Question 5. New April 19, 2021.a. Suppose that after delivery several drops of the water cling to the inner wall of the pipet(because the pipet wall is dirty). How does this technique error affect the reporteddensity of water?. See drawing at right.b) The mass of a beaker is 5.333 g. After 5.00 mL of spearmint oil is pipetted into thebeaker, the combined mass of the beaker and the spearmint oil sample is 9.962 g. Fromthe data, what is the measured density of spearmint oil in g/mL?

a). Assume this is some experiment to measure the density of water perhaps by weighing a known…

Question 5. New April 19, 2021. Suppose that after delivery several drops of the water cling to the inner wall of the pipet (because the pipet wall is dirty). How does this technique error affect the reported density of water?. See drawing at right.

Question 5. New April 19, 2021. Suppose that after delivery several drops of the water cling to the inner wall of the pipet (because the pipet wall is dirty). How does this technique error affect the reported density of water?. See drawing at right.

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter20: Electrochemistry

Section: Chapter Questions

Problem 9STP

See similar textbooks

Similar questions

Collect and give the specifications of natural gas pipeline
A 1.06 den silk fiber has reached its maximum tenacity value. How many grams (force) would it take to rupture such fiber when dry?
Actual volume of water delivered by pipet and Percent error in volumetric pipet
Please show the proper calculation of the above answer how 17.72% as it creates a lot of confusion please show step by step calculation
The chlorine content of a pool with a capacity of 1.80×104 L was discovered to be 0.00145% by mass, which is well below the sanitary level of 0.00305%. How much chlorine needs to be added in order for the pool to meet the health regulation standard of 0.00305%? First draw a flowchart, then given that the pool consists of fresh water and chlorine, write the total mass (or alternatively chlorine mass) and fresh water balance equations, and then calculate the mass of chlorine in grams that needs to be added to the pool. Assume that the density of the pool water is the same as that of fresh water (1.00 kg/L), the pool is filled to its rated capacity (1.80×104 L), and that the required chlorine can be added to this capacity.
The mystery fuel speedster! (Homework ) For fun, you build an explosive car with your little brother by attaching wheels to an empty windshield washer container. To advance it, you add 1.20 ml ( = 0.7915 g/ml) of a liquid but volatile fuel into the container. You close the cap and shake to evaporate the liquid. Finally, you place the car on its wheels, remove the cap and insert a burning wooden rod into the container. A flame suddenly comes out of the car, which is propelled with good speed in front of your little brother surprised, but all upset by the maneuver. The volatile fuel is composed of 37.5% carbon, 12.6% hydrogen and 49.9% oxygen. Its molar mass is approximately 32.0 g/mol. During the reaction, the fuel (gaseous) burns in the presence of gaseous oxygen, and the products of the reaction are carbon dioxide and water, gaseous too. The volume of the windshield washer container used is 4.00 litres. Useful Info: There is 21.0% gaseous oxygen in the air and initial conditions…
Read the Limit Test for salicylic acid in aspirin below then answer the question below. Remember: Aspirin = acetyl salicylic acid (ASA), and salicylic acid = SA Limit Test for salicylic acid: Extract powdered Aspirin tablets (i.e., active + excipient) containing 0.4g acetylsalicylic acid (i.e., active) with 4 mL of 95% ethanol. Add water to give a final volume of 100.0 mL and mix. Transfer 50.0 mL of the filtrate to a Nessler Cylinder and add 1.0 mL of acidified ferric ammonium sulfate solution. Mix and allow to stand. Prepare the standard solution used for comparison as follows: To another Nessler Cylinder add 3.0 mL of freshly prepared 0.01% (wt/vol) salicylic acid, 2.0 mL of ethanol, 1.0 mL of acidified ferric ammonium sulfate solution and sufficient water to give a total volume of 51.0 mL. Mix. A violet colour produced by the sample should not be more intense than that of the standard, used for comparison. Example of "Limit" calculations: Based on the above limit test, the…
Concentration of a Sodium Chloride Solution Complete the following table as directed: Do not include units Report answers with the appropriate number of significant digits Do not use scientific notation Mass of empty evaporating dish (g) 29.625 Volume of NaCl solution (mL) 9.8 Mass of dish and NaCl solution (g) 40.307 Mass of dish and dry NaCl (g) 30.949 Mass of NaCl solution (g) ?????? Mass of dry NaCl (g) ????? Mass/mass percent (%) ?????? Mass/volume percent (%) ????? Moles of NaCl (mol) ?????? Volume of NaCl solution in liters (L) ?????? Molarity of NaCl solution (mol/L) ?????? (Concentration Calculations Guide)1. Calculate the mass of the NaCl solution as2. mass of NaCl solution=mass of dish with solution − mass of empty dish 3. Calculate the mass of dry NaCl as4. mass of dry NaCl=mass of dish with dry NaCl − mass of empty dish 5. Calculate the mass percent of the solution by dividing the mass of dry NaCl by the mass of NaCl solution and multiplying by 100.6. mass percent…
Suppose that you are closing a cabin in the north woods for the winter and you do not want the water in the toilet tank to freeze. You know that the temperature might get as low as 30. C, and you want to protect about 4.0 L water in the toilet tank from freezing. Calculate the volume of ethylene glycol (density = 1.113 g/mL; molar mass = 62.1 g/mol) you should add to the 4.0 L water.
In an accident, a solution containing 2.5 kg of nitric acid was spilled. Two kilograms of Na2CO3 was quickly spread on the area and CO2 was released by the reaction. Was sufficient Na2CO3 used to neutralize all of the acid?
(For Exercises 4546) Solutions containing nickel(II) ion are usually bright green in color. When potassium hydroxide is added to such a nickel(II) solution, a pale-green fluffy solid forms and settles out of the solution. The fact that a reaction takes place when potassium hydroxide is added to a solution of nickel(II) ions is an example of a properly. . The fact that a solution of nickel(II) ion is bright green is an example of a property.
It is important to rinse the cylinder with water and a small amount of the second reactant before measuring the volume of the second reactant. Explain why this is important to do for this investigation