Actual volume of water delivered by pipet (Calculated from density formula) D- (Show set-up) 13. 24,371 mL 46.332 0.998203 Percent error in volumetric pipet (Show set-up) 24.824 0.998203 14.

Q: I need help in calculating the total mass of the unknown #2 sample of copper. The following chemical…

A: The given equations are: 2 Cu2+ + 4 I-  ----> 2 Cus + 2 I2  I2 + 2 S2O3-2 ----> 2 I- +S4O6-2…

Q: 2. The densities of Methane at °C were measured at several pressures with the following results:…

A:

Q: • Part A 190 mL of a 31.8 % (m/v) LINO3 solution Express your answer using two significant figures.…

A: The concentration can be expressed in the following ways: 1. Percent by volume (v/v) % = volume of…

Q: + A. Measurement of Liquid Equipment Measured Volume Actual Volume 250 mL Beaker 100 mL 101 mL 125…

A:

Q: What is the volume reading of the liquid in the graduated cylinder? * -40 -35 -30 -25 -20 a)36.50 +…

A: A graduated cylinder is used to measure the amount of liquid. It is never intended to heat or shake…

Q: • Part D Hg (1) + HgCl, (aq) → Hg,Cl2 (s) Express your answer using ftwo significant figures. ΑΣφ ?…

A: The given reaction, Hg(l)+HgCl2(aq) → Hg2Cl2(s)

Q: 24picometer to meter

A: The conversion of 24 picometer to meter is shown as follows, 1m = 10-12 The conversion factor to…

Q: Mention 3 products available on the market where its specific gravity must be measured

A: Given data :   Mention 3 products available on the market where its specific gravity must be…

Q: 1. Using the pictures in the below, record the volumes of water in the graduated cylinders with and…

A: We would read the volumes from each cylinder with and without rock . Then volume of rock is…

Q: Answer the following questions. _____1. Which of the ff you can use for mixing liquids? a) test tube…

A: 1) The tool which is used for mixing liquids is stirring rod. Therefore, the correct answer is…

Q: 1) determine the glassware that can be used to deliver 4.5mL with an absolute error: a) ≤ 0.15 mL…

A: Answer - Absolute error - The absolute value of the difference between an observed value of a…

Q: n. is the total mass of solid recovered? g is the percent composition of naphthalene in the initial…

A: A) 1.661gm B)21.06% C)15.73%

Q: Part 2: Obtain volume of a marble using volume by water displacement technique. 1. Using the…

A: It is given that the volume of the rock needs to be determined by water displacement method, this…

Q: STARTING AMOUNT X (0.01)³ * ( ) 1 0.076 0.1 (100)³ cm³ Convert 7.6 7.6 1000 m³ cm³ to (0.1)³ 0.01 cm…

A: In different fields of science, the dimensional analysis is used to determine the relation between…

Q: Least count of the balance 0.1 g   1 21.0 24.0   Mass of solid, reading 1 25 g   2 19.0 21.0   Mass…

A: Concept: Density = Mass/ Volume To complete the table using the given experimental data

Q: Test Tube Volume Volume of Water Added Syringe Reading (mL) V w Total Air Volume Trial (mL) V t (mL)…

A: Boyel's law : It states that the temperature always remains constant when the volume of given mass…

Q: 1. I. Press Tare II. Weigh container and sample II. Weigh container A) II, II, I B I, II, II c II, ,…

A: First  put  weigh container  on the balance then press tare button after that we will weigh both…

Q: Finding mass /volume/Tempeture with data collection

A: It is given that: Weight of empty 400 mL beaker = 143.018 g Weight of 30 mL beaker and test tube =…

Q: Density of a Liquid Material A dry 5-ml graduated cylinder weighs 52.2365 g. Into it was poured a…

A: A question based on measurement, which is to be accomplished.

Q: 4. For a constant head laboratory permeability test on sand, the following data were given: Length…

A: Hi thanks for the question

Q: Fill the table and create a publication quality graph of density vs % mass for solutions 5. Fit the…

A: Use the excel to draw the trendline graph- write the value of x and y axis select them , choose…

Q: Limitation of accuracy

A: A graduated cylinder can measure upto 1 mL for 100 mL cylinder and upto 0.1 mL for a 10 mL cylinder.…

Q: M: Table 1: Standardization Data Trial 1 Trial 2 Mass of KHP O145504 0.05ML 04536 12.3 mL Initial…

A: To calculate the Molarity of base, we would first check the mole ratio between base and KHP from the…

Q: Calculate the suspended solids in mg/L given the following data: Weight of crucible: 21.0256 g,…

