Suppose there was a large air bubble in the tip of the acid burette during the titration and it was dislodged toward the end of your titration. Explain the effect that this would have on the calculated value of the acid's molarity.

Suppose there was a large air bubble in the tip of the acid burette during the titration and it was dislodged toward the end of your titration. Explain the effect that this would have on the calculated value of the acid's molarity.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter21: Potentiometry

Section: Chapter Questions

Problem 21.22QAP

See similar textbooks

Related questions

Q: Three-point calibration was not performed on the pH meter prior to titration. Is there a…

A: Three-point calibration is performed on the pH meter when pH of a solution that can be both acidic…

Q: Why is a lower concentration of NaOH or HCl used for titration while a solution with higher…

A: Given information: NaOH or HCl

Q: In the experiment "Preparation and Standardization of a Sodium Hydroxide Solution", why was the…

A: Titration is the technique in which the concentration of an unknown substance. The concentration of…

Q: Back aboard the ship, in the botany lab, Mr. Sulu is performing a titration on a weak acid he has…

A: The work is being done a weak acid, which will have some pKa value. The weak acid is titrated with…

Q: Using the Henderson-Hasselbalch equation, demonstrate that the pH at 50% neutralisation for a…

Q: Define the end point of a titration: a) It is a synonym for equivalence point b) It is when a change…

A: The equivalence point is the point in a titration where the amount of titrant added is enough to…

Q: Assess the suitability of methyl orange to signal the equivalence point in weak acid and strong base…

A: Methyl orange is a widely used pH indicator in titrations.

Q: Suppose

A: According to the question, we are using Calcium hydroxide (Ca(OH)2) as the titrant instead of sodium…

Q: Name all possible amino acids for which this might reasonably be the titration curve Explain your…

Q: Find the pH of a formic acid solution when the concentration of formate and formic acid are equal to…

A: Formic acid is an weak acid . Thus, it dissociates weakly in solution to give formate ion.…

Q: A strong acid and a weak acid were titrated with the same strong base. Although the titration curves…

A: Given: Same strong base is titrated against strong acid and weak acid. Concentration of both strong…

Q: Consider the H2O-NaCl-n-propanol ternary diagram. Given a 70-30 mixture of NaCl-n-propanol titrated…

A: There are three most common phases associated with a system such as solid, liquid, and gas. In the…

Q: Why is it necessary to completely fill the rubber tubing of the stopcock with the solution before…

A: Titrations are done by using a buret. A burette is the volumetric measuring glassware carries marks…

Q: Give three uses of acid-base indicators. State two properties of acid-base indicators that make them…

Q: A basic buffer solution is to be prepared. Give the Henderson-Hasselbach equation (buffer equation)…

Q: encountered during the analysis in double indicator titration (determining of carbonates in a…

Q: Which of the following steps MUST be done prior to titration of an analyte? I. Prepare a…

A: Steps done prior titration.

Q: An analytical method that is based on determining the volumes of reagent of known strength that is…

A: Volumetric titrations involve measuring the volume of a solution of knownconcentration that is…

Q: Describe what is done in a displacement titration and give an example.

A: In displacement titration a complex is formed as analyte displaces a reagent, and amount of…

Q: In the determination of Hammett Plot of Substituteed benzoic acids, explain the principle or what…

Q: An approximately 0.1-molar solution of NaOH is to be standardized by titration. Assume that the…

A: Solution - According to the question - In some reacfion there is problem to detect the end point so…

Q: Discuss the theory behind potentiometric pH determinations. Then compare the advantages and…

A: Potentiometric pH meter is used to measure the difference in electric potential between the pH…

Q: Why phenolphthalein is a suitable indicator in the titration of a strong acid with a strong base?

A: To choose appropriate indicator for titration for this graph one must know :- a) pIn value of an…

Q: In this experiment, a student used a pH probe that was not properly calibrated. The probe reads the…

Q: .. Suppose you wanted to further purify the acidic or basic component of your mixture. What might be…

Q: Explain the factors that need to be considered in choosing the possible analyte-titrant-indicator…

Q: Identify the different techniques used to standardize a solution (Acid-Base Titration)

A: Answer - Standardization is the process of determining the exact concentration (molarity) of a…

Q: Term Definition A point during a titration when a sudden change occurs in some observable property…

A: End point is the point during a titration when a sudden change occurs. Equivalence Point is the…

Q: Utilizing stoichiometry, the equivalence point volume and the concentration of sodium hydroxide,…

A: When acid - base Titration take place between sodium hydroxide, base and Hydrochloric acid, acid…

Q: When you plot the volume of the titrant added to the sample against a concentration related…

A: Titrant is the standard solution used in titration process to determine concentration of given…

Q: Before running a titration, you calculate the expected endpoint. However, when performing the…

A: Titration is a popular laboratory technique of quantitative chemical analysis used to assess the…

Q: When performing the titration, it is best to position the tip of the buret: O inside the body of the…

A: When performing the titration then the position of the buret should be as it is that the titrant…

Q: The degree of dissociation of acids is often expressed in terms of pKa. pKa then is Directly…

A: The correct option with explanation is as follows:

Q: In the titration between potassium iodate and the sodium thiosulfate solution, if the titration is…

A: The reaction of IO32- with KI it releases I2 gas ,when H2SO4 is added, so to prevent I2 from…

Q: Often, right after titrant is added, the drop turns dark pink then disappears after swirling. Is the…

A: Indicator has different color at different PH of the solution. When PH the solution changes, then…

Q: Aside from repeating the experiment, what can be done to remedy a sample that is ‘over-titrated’.

