sample of normally consolidated clay was subjected to a consolidated undrained triaxial compression st that was carried out until the specimen failed at a deviator stress of 50 kN/m?. The pore water pressure at failure was recorded to be 20 kN/m2 and confining pressure of 50 kN/m² was used in the test. Determine the consolidated undrained friction angle o and drained friction angle gD:

sample of normally consolidated clay was subjected to a consolidated undrained triaxial compression st that was carried out until the specimen failed at a deviator stress of 50 kN/m?. The pore water pressure at failure was recorded to be 20 kN/m2 and confining pressure of 50 kN/m² was used in the test. Determine the consolidated undrained friction angle o and drained friction angle gD:

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter12: Shear Strength Of Soil

Section: Chapter Questions

Problem 12.20P

See similar textbooks

Similar questions

A consolidated undrained (CU) triaxial compression test is conducted on a normally consolidated clay at a confining pressure of 100 kPa. The deviator stress at failure is 80 kPa, and the pore-water pressure measured at failure is 50 KPa. The effective angle of internal friction (indegrees, up to one decimal place) of the soil is..?
Solve it quick? Triaxial test (CU) is performed on a clay for a confining pressure of 110 kPa. If the deviator stress and pore-water pressure were 70 kpa and 55 kpa respectively then determine the internal friction angle.
Consolidation of an undrained clay occurs at an effective pressure of 100 kPa and a shear stress of 40 kPa. The ratio of effective pressure to shear stress in drained clay is 2 to 1. If the shear stress at zero effective pressure, To, is 10 kPa, what is the pore water pressure at failure? A. 10 kPa в. 40 кра с. 53 кра D. 67 kPa
The stresses on a failure plane in a drained triaxial test on sand are as Follows: Normal Stress nf = 100 kN/m2 Shear Stress τf = 40 kN/m2 Required: a) Determine the angle of internal friction and angle of failure plane b) Find the major and minor principle stresses (1 , 3 )
A consolidated-drained triaxial test on a normally consolidated clay yielded a friction angle, Φ', of 28°. If the all-around confining pressure during the test was 140 kN/m2, what was the major principal stress at failure?
In a drained triaxial compression test, a saturated specimen of cohesionless sand fails at a deviator stress of 450 kN/m2 when the cell pressure was 135 kN/m2. Find the angle of inclination of the failure plane with the horizontal. Show diagram
A specimen of normally consolidated clay was consolidated under a chamber confining pressure of 280kpa for a drained test by how much does the axial stress have to be reduced to cause failure by axial extension?
A specimen of saturated sand was consolidated under an all-around pressure of 105kN/m2.The axial stress was then increased and drainage was prevented.The specimen failed when the axial deviator stress reached 70 KN/m2.The pore water pressure at failure was 50 KN/m2.Determine:i. Consolidated-undrained angle of shearing resistance, ɸii. Drained friction angle, ɸ′iii. Sketch Mohr’s circles and Failure Envelops in terms of total and effective stress.iv. Assuming soil specimen to be homogenous, sketch a network of failure planes.
A saturated clay layer (300cm in thickness) was sitting upon the rock, its unit weight was = 20kN/m3, an oedometer test also found that Cc = 0.2, Cr = 0.04. The existing vertical effective stressin the field is 200 kPa. Construction will increase the vertical stress at the centre of the clay by = 600 kPa.a) Calculate the primary consolidation settlement of clay layer if it has been subjected toa load at OCR = 2.b) Assume spatial variation of pore pressure u with time t and depth z is onedimensional,and governed by:where Cv is a given constant, specify its boundary and initial condition, and try toillustrate the pore pressure change with time along its depth.
A consolidated-drained triaxial test was conducted on a normally consolidated clay with a chamber pressure, σ3 = 276 kN/m2. The deviator stress at failure is = 276 kN/m2. Determine: a. The angle of friction b. The angle θ that the failure plane makes with the major principal plane c. The normal stress, σf, and the shear stress, τf, on the failure plane
The effective internal friction angle of a normal compacted clay is 33°, the triaxial test of this clay specimen is carried out, and the applied confining pressure is 115 kN/m2. (1) If the compaction undrained test is carried out, the axial differential stress at failure is 102 kN/m2, and the water pressure in the clay test body at failure is determined. (2) If the compaction drainage test is carried out, the applied confining pressure is still 115 kN/m2, and the axial difference stress at the time of failure is determined.
A stratum of clay is 2m thick and has an initial vertical effective stress of 50 KN/m2. The foundation load caused an increased pressure of 40 KN/m2 at the mid-layer of clay. Consolidation test revealed the following results: overconsolidation ratio (OCR) = 1.5 Compression index = 0.25 Recompression index = 0.05 Secondary compression index = 0.02 Initial void ratio = 0.90 Determine the following a. the primary consolidation settlement of the clay layer (in mm). b. If the primary consolidation settlement took 2 years to achieve in the field, calculate the secondary consolidation settlement after a period of 5 years (in mm). c. the preconsolidation pressure (in KPa. Note: Kindly give all right solutions with clear calculations.