Tutorial #1 Fluid Properties What is the specific gravity of kerosene, which has a specific weight of 7.853103 N/m³? Two capillary tubes are placed vertically in an open container of water. One tube has a diameter of 2.0 mm, and the other a diameter of 1.0 inch. In which tube will the water rise higher? A sliding plate viscometer, as shown below, is used to measure the viscosity of a fluid. The plate area is 0.75 ft2. A force of 1.531024 lb moves the upper plate at a velocity of 10.0 ft/s. What is the absolute viscosity? V = 10.0 ft/s 0.50" Fluid A liquid has an absolute viscosity of 2.231025 Ib-s/ft?. It weighs 45 lb/ft³. What is its kinematic viscosity? A liquid has an absolute viscosity of 2.431023 N-s/m². It weighs 7.853103 N/m³. What is its kinematic viscosity?

Tutorial #1 Fluid Properties What is the specific gravity of kerosene, which has a specific weight of 7.853103 N/m³? Two capillary tubes are placed vertically in an open container of water. One tube has a diameter of 2.0 mm, and the other a diameter of 1.0 inch. In which tube will the water rise higher? A sliding plate viscometer, as shown below, is used to measure the viscosity of a fluid. The plate area is 0.75 ft2. A force of 1.531024 lb moves the upper plate at a velocity of 10.0 ft/s. What is the absolute viscosity? V = 10.0 ft/s 0.50" Fluid A liquid has an absolute viscosity of 2.231025 Ib-s/ft?. It weighs 45 lb/ft³. What is its kinematic viscosity? A liquid has an absolute viscosity of 2.431023 N-s/m². It weighs 7.853103 N/m³. What is its kinematic viscosity?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 26P: SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the...

See similar textbooks

Similar questions

A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3.
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3. pls answer asap thank you
The Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original area. Cold air at 0 deg C flows in the pipe through the Venturi meter. The velocity of the air upstream of the Venturi meter is equal to 40 ft/s and the pressure at the same point is equal to 30 psia. What is the manometer reading if the fluid of the manometer is water with density 1000 kg/m3 . Assume that the air behaves as an ideal gas with molecular weight equal to Mw=29 kg/kmol and constant density evaluated at upstream conditions. Use Bernoulli's equation for your calculations. please respond asap!
A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined inan internal reservoir inside the closed tank, the height of mercury is 450mm. An openmanometer is placed on the bottom left part of the tank with liquid “X” as its gage liquid , thedeflection from the gage liquid shows 800mm. Determine the following:a) Height of the oil from point A up to point c if height A to C is 5 times the height of y.b) Pressure at point B in kPa. c) Pressure at point C in psi.
Solve the mixing problem using first order differential equations. A 200-gallon tank initially holds 50 gallons of salt solution containing 20 lbs dissolved salt. A pipe fills the tank with 2 lbs of salt per gallon at a rate of 5 gpm. The mixture is stirred uniformly and 3 gpm of brine runs out of the tank. a. Draw the schematic diagram of the system showing the values given in the problem. b. Determine the amount of salt in the tank at the end of 85 minutes.
Pitot PipeBy connecting a mercury pressure gauge to a vertical pipeline through which water is transmitted, speed measurement is performed with a pitot tube. Since the deviation from the pressure gauge column is 15 cm, calculate the speed of the water in the pipe. (Pmercury=13560 kg/m3, Pwater=1000 kg/m3) (Answer is V2=6.08 m/s)
40. Situation 14 - A calibration test of a 0.00785 m2 circular sharp-edged orifice in a vertical side of a large tank showed a discharge of 22,300 N of water in 1 minute and 40 seconds at a constant head of 1.20 m. Measurement of the jet showed that it traveled 1.92 m. horizontally while dropping 0.80 m. a. What is the nearest value of the coefficient of contraction? Round off to four decimal places. b. What is the nearest value of the coefficient of velocity? Round off to four decimal places. c. What is the nearest value of the coefficient of discharge? Round off to four decimal places.
A closed tank contains 0.610 m of mercury (SGmercury = 13.6), 1.524 m of water, 2.438 m of oil of specific gravity 0.750, and an air space above the oil. If the pressure at the bottom of the tank is 276 kPa gage, what should be the reading at the top of the tank? Express your answer in kPa.
A 4-in diameter solid cylinder of height 3.75 in weighing 0.85 lb is immersed in liquid (y= 52 pcf) contained in a tall, upright metal cylinder havibg a diameter if 5 in. Before immersion the liquid was 3.0 in deep. Calculate the distance if the bottom of the solid cylinder from the bottom of the metal cylinder Choices: 2.19 in , 2.33 in, 2.47 in, 1.80 in
In a manometer shown, the fluid from A to B is mercury (sp. gr. = 13.6) and fromB to C, the fluid is oil (sp. gr. = 0.80). At what height, h, of oil will give a pressureof 452 grams/cm2at C. Use density of water of 1.0 grams per cu.cm.
1. Determine the specific gravity of the liquid with a mass of 1,200 kg/m3 2. Determine the volumetric flow rate, in gpm, for water flowing out of a faucet based on 2 gal in 23 s. 3. Determine the volumetric flow rate, in L/s, for water flowing out of a faucet based on 6 L in 8 s. 4. Determine the average velocity for water flow in a 2 in diameter pipe, Schedule 40 chlorinated polyvinyl chloride (CPVC) pipe (2.375 in outside diameter and 2.047 in inside diameter) carrying cold water at a volumetric flow rate of 40 gpm. 5. Determine the average velocity for water flow in a 20 mm diameter copper tube (21.4 mm outside diameter and 19.9 mm inside diameter) carrying water at a volumetric flow rate of 40 L/min. 6. At sea level, atmospheric pressure is 14.7 psia (101 325 Pa). A bicycle tire (at sea level) is inflated to 50 psi (344 737 Pa). Determine the gauge and absolute pressures in the inflated tire. 7. Define pressure drop.
On the suction side of a pump, a Bourdon pressure gage reads 40 kPa vacuum ( = - 40 kPa). What is the corresponding absolute pressure if the local atmosphere pressure is 100 kPa (abs)?[Answer in units of kPa]