A: remedy a sample that is ‘over-titrated 1 - Over-titration is a state where there is more analyte…

Q: Compare the size of the change in pH value when HCl and NaOH are added to water vs. the size of the…

A: BUFFER SOLUTION A buffer solution is chemical solution which resists change to its pH . It is a…

Q: In the experiment, the endpoint of titration is achieved once the solution changes color from yellow…

Q: Hatsume Mei wanted to maintain the pH of a certain solution within a specified range. What should…

Q: Why are the standard reagents used in neutralization titrations generally strong acids and bases…

A: During titration, chemical reaction takes place. Generally am acid reacts with a base. When the…

Q: 2. What is the physical observation when the endpoint has been achieved during titration?

A: Endpoint: refers to the point at which the indicator changes color in an acid-base titration.

Q: During the standardization of NaOH, Shane didn’t notice that there was an air bubble in the tip of…

A: Burette measure the amount of liquid delivered through the tip. If an air bubble exits the tip…

Q: Explain the importance of performing blank titration in a precipitation titration experiment

A: A blank titration is carried out by titrating a fixed and known concentration of titrant into a…

Q: why does a phenolphthalein can be used as an indicator in the Kjeldahl titration?

A: Phenolphthalein is an indicator used in acid-base titration to determine the equivalence point of…

Q: A student recorded the following end-point volumes in an acid-base titration: Trial Number Volume…

A: Mean is the average of a finite number of data. Basically it is defined as the sum of the values…

Q: What are the advantages of potentiometric titrations over conventional titrations?

A: Introduction: Titration : Titration is a method to determine to determine the concentration of the…

Q: Why is the center of the buffer region of a weak acid–strong base titration significant?

A: The reason why the center of the buffer region of a weak acid–strong base titration significant gas…

Concept explainers

Ionic Equilibrium

Chemical equilibrium and ionic equilibrium are two major concepts in chemistry. Ionic equilibrium deals with the equilibrium involved in an ionization process while chemical equilibrium deals with the equilibrium during a chemical change. Ionic equilibrium is established between the ions and unionized species in a system. Understanding the concept of ionic equilibrium is very important to answer the questions related to certain chemical reactions in chemistry.

Arrhenius Acid

Arrhenius acid act as a good electrolyte as it dissociates to its respective ions in the aqueous solutions. Keeping it similar to the general acid properties, Arrhenius acid also neutralizes bases and turns litmus paper into red.

Bronsted Lowry Base In Inorganic Chemistry

Bronsted-Lowry base in inorganic chemistry is any chemical substance that can accept a proton from the other chemical substance it is reacting with.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

If water was used to rinse the conical flask used for the titration, how would this affect your final estimate of hydrochloric acid concentration? (More, less or unchanged?) Explain why, discussing the number of moles that you would actually have due to the rinsing
In a titration experiment what would having a drop on the tip of the buret do for the accuracy of the end point? Is it a problem to have a drop on the end of your belt? Why or why not?
Will the calculated molarity of the hydrogen peroxide be higher or lower than the actual molarity if the endpoint is passed(dark pink)during the titration? Please explain.
What is the relationship between the point of maximum buffer capacity and the speciation diagram? In other words, is there a pattern of chemical behavior between the weak acid and weak base present in the solution at the point(s) of maximum buffer capacity?
Suppose a change (an error, if you like) was made in the procedure of the experiment. We would to know qualitatively, (higher than the correct value, lower than the correct value, or no change) how this change would affect the calculated hydroxide ion concentration. A suggested method for determining and explaining the answer was given in experiment 7 and is repeated here for one such change, with only the final conclusion missing. Fill it in. For the second change, you do the whole analysis. Change 1 – The endpoint was overshot (too much titrant was added). Quantity Measured value (what actually happened) “True” value (what should have happened) (Compared to true value) measured value is Why? Initial burette reading Correct Beginning of titration was ok. Final burette reading 31 mL, say 30 mL, say Too high VNaOH Too high so change in the same direction. Correct Pipetting was ok. Correct Too _________ The numerator is correct; the denominator too high. Change 2 –…
List the observations of a manual titration experiment and explain your expectations. This should include color change and when the equivalence point (endpoint) might be reached. When do you stop and why.
Draw the titration curve for a strong acid (titrant) and a strong base (analyte) titration. Kindly show and label the x- and y- axes, and the equivalence point.
When calculating your equivalent mass of the unknown organic acid, the volume used in your titration must be in what units?
How do I determine the concentration of hydrochloric acid through acid-base titration? I mean what experiment could be done to do it. Like what materials or methods to use
Would you recommend adding the phenolphthalein and methyl orange indicators together at the start of the titration to save time?
During the titration of acetic acid solution with standard NaOH using phenolphthalein, the end point was read when the color of the solution was red. How does the reported value of the molarity of acid compare with the actual value?
How is the End-point detected in a Karl Fisher titration?