The chemical method of analysis in determination of the blood alcohol content (%BAC) is: K2Cr2O7 + H2SO4 + C2H5OH → Cr2(SO4)3 + K2SO4 + CH3COOH + H2O What are the stoichiometric coefficients for the reaction above? (please enter the coefficients without spaces and with a coma between the numbers, e.g. 1,2,3,4) During a Breathalyzer Test it was determined that 2.00mg of K2Cr2O7 was consumed by the above reaction. Calculate the number of milligrams of ethanol in the test sample. Calculate the Blood Alcohol Content in this sample (%BAC).

The chemical method of analysis in determination of the blood alcohol content (%BAC) is: K2Cr2O7 + H2SO4 + C2H5OH → Cr2(SO4)3 + K2SO4 + CH3COOH + H2O What are the stoichiometric coefficients for the reaction above? (please enter the coefficients without spaces and with a coma between the numbers, e.g. 1,2,3,4) During a Breathalyzer Test it was determined that 2.00mg of K2Cr2O7 was consumed by the above reaction. Calculate the number of milligrams of ethanol in the test sample. Calculate the Blood Alcohol Content in this sample (%BAC).

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter7: Extraction

Section: Chapter Questions

Problem 1Q

See similar textbooks

Similar questions

The procedure for the synthesis of menthone indicates that you should use 10 cm³ of 6M sulphuric acid. Suppose that only sulphuric acid with concentration 1.5M is available in the laboratory. What volume in cubic centimetres of this solution do you need to add to the reaction mixture to replace the solution originally specified? [Do not type in the unit. Round the answer to a whole number.] *
You are given a concentrated stock solution of 3.0 M sucrose, and you’re asked to do a serial dilution of 1:25, 1:10, and 1:5. What is the final concentration of sucrose (in mM) you achieve after these dilutions. Show your unit conversions step by step
A student performs a crystallization on an impure sample of biphenyl. The sample weighs 0.5 g and contains about 5% impurity. Based on his knowledge of solubility, the student decides to use benzene as the solvent. After crystallization, the crystals are dried and the nal weight is found to be 0.02 g. Assume that all steps in the crystallization are performed correctly, there are no spills, and the student lost very little solid on any glassware or in any of the transfers. Why is the recovery so low?
The procedure for the synthesis of menthone indicates that you should use 10 cm³ of 6M sulphuric acid. Suppose that only sulphuric acid with concentration 1.5M is available in the laboratory. What volume in cubic centimetres of this solution do you need to add to the reaction mixture to replace the solution originally specified?
The first goal is to make the oxalic acid standard solution. You measure 1.5232 g of oxalic acid on an analytical balance, add it to a 250-mL volumetric flask and add deionized H2O to a final volume of 250.0 mL. Molar mass of H2C2O4•2H2O = 126.07 g/mol Mass of H2C2O4•2H2O = 1.5232g what is the Number of moles of H2C2O4•2H2O?
5.0 mL of 1-butanol was mixed with 10 mL of HCl. The reaction was put on an ice bath and 4 mL of concentrated sulfuric acid was added. This mixture was refluxed for 45 min and then the product was co-distilled with water using a simple distillation apparatus. Water and the product are immiscible. 1-butanol has a molar mass of 74.12 g/mol, a density of 0.810 g/mL, and a boiling point of 118 C. The product has a molar mass of 92.57 g/mol, a density of 0.880 g/mL, and a boiling point of 78 C. What is the nucleophile in this reaction? What is the role of H2SO4 in this reaction? Calculate the theoretical yield for this reaction. Give your answer in grams. Select the following statements that can be said about the reaction shown.
Given a reaction mixture of 40 mols of ethylebe glycol, 40 mols terephthalic acid, and 1.2 mol benzoic acid, what value of Xn would be expected if complete conversion (p = 1) of limiting factor were completed?
In the molecular weight determination by the Dumas method, several grams of an organic liquid was drawn into a bulb. The bulb was then immersed in a water bath at 87 degrees C and kept there until all the liquid was vaporized and the air in the bulb was replaced by the vapor. The tip was then sealed shut and the bulb removed from the vapor was 36.127g; the weight of the empty (evacuated) bulb was 35.427g; the bulb’s volume was 200.0mL; room temperature was 25 degrees C, and the barometric pressure was 720 mm Hg. Calculate the molecular weight of the organic liquid. Calculate the molecular weight of the organic liquid.
The stock erythrosine B solution is 8.5 × 10-5 M. Calculate the volume of this solution that you must pipet into a 50-mL volumetric flask, which, when diluted to mark with deionized water, will give a final concentration of 1.7 × 10-5 M. Show your calculation setup.
50.00 cm3 of a 1.5784 mol.dm-3 solution of potassium hydroxide is transferred to an empty 700.00 cm3 volumetric flask. This flask is made up to the mark with distilled water and then shaken well. The concentration of the potassium hydroxide in this second flask is:
The first goal is to make the oxalic acid standard solution. You measure 1.5232 g of oxalic acid on an analytical balance, add it to a 250-mL volumetric flask and add deionized H2O to a final volume of 250.0 mL. Molar mass of H2C2O4•2H2O = 126.07 g/mol Mass of H2C2O4•2H2O = 1.5232g Volume of H2C2O4•2H2O solution = 250.0mL What is the Molarity H2C2O4 standard solution ?
If one mixes 50cm³ of EtOH and 50cm³ of H2O at room temperature; will the total volume of the solution be 100.0 cm³? Justify answer with appropriate calculations and explanations