Question 1: Using a well-known protein estimation technique, absorbance reading for a set of standards were obtained. You were required to plot the data. Which graph would you use? Plot the data using the graph type. Protein concentration Absorbance (a.u.) (mg/mL) 0.01 2 0.05 0.12 10 0.25 25 0.63 50 1.25 Question 2: Enzymes are biological catalysts and perform important biochemical reactions in the body. A group of scientists discovered a new enzyme – Enzyme X. To understand the working of this enzyme, they performed biochemical assays to assess the activity of the enzyme. The results for which are shown in the table below. Based on the information provided in the table, please state which graph would you use? Plot the data using the graph type. Enzyme activity (%) 35 pH 3. 55 68 79 98 8. 85 9. 20 10 4667 coa

Question 1: Using a well-known protein estimation technique, absorbance reading for a set of standards were obtained. You were required to plot the data. Which graph would you use? Plot the data using the graph type. Protein concentration Absorbance (a.u.) (mg/mL) 0.01 2 0.05 0.12 10 0.25 25 0.63 50 1.25 Question 2: Enzymes are biological catalysts and perform important biochemical reactions in the body. A group of scientists discovered a new enzyme – Enzyme X. To understand the working of this enzyme, they performed biochemical assays to assess the activity of the enzyme. The results for which are shown in the table below. Based on the information provided in the table, please state which graph would you use? Plot the data using the graph type. Enzyme activity (%) 35 pH 3. 55 68 79 98 8. 85 9. 20 10 4667 coa

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter28: Atomic Spectroscopy

Section: Chapter Questions

Problem 28.15QAP

See similar textbooks

Similar questions

Predict relative intensities at m/z 34, 35, and 36 for H2S. Let the intensity of the molecular ion be 100 and disregard contributions ,0.1%.
Calculate the concentration of a solution of peptide AWSME, in mM if the absorbance at 280 nm for the solution is 0.6 absorbance units, and a 0.2-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1. Round your answer to two decimals.
Calculate the absorbance at 280 nm that is expected for a 17 microM solution of peptide GRAYISH, if a 10-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1.
Describe the mechanism of end point detection by EBT.
(a) A sample of body serum is to be analysed for sodium by flame emission spectroscopy. 1.00cm3 aliquot of serum was pipetted into each of two 50.0 cm3 volumetric flasks. The firstflask was diluted to volume with deionised water. The absorbance of this first solution was0.350. To the second flask 10.0 cm3 of a 25.0 ppm sodium standard was added and theflask made up to volume with deionised water. The absorbance of this second solution was0.720.(i) Calculate the concentration of the sodium in the body serum in mg dm–3
i) Find the differences between the AES and XPS in terms of principle and information obtained from the spectra. ii) Why AFM is mostly utilized microscopic method for the determination of the thickness of the film?
The following calibration data were obtained by an atomic absorption spectrophotometric (AAS) method for the determination of mercury in an herbal product. (show complete solution) 1. What is the detection limit for the method? 2. What is the limit of quantitation for the method?
You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0 0.225 1 0.310 2 0.420 3 0.510 4 0.610 5 0.720 6 0.810 7 0.915 8 0.950 9 0.980 10 0.990 After blanking against a bradford-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.523 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
Predict relative intensities at m/z 36, 37, and 38 for HCl. Let the intensity of the molecular ion be 100 and disregard contributions ,0.1%.
Give a detailed explanation of how Raman spectroscopy protocol will be used to process a sample of palm oil adulterated with Sudan IV
I extracted caffeine by using chloroform and magnesium sulfate to dehydrate the organic phase. I got crude caffeine just by solvent evaporation at room temperature. However, I wanted to conduct Raman spectroscopy measurements but I did not get the characteristic peaks. I think that it has to be whit chloroform presence. So I let the crude caffeine 24h at 65 degrees but still I did not get any peak. What can I use to rinse my crude caffeine extract to remove all chloroform molecules? Or what is wrong with my extraction?
a) How does mass spectrometry identify organic compounds? b) Describe the use and function of Quadrupole Analyzers ? c) One of the ionization sources for atomic mass spectrometry (MS) is Inductively Coupled Plasma (ICP). Explain the need for an interface in the ICPMS instrument and how can it be achieved.