When the diffusion test is performed in the setup in the figure, a white smoke is formed at point B after 40 s. Calculate the experimental error since the length AB is 30 cm and the length AC is 50 cm. (N: 14 g / mol , Cl: 35.5 g/ mol, H:1 g/ mol) NH C

When the diffusion test is performed in the setup in the figure, a white smoke is formed at point B after 40 s. Calculate the experimental error since the length AB is 30 cm and the length AC is 50 cm. (N: 14 g / mol , Cl: 35.5 g/ mol, H:1 g/ mol) NH C

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter8: Properties Of Gases

Section8.7: Kinetic-molecular Theory And The Velocities Of Gas Molecules

Problem 8.17E

See similar textbooks

Related questions

Q: Dry ice, solid CO2 (s), can be made by allowing pressurized CO2 (g) to expand rapidly. If 36% of the…

A: Given data: Volume (V) = 6.8 ft3…

Q: Cell A has a surface area of 50 um? and a volume of 10 um. Cell B has a surface area of 14 um and a…

A: For the cell A, the SA:V is calculated as shown below. For the cell A, the SA:V is 5μm-1.

Q: A small crystal of potassium permanganate (orange) and methylene blue (blue crystal) are placed on…

A: The Methylene Blue is more complex, heavy.

Q: A 0.200-dm sample of H2 is collected over water at a temperature of 298.15 K and at a pressure of…

Q: What is the root-mean square speed of nitrogen molecules at 300.0 K in meters per second? Select…

A: Answer: Root mean square speed of gas molecules is: Vrms=3RTMHere:R= universal gas constantM=molar…

Q: If a small box contains 1.5×1012 molecules per cubic centimeter for methane gas, a temperature of…

A: Interpretation - To determine the partial pressure of methane gas when box contain 1.5 × 10 12…

Q: A 0.55 g sample of a certain metal reacted with acid to liberate 375.0 mL of hydrogen gas when…

Q: A sample of benzoic acid is contaminated with methyl red, a compound that is soluble in cold water.…

A: Gravity filtration only runs from the help on gravitational force , so no other external stimuli is…

Q: CAN YOU FIND THE VISCOSITY ENERGY FOR ACETONE ? VISCOSITY 1 VALUE = 0.797 VISCOSITY 2.VALUE=…

A: In the given question we have to calculate the viscosity energy for acetone by using the Arrhenius…

Q: The following are used to remove bubbles in the mobile phase, except: Ultraviolet Vacuum Pumps…

A: Answer = EXCEPT (Ultraviolet Vacuum Pumps) Are not used for remove bubbles in the mobile phase,

Q: 20 - What is the diffusion rate of CH4 gas at 227 °C m.s-1? (H: 1, C: 12, R: 8 JK-1.mol-1) O A) 866…

Q: the pressure at the bottom of the Mariana trench is 950 atmospheres, choose the best answer for the…

A: Units and conversions 1 atmosphere=14.6959488 Psi units so 950 atmosphere ........? Psi units =950…

Q: The time of diffusion of an ideal is ___________ to the square root of density. directly…

A: Graham's law of diffusion gives the relationship between rate of diffusion of an ideal gas with…

Q: The Molecular Weight of an unknown liquid is determined using the Dumas Method. The following data…

Q: Which of these graphs allows you to determine your CMC? CMC CMC In(concentration) Concentration…

A: The CMC is an important characteristics of surface tension. The surface tension changes strongly…

Q: Determine the number of Frenkel defects per cubic centimeter of a metal chloride at 40 deg Celcius.…

Q: A helium balloon is used to lift a load of 110 N. The weight of the balloon cover is 50 N and its…

A: Given that: Helium balloon used to lift weight = 110 N Weight of balloon cover = 50 N Volume = 32 m3…

Q: What is the evaporation rate of liquid A given the following data? (°C/s). Temperature (°C) Time (s)…

Q: absorbance data that you have obtained while doing an experiment studying the diffusion of potassium…

A: A numerical problem based on quantitative analysis, which is to be accomplished.

