The acceleration of an object that has a mass of 0.025 kg and exhibits simple harmonic motion is given by thefollowing equation.az (t) = (10 m/s² ) cosnt +Calculate the object's velocity v×(t) at time t =3.0 s,assuming that the velocity of the object is vz3.2 m/s atUx (3.0 s) =m/st = 0 s.

Name: The acceleration of an object that has a mass of 0.025 kg and exhibit
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: The acceleration of an object that has a mass of 0.025 kg and exhibits simple harmonic motion is given by thefollowing equation.az (t) = (10 m/s² ) cosnt +Calculate the object's velocity v×(t) at time t =3.0 s,assuming that the velocity of the objec

Answered: Image /qna-images/answer/6bf50c5e-3809-49b1-850e-deb1fe696387.jpg

Science

Physics

The acceleration of an object that has a mass of 0.025 kg and exhibits simple harmonic motion is given by the following equation. ax (t) = (10 m/s²) cos ( at + Calculate the object's velocity V×(t) at time t = 3.0 s, assuming that the velocity of the object is vz = 3.2 m/s at Ux (3.0 s) = m/s t = 0 s.

The acceleration of an object that has a mass of 0.025 kg and exhibits simple harmonic motion is given by the following equation. ax (t) = (10 m/s²) cos ( at + Calculate the object's velocity V×(t) at time t = 3.0 s, assuming that the velocity of the object is vz = 3.2 m/s at Ux (3.0 s) = m/s t = 0 s.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Oscillatory Motion

Section: Chapter Questions

Problem 2OQ

See similar textbooks

Similar questions

A 200-g block is attached to a horizontal spring and executes simple harmonic motion with a period of 0.250 s. The total energy of the system is 2.00 J. Find (a) the force constant of the spring and (b) the amplitude of the motion.
A pendulum of length L and mass M has a spring of force constant k connected to it at a distance h below its point of suspension (Fig. P15.55). Find the frequency of vibration of the system for small values of the amplitude (small ). Assume the vertical suspension rod of length L is rigid, but ignore its mass. Figure P15.35
In an engine, a piston oscillates with simple harmonic motion so that its position varies according to the expression x=5.00cos(2t+6) where x is in centimeters and t is in seconds. At t = 0, find (a) the position of the piston, (b) its velocity, and (c) its acceleration. Find (d) the period and (e) the amplitude of the motion.
An automobile with a mass of 1000 kg, including passengers, settles 1.0 cm closer to the road for every additional 100 kg of passengers. It is driven with a constant horizontal component of speed 20 km/h over a washboard road with sinusoidal bumps. The amplitude and wavelength of the sine curve are 5.0 cm and 20 cm, respectively. The distance between the front and back wheels is 2.4 m. Find the amplitude of oscillation of the automobile, assuming it moves vertically as an undamped driven harmonic oscillator. Neglect the mass of the wheels and springs and assume that the wheels are always in contact with the road.
Which of the following statements is not true regarding a massspring system that moves with simple harmonic motion in the absence of friction? (a) The total energy of the system remains constant. (b) The energy of the system is continually transformed between kinetic and potential energy. (c) The total energy of the system is proportional to the square of the amplitude. (d) The potential energy stored in the system is greatest when the mass passes through the equilibrium position. (e) The velocity of the oscillating mass has its maximum value when the mass passes through the equilibrium position.
When a block of mass M, connected to the end of a spring of mass ms = 7.40 g and force constant k, is set into simple harmonic motion, the period of its motion is T=2M+(ms/3)k A two-part experiment is conducted with the use of blocks of various masses suspended vertically from the spring as shown in Figure P15.76. (a) Static extensions of 17.0, 29.3, 35.3, 41.3, 47.1, and 49.3 cm are measured for M values of 20.0, 40.0, 50.0, 60.0, 70.0, and 80.0 g, respectively. Construct a graph of Mg versus x and perform a linear least-squares fit to the data. (b) From the slope of your graph, determine a value for k for this spring. (c) The system is now set into simple harmonic motion, and periods are measured with a stopwatch. With M = 80.0 g, the total time interval required for ten oscillations is measured to be 13.41 s. The experiment is repeated with M values of 70.0, 60.0, 50.0, 40.0, and 20.0 g, with corresponding time intervals for ten oscillations of 12.52, 11.67, 10.67, 9.62, and 7.03 s. Make a table of these masses and times. (d) Compute the experimental value for T from each of these measurements. (e) Plot a graph of T2 versus M and (f) determine a value for k from the slope of the linear least-squares fit through the data points. (g) Compare this value of k with that obtained in part (b). (h) Obtain a value for ms from your graph and compare it with the given value of 7.40 g.
Consider a graphical representation (Fig. 12.3) of simple harmonic motion as described mathematically in Equation 12.6. When the particle is at point on the graph, what can you say about its position and velocity? (a) The position and velocity are both positive. (b) The position and velocity are both negative. (c) The position is positive, and the velocity is zero. (d) The position is negative, and the velocity is zero. (e) The position is positive, and the velocity is negative. (f) The position is negative, and the velocity is positive. Figure 12.3 (Quick Quiz 12.2) An xt graph for a particle undergoing simple harmonic motion. At a particular time, the particles position is indicated by in the graph.
A block of unknown mass is attached to a spring with a spring constant of 6.50 N/m and undergoes simple harmonic motion with an amplitude of 10.0 cm. When the block is halfway between its equilibrium position and the end point, its speed is measured to be 30.0 cm/s. Calculate (a) the mass of the block, (b) the period of the motion, and (c) the maximum acceleration of the block.
Consider the simplified single-piston engine in Figure CQ12.13. Assuming the wheel rotates with constant angular speed, explain why the piston rod oscillates in simple harmonic motion. Figure CQ12.13
A 500-kg object attached to a spring with a force constant of 8.00 N/m vibrates in simple harmonic motion with an amplitude of 10.0 cm. Calculate the maximum value of its (a) speed and (b) acceleration, (c) the speed and (d) the acceleration when the object is 6.00 cm from the equilibrium position, and (e) the time interval required for the object to move from x = 0 to x = 8.00 cm.
Determine the angular frequency of oscillation of a thin, uniform, vertical rod of mass m and length L pivoted at the point O and connected to two springs (Fig. P16.78). The combined spring constant of the springs is k(k = k1 + k2), and the masses of the springs are negligible. Use the small-angle approximation (sin ). FIGURE P16.78
The mechanical energy of an undamped block-spring system is constant as kinetic energy transforms to elastic potential energy and vice versa. For comparison, explain what happens to the energy of a damped oscillator in terms of the mechanical, potential, and kinetic energies.