air flows isentropically through the channel To = 300 ° C. both ends have an identical area that is A = 25 cm², pressure p1 = 120 kPa and p2 = 60 kPa. Determine : a). Mass flow rate, b). Throat area C). Ma2
A reaction turbine works at 450rpm under a head of 120m.its diameter at inlet is 1.2m and the flow area is 0.4m^2.The angles made by absolute and relative velocities at inlet are 20°and 60° respectively with the tangential velocity. Determine i) the volume flow rate ii) the power developed iii) the hydraulic efficiency
A Francis turbine rotates at 1600 rpm and a flow rate of 1 m3/sec enters it. The inlet and outlet diameters are 1.2 m and 0.55 m, respectively, and the corresponding sections between the blades are 0.24 m2 and 0.08 m2. The outlet angle of the water from the distributor is 10º, the outlet angle of the wheel b2 = 40º and the manometric efficiency of the turbine is 78%.Determine:a) The net jumpb) The torque and power on the shaft