table of choices: Evaporation is the process by which water is changed from the liquid or solid state into the gaseous state through the transfer of _______________.table of choices: WATER INPUTSMALLERPICHE-EVAPORIMETER TRANSPIRATIONPONDING TIMEHYDRAULIC CONDUCTIVITYSTATIC PRESSUREHYDRAULICPOROSITYPHYSICALKINETIC ENERGYEVAPORATIONUNSATURATED TEXTUREWATER VAPOR DAILY AERODYNAMICSURFACE TENSIONEXFILTRATION SORPTIVITYPERCOLATIONPOTENTIAL EVAPOTRANSPIRATIONRECHARGEINTERFLOW LYSIMETERINFILTRATIONCAPILLARY RISE EVAPOTRANSPIRATIONCUMULATIVE INFILTRATIONGRADIENT ACTUAL INFILTRATIONINFILTROMETERHEAT ENERGYSATURATEDLARGERSOIL SUCTION POTENTIALREDISTRIBUTIONSMALL

Answered: table of choices: Evaporation is the…

table of choices: Evaporation is the process by which water is changed from the liquid or solid state into the gaseous state through the transfer of _______________. table of choices:

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Due to rise in temperature, the viscosity and unit weight of percolating fluid are reduced to 70%…

Q: Fluid Mechanics , i need solutions in 15 minutes please. MCQ/Find the capillary rise (h) in the tube…

Q: Tutorial #1 Fluid Properties What is the specific gravity of kerosene, which has a specific weight…

A: specific gravity=specific wt of substancespecific wt of reference substancesospecific gravity of…

Q: At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vapor pressure at…

Q: tank with a capacity of 1500 gallons originally contains 1000 gals of fresh water. The first pipe…

A: To find salt concentration in tank

Q: Measurement of changes in volume of water in an evaporation pan is a standard technique for…

A: Solution : a) Since US Class A evaporation pan is open to upper circular area through which…

Q: In a given setup as defined by the figure below, determine the rate of change in terms of h(t) given…

Q: 29. Which of the following term in the buildings is used to mean the coming out of water from…

Q: Given the subsequent statistics for liquid methanol, decide its density in h/f * t^ three and…

Q: A spherical tank is full of water that has a total mass of 10,000 kg. If the outside diameter of the…

Q: saturated) it is at 68°F (barometer reads 745 mmHg), what percent

A: data given Barometric pressure at 90 F , P1 =739mm HgBarometric pressure at 68 F , P1 =745 mm Hg…

Q: For the given amount volume of (gel=18.5ml, combined water= 6.2ml, gel water= 4.8ml and empty…

Q: Write a note on the dew point and its measurement device

A: The dew point is the temperature at which air must be cooled to become saturated with water vapor.…

Q: A tunnel in the shape of a half cylinder connects two buildings. The tunnel is24 feet long and 10…

A: Calculate the volume of half cylinder-shaped tunnel, Volume = Cross sectional area × Length The…

Q: Determine the diameter of the nozzle, if the flowing fluid in the nozzle has a specific gravity of…

A: To Determine Diameter of the nozzle, D

Q: REJECTED Tuesday, Jan 19, 2021 ENGINEERING • CIVIL-ENGINEERING A jet of water having velocity of 20…

A: Given Data V1=20msecU1=U2=10msecα=20°ϕ=180°-130°=50°d=50mm

Q: Consider a cylindrical tank (diameter = 8 m and depth = 5 m) that contains water at 15ºC and is…

Q: Watch a video about Airflow Visualization. Answer the following How does the air behaves at zero…

A: boundary layer

Q: There are two barrels, one containing 40 gallons of wine and 60 gallons of water, the other…

Q: (c) Which of the following would be considered control volume system? a Tire b. Piston-cylinder…

A: Which of the following would be considered control volume system? e. Mixture of liquid water and air…

Q: height of the fluid inside the tube after immersion is 1⁄8 the height of the cylinder glass tubing.…

A: Immersion is something placed in a liquid. When an object is immersed in a fluid, its weight will…

Q: calculate the volume of the water in ft3

Q: The rate of the water flowing from a pipe is at 1500 gal/min. Convert this volume rate of flow in…

A: To convert the volume rate of flow to the given units. Given, Volume rate of flow, say Q = 1500…