A: Given,  Weight of crucible: 21.0256 g Weight of crucible and dry solids: 21.0301 g Weight of…

Q: If water weighs 1000 kg per cubic meter, determine the total weight of th water that a 1-meter…

A: The radius of cylindrical tank is 0.5 m. The volume of a cylinder is calculated using the following…

Q: "unknown C run #1" 1 1 C: \Bruker\Topspin4.0.9 unknown C run #1 10 8 2 [ppm] 0000' 3.9217 z- 2

A:

Q: If the Day 2 filter paper was not left in the drying oven for long enough (i.e. the time specified…

A: Random error:  Random error in experiment measurements are caused by unknown and unpredictable…

Q: For question number 2 does that mean weigh the dish to 0.001g without clearing it ?

A: In step-1, after cleaning the evaporating dish properly, we have to heat to remove any impurities…

Q: A group of students were trying to experimentally determine the density of an unknown liquid. They…

A: The data given is, And the volume of the liquid = 5.00 mL.

Q: Estimated volume of crucible 25.0 mL  measured volume of crucible 23.0 mL  percent error of…

A: Percent error or percentage error expresses as a percentage the difference between an approximate or…

Q: You wait an empty glass filter on the balance and record a way of 12.4361 g. After a 1.00 L sample…

A: The weight of the TSS is calculated as shown below. wTSS=wtotal-wfilter

Q: PLEASE ANSWER ALL THE ITEMS. WILL GIVE YOU THUMBS UP AND GOOD RATING TRUE OR FALSE 1. The specific…

A: 1. The specific gravity bottle method can be used for both liquid and solid state. : True 2. The…

Q: Calculate the error and percent error

A:

Q: A patient result is greater than the linearity of the instrument. An off-line dilution needs to be…

A: Volume of patient sample = 100 micro Lit. Volume require for instrument = Sample + dead space   =…

Q: Can you give 5 laboratory apparatuses examples on each classifications?

A: A. Measuring type : In laboratory many measuring cylinder are used. These are used to measure liquid…

Q: Table 2: Part B- Using a Graduated Cylinder to Measure Volume Data: Trial 1 Trial 2 Trial 3 Leave…

A: Percent Error:-  It is basically the percent deviation from the actual value of the experimental…

Q: Quantity Standard Millimeter Mercury Cadnaen mm Hg) Torr atmosphere(atm) 1 Pascal( Pa) nienimateh sl…

A: Unit is defined as the quantity which has a fixed magnitude. Many units of a physical quantity are…

Q: Volume Initial (mL) | Calculate Volume change (mL) Trial Mass (g) Volume Final (mL) 1 53.458 16.3…

A:

Q: 2- Measuring the Mass of Liquids. Determination of the Density of a Liquid. Trial 2 Trial 1 Mass of…

A: Specific gravity is relative density, that is, density of sample divided by density of water…

Q: Date lab performed: Name: Date due: Partner(s) ame Measurements: Density of a Sallne Solution Data:…

A: 10 mL graduated cylinder is most accurate and 100 mL beaker is least accurate. In the 10 mL…

Q: Need help with question #24  Results  Trial 1 :  Initial Volume = 0 0.5143g=KHP 14.3 = Buret…

A: The stoichiometric reaction of KHP with NaOH is:                  NaOH + C8H5O4K →  C8H4O4KNa + H2O…

Q: Name: Date lab performed: Partner(s) name: Date due: Measurements: Density of a Salime Solutiom…

A: Density = mass/ volume

Q: 9 9 A. Cg Hg 03 00 ppm -N 200 180 160 140 120 100 com -9 O

A:

Q: Standardization of a Solution lab Discuss two possible sources of error for this experiment

A: The  question is based on the concept of titrations. We have to determine the possible sources of…

Q: Data and Observations: Data Table Mass Volume Solution A-1 6.30009 4,25009 5.00ML 5.00 ML Solution…

A:

Q: volume: mL

A: Molarity is defined as total number of moles of solute dissolved in 1000 ml of solution Molarity =…

Q: Class A 50 mL Burette Calibration Mass of Water Delivered, g Actual Volume Delivered, Burette…

A: For the actual volume delivered we will use the concept of density of water. We know that; Density…

Q: Mass of a 50 mL dry and empty beaker. Next, use a 10-mL graduated cylinder and transfer 5.0 mL of DI…

A: Given : mass of empty beaker = 29.90 g And mass of beaker + water = 34.96 g

Q: volume measure for the 90 drop data and calculate the volume for each drop of water.

A:

Q: Estimated volume of crucible 25.0 mL  measured volume of crucible 23.0 mL  percent error of…

A: % error=accepted value-experimental valueaccepted valuex100 %

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.