The content of acetylsalicylic acid is determined by liquid chromatography/Uv, the quantification is performed by calibration curve, the sample is weigh 325 mg and are diluted to 500 mL, the content average is 327 mg/tab. Indicate the content of acetylsalicylic acid according to the following information. mg/mL 0.1 0.2 0.3 0.4 0.5 Sample: 27000.000 Rta 8500 16900 25650 34000 42558

The content of acetylsalicylic acid is determined by liquid chromatography/Uv, the quantification is performed by calibration curve, the sample is weigh 325 mg and are diluted to 500 mL, the content average is 327 mg/tab. Indicate the content of acetylsalicylic acid according to the following information. mg/mL 0.1 0.2 0.3 0.4 0.5 Sample: 27000.000 Rta 8500 16900 25650 34000 42558

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter4: Digital Electronics And Computers

Section: Chapter Questions

Problem 4.11QAP

See similar textbooks

Similar questions

1. For the following chromatography state what the mobile phase is, stationary phase is, and what would elute first for each of the chromatography type... HPLC Gas Chromatography Ion Exchange Chromatography Size Exclusion Chromatography (SEC) Affinity Chromatography Reverse Phase Chromatography Normal Phase Chromatography
An HPLC method was developed for the separation and determination of ibuprofen in blood samples. A 3.00 mL blood sample dissolved in 70.00 mL solvent was prepared and 10.0 mL was injected into the HPLC. Standard ibuprofen solutions were also run.Calculate the ibuprofen present in the 3.00 mL blood sample The following data were obtained. Table po itoo: Ibuprofen concentration, mg/ml0.50 1.0 2.0 3.0 Blood sample Peak area (Right column)5.29.617.419.911.4
Categorize each as a determinate or an indeterminate error and further classify determinate errors as instrumental, method or personal.d) The tip of the pipet used in the analysis is broken. e) In measuring the same peak heights of a chromatogram, two technician each report different heights.
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.
Tim is interested in analyzing for Pyraclostrobin (pesticide) in strawberries using QuECHers method for extraction and clean up before analysis with HPLC-uv. The concentration of the Pyraclostrobin in the fruits that he sampled is thought to be between 1-10 ng pesticide per g fruit fresh weight. The HPLC-uv instrument he is using has a LoQ of 5 ppb for Pyraclostrobin. Tim is starting out with 500 mg of the sliced fruit
In order to execute paper chromatography, which of the following stages is required?I. Load the standard/s beside the sample spotsII. Allow the chromatogram to touch sides of beakerIII. Saturate the chamber with vapor of the mobile phaseIV. Place the spots at the same height as the solvent level
Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many amphetamine‑type stimulants (ATS). Using a