Q: What is the definition of dew point? If the air (30 °C, 1 atm) contains 2% (volume fraction) water,…

A: DEFINITION OF DEW POINT : FROM ENVIRONMENTAL PERSPECTIVE, THE CLIMATIC TEMPERATURE AT WHICH THE AIR…

Q: Water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a…

A: To find rate of hot water

Q: Define the following words: 1. RESERVOIRS 2. EVAPORATION 3. CONDENSATION 4. INTERCEPTION 5.…

A: 1. RESERVOIRS:- The term reservoir is defined as a barrier which is constructed across the river in…

Q: A tank has pure water flowing into it at 12 L/min. The contents of the tank are kept thoroughly…

A: Step 1

Q: The fuel gage for a gasoline tank an a car reads proportional to its bottom gage. The tank is 35 cm…

A: Pressure when tank is full of gasolinePG=γghgPG=(0.68×9.81)(0.35)=2.335kPa

Q: Discuss the difference between total suction, matric suction and osmotic suction.

Q: Copper tubing 0.500 in. in I.D. (inside diameter) is 13.0 ft long. What is the volume of the…

A: Given:- The inside diameter of the copper tubing = 0.500 in The length of the tube = 13 ft To…

Q: 50-mm inside diameter Flow 600 mm 100-mm inside diameter Water 200 What volume flow rate in gallons…

A: step 1-

Q: Find the dynamic and kinematic viscosities of kerosene, SAE 10W-30 motor oil, and water at a…

A: Given: The temperature is 50oC.

Q: Describe the function of an air filter

A: Function of air filter

Q: vendor takes an ice cream cup out of a freezer, kept at -18 degree-Celcius. Outside, the room…

A: Newtons law of cooling:

Q: Write the relationship between the Kelvin and Celsius for measuring temperatures in SI system. Write…

Q: 2= 1 m n3= 7 m 4= 12 m Oil h1 Water h2 Mercury h3

A: Specific Gravity of Oil = 0.8 Specific Gravity of water = 1 Specific Gravity of Mercury = 13.6

Q: Consider that water aeration does not result in calcium carbonate precipitation, which of the…

Q: 2.116 A manufacturer is studying the effects of cook- ing temperature, cooking time, and type of…

A: Given data, number of different temperatures obtained = 3 Different cooking times = 4 different oils…

Q: discuss at least five sources of error in measuring anions in rainwater through ion chromatography

A: Inorganic and short-chain organic anions and cations can be separated and measured using ion…

Q: Calculate the flow rate through the system

A: Answer We can use Bernoulli's energy equation to calculate the flow rate through the system Consider…

Q: W.S (t-O) FIGURE H 1.5 m by 1.5 m T 1.20 m 0.60 m T orifice (1) orifice (2) T 1.

Q: 409.65 gallons +0.644 gallons + 79.7 gallons + 69.286 gallons

A: Write down the given number, one under the other;

Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4…

Q: ACTIVITY 2 Direction: solve and analyze each of the following problem in neat and orderly manner. Do…

A: Given room temperature = Tm = 700C At t= 0min : T0 = 18⁰C At t=1 min : T1 = 31⁰C

Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…

Q: For the given amount volume of (gel-18.5ml, combined water=6.2ml, gel water= 4.8ml and empty…

A: Given- volume of gel=18.5ml combined water=6.2ml gel water= 4.8ml empty pores-3.5ml

Q: Brief description about the uses of Evaporimeters, Atmometers and Evaporation pans and tanks.

A: Water requirement is important to be known for watering crops. Random amount of watering may led to…

Q: Calculate AH for the process in which 50.0 g of water is converted from liquid at to vapor at 25 C?

A: Given data: Mass, m = 50 g Specific heat capacity for water, c = 4.18 g-1 Change in temperature from…

Q: 2Q. Calculate the density, specific weight, and specific volume of air at 120°F and 50 psia.