Q: 2. How will you be able to tell that your liquid sample is completely vaporized? How long will it…

A: 2. We can tell that a liquid is completely vaporized when no more liquid is left or wets the surface…

Q: Calculate the volume of the flask using the mass of water which filled the flask and the density of…

Q: 1og of ice at D2 is mixed With H20 at 58°2? Find t, :."

A: The heat capacity is the ratio of the energy supplied in the form of heat to the rise in the…

Q: The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 Calculate a) The mean path in…

A: Solution -

Q: 006 008 00L 009 00s 00t 00€ 007 00L 007- Pressure (atmospheres)

A: A question based on phase diagram that is to be accomplished.

Q: Pictured is a closed-end manometer filled with mercury. If four different closed-end manometers…

A: Since the sample of gas and the properties of tube are same. Hence the pressure of gas will also be…

Q: :Q9: The defects importance are Improving chemical properties of the material Enhancing mechanical…

A: defects often determine properties of material. Defects can change physical properties of material…

Q: An oil barrel at 4500 psi and 160 °F has been exposed to the standard conditions. a. Oil expand or…

A: We are given with tempreture and pressure. Consider the standard tempreture and pressure. And to…

Q: Complete the following table with the necessarv data P1 P2 V2 4 800 mL 500 kPa 160 mL 0.040 atm 250…

A: Given that : We have to complete the following table :

Q: What is the apparent hard-sphere diameter of CO2 at 0°C? The viscosity of CO2(g) at 1 atm and 0°C is…

Q: A constant volume of nitrogen is heated from 10 celcius to 85 celcius. The initial preassure is 1.5…

A: Initial pressure, P1 = 1.5 atm Initial temperature, T1 = 10 ∘C = 283 K Final pressure, P2 = ? Final…

Q: The test tubes shown here contain equal amounts of the specified motor oils. Identical metal spheres…

A: The motor oils in order of increasing viscosity are to be ranked and explained. Given: Viscosity is…

Q: B28 Asoap bubble whose radius is 12 mm becomes attached to one of radius 20 mm. Calculate the radius…

Q: Determination of the Surface Tension of a Liquid by the Capillary Rise Method: A group of students…

Q: The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 poise. Calculate the mean path in…

Q: how do you do the calculations for rate of diffusion for this table

A: A question based on general chemistry that is to be accomplished.

Q: The densities of sulfur dioxide at several temperatures are as follows: t°C 132 145.2 151.7 156.1…

A: A question based on properties of gases that is to be accomplished.

Q: red in a 2.15L flask. g/

A: Density of the gas = ( mass / volume ) Density = ( 3.35g / 2.15 L ) Density = 1.56 g/L ( Answer )

Q: ligh-pressure liquid chromatography (HPLC) is a method used in chemistry and biochemistry to purify…

A: the explanation is given below

Q: The absolute pressure is 2.50 bars. What is the gauge pressure in kPa? (write your answer up to 3…

A: Since, 1 bar = 100 kPa then,

Q: 10. The figure shows a water tank with a valve. If the valve is opened, what is the maximum height…

A: Given : Height = h = 10.0m Length = L = 2.00m Angle in degree = θ =…

Q: Which of the critical constants is least accurately known? O Vm,c O Tc O Pc

A: The three critical constants which are critical pressure (Pc), critical temperature (Tc) and…

Q: 34 - What is the diffusion rate of CH4 gas at 227 °C m.s-1? (H: 1, C: 12, R: 8 J K-1.mol-1 O A) 26…

A: The diffusion rate of gas means root mean square velocity of gas , because rate according to kinetic…

Q: Calculate the height in meters of a column of liquid glycerol (d = 1.26 g/cm3) required to exert the…

A: Pressure will remain same then we can write dHg×g×hHg = dalc×g×halc Where dHg = density of mercury g…

Q: 4. If a monolayer of N2 molecules is 0.03075 mole per one gram of activated carbon, and the surface…

Q: State which particle sizes are more important with respect to alveolar deposition and why. • Explain…

A: Everyday a large no of particles are inhaled through air.Many of this particles are deposited in the…