Concept explainers

Evaporation

This topic is majorly taught in various undergraduate and postgraduate degree courses of:

Question

table of choices: Evaporation is the process by which water is changed from the liquid or solid state into the gaseous state through the transfer of _______________. table of choices:

WATER INPUT
SMALLER
PICHE-EVAPORIMETER TRANSPIRATION
PONDING TIME
HYDRAULIC CONDUCTIVITY
STATIC PRESSURE
HYDRAULIC
POROSITY
PHYSICAL
KINETIC ENERGY
EVAPORATION
UNSATURATED TEXTURE
WATER VAPOR DAILY AERODYNAMIC
SURFACE TENSIONEXFILTRATION SORPTIVITY
PERCOLATION
POTENTIAL EVAPOTRANSPIRATION
RECHARGE
INTERFLOW LYSIMETER
INFILTRATION
CAPILLARY RISE EVAPOTRANSPIRATION
CUMULATIVE INFILTRATION
GRADIENT ACTUAL INFILTRATION
INFILTROMETER
HEAT ENERGY
SATURATED
LARGER
SOIL SUCTION POTENTIAL
REDISTRIBUTION
SMALL

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Theflowrateofwaterthroughacastironpipeis5000GPM.The diameter of the pipe is 330mm, and the coefficient of friction is f=0.0173. What is the pressure drop over a 30m length of pipe
Exercise (51 A system of pipe drains of (0.2m in diameter) are used to drainage area, the drains are located (1.8m) below ground surface. The impervious layer about 6.8m from ground surface, k = 1.0 m / day. The successive irrigations are every 20 days, deep percolation losses toward water table (WT) are 40mm / irrigation. Determine the spacing between drains (1) To maintain WT level of 0.8m. 2) To maintain WT level
A conventional activated-sludge system treats 11,000 m3/day of wastewaterin an aeration tank with a volume of 3400 m3. The BOD after primary clarification is 180mg/l. Given the operation conditions below, calculate the sludge residence timeMLVSS in the rector = 2,100 mg/lMLSS = (1.25)*MLVSSQw = 160 m3/daySVI = 125 mL/g (Ans. SRT = 7.0 days)
Evaporation pans provide an approximate estimate of (i)Evaporation from lakes (ii)Actual evapotranspiration (iii)Potential evapotranspiration (iv)Reference evapotranspiration
need ans very vaey fast in 20 min
If (Qr/Q=120 percent of discharge), effluent BOD concentration=80ppm, volume of filter =825m3 , discharge =50L/sec , The influent BOD concentration equal: Choose one: a. 277.89 b. 277.2 c. 276 d. 275
issues from the tank in shown at Q = 45 f3/h. Assume laminar flow conditions and neglect entrance and exit losses. (a) What is the velocity of flow in the pipe. Ans: 9.167 ft/s (b) Determine the head lost in the pipe. Ans: 7.695 feet - Determine the kinematic viscosity of the paint in ft?/s. Ans:0.0002444
Wasterwater civil engineering 11 and 12
A shaker-type baghouse is to be designed to remove gypsum dust from a wall-board manufacturing plant exhaust gas stream flowing at 125,000 adxo. The air stream is at 175 °F and has a signilicanfc content of SO2 gas, Specify, the total number of bags, assuming each bag has 35 ft2 of cloth area, (Be sure to consider a proper layout of bags in each compartment),
Assume that the ESP of Problem 5.1 is built with an actual collection area of 5400 m2, Now suppose that the actual drift velocity turns out to be 5,0 cm/s and the actual gas flow turns out to he 5500 m3/mtn, Calculate the actual efficiency, 5.1 A 98% efficient ESP is to treat a gas stream flowing at 5000 m3/ min. If the effective drift velocity is 6.0 cmf% calculate (a) the plate area {required and actual) in m2, and (b) the number of plates if each plate is 6 m hy 10 m, and there are 3 mechanical fields.
A stack was sampled for 8 minutes. The gas velocity (at stack conditions) through the sampler was 15.0 mfs and the area of the sample probe was 5.07 cmK The net mass of particulates collected was 0,430 grams. a. Calculate the concentration of particulates in the- stack in p.g/m3.b. The temperature in the stack is 300 aF and the pressure is 725 mm Hg. If the total flow rate of gas out of the stack is 190 standard cubic meters per second* calculate the total mass emissions of particulates out of the stack in kg/day.
An orifice meter was calibrated by the manufacturer for air at 25℃ and 1atm. It is installed in an air sampling system where it operates at 33℃, 0.9atm and reads a ΔP of 4.8″H2O. The calibration curve has the relationship Qi=41×(ΔP)1/2in slpm(liters per minute at 25℃, 1atm). What is the true gas flow rate in slpm?