Question

Help pls

88
ㅇ
...
When the diffusion test is
performed in the setup in the
figure, a white smoke is formed
at point B after 40 s. Calculate
the experimental error since the
length AB is 30 cm and the length
AC is 50 cm. (N: 14 g/ mol, Cl:
35.5 g / mol , H:1 g/ mol)
NH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

A 2.000 gram sample containing graphite (carbon) and an inert substance was burned in oxygen and produced a mixture of carbon dioxide and carbon monoxide in the mole ratio 2.00: 1.00. The volume of oxygen used was 747.0 milliliters at 1,092K and 12.00 atmospheres pressure. Calculate the percentage by weight of graphite in the original mixture.
If the initial pressure of the air in the flask was 0.985atm at 298.15k what would the corrected pressure of the air be at 327.76K. For a given liquid a plot of the lnP versus 1/T gives a straight line with a slope of -5199k. What is the Hvap of this liquid?
Provide the remaining data missing
A tanker truck carrying liquid ammonia overturns, releasing ammonia vapor into the air.(a) Approximating ammonia, oxygen, and nitrogen asspheres of equal diameter (3 × 10-10 m), estimate the diffusion constant of ammonia in air at atmosphericpressure and 20°C.(b) Calculate the time required for a 100-m root-meansquare displacement of ammonia from the truck, andexpress this time in everyday units (seconds, minutes,hours, days, or years). The actual time for the ammonia to travel this distance is far shorter because of theexistence of air currents (even when there is no wind).
At sea level, where the pressure was 104 kPa and the temperature 21.1 °c. a certain mass of air occupied 2.0 m3. To what volume will the region expand when it has risen to an altitude where the pressure and temperature are (a) 52 kPa, -5.0 oc. (b) 880 Pa, -52.0 °c?
Compute the volume percent of graphite VGr in a 3.8 wt% C cast iron, assuming that all the carbon exists as the graphite phase. Assume densities of 7.9 and 2.3 g/cm3 for ferrite and graphite, respectively. Answer in Vol%
Let's say you are interested in measuring the radiocarbon content of atmospheric CO2 in a relatively clean location. How large of an air sample (in liters) would you need to take to get a sample of 1 mg of carbon? Assume a mixing ratio of CO2 in of 415 ppm and that you are sampling under standard conditions of temperature and pressure (1 mol = 22.4 l).
In an experiment carried out at a temperature of 4700C and a pressure of 100 atmosphere, 4.3g of a volatile liquid produced 30.6cm3of the gas. Calculate the molar mass of the liquid. (Molar gas constant, R= 8.314JKmol, molar gas volume at stp = 22400cm3, 1 atmosphere= 1.0 x 10 Nm-2)
What is the diffusion coefficient of a membrane-bound protein of molar mass 79,300 daltons at 37°C if the viscosity of the membrane is 1 poise (0.10 N-s-m-2)? Assume that this protein is an unhydrated, rigid sphere that has a density of 1.4 g-cm-3. 4.0 8.05e-12 x m².s-1 What is the average distance traveled by this protein in 2.3 s? 4.0 6.085e-6 x Å
The following is the van Deemter Equation. Explain briefly the parameters A, B and C and how they affect the hight of the theoretical plate (H).
1. What is the apparent hard-sphere diameter of CO2 at 0°C? The viscosity of CO2(g) at 1 atm and 0°C is 139 μP (micropoise). 2. When equal amounts of hydrogen, H2, and iodine, I2, are mixed together at a total pressure of 1 bar, the partial pressure of hydrogen iodide, HI, vapour produced from by the reaction H2(g) + I2(g) ⇌ 2 HI(g) is 22.8 kPa. Calculate the equilibrium constant for the reaction. 3. The equilibrium constant for the reaction 2HCl(g) + O2(g) ⇌ H2O(g) + Cl2(g) is 13300 at 400 K and 429 at 500 K. Use the van't Hoff equation to determine the standard enthalpy of reaction.
The diffusion rate for a solute is 4.0 × 10-11 kg/s in a solvent-filled channel that has a cross-sectional area of 0.50 cm2 and a length of 0.20 cm. What would be the diffusion rate m/t in a channel with a cross-sectional area of 0.30 cm2 and a length of 0.10 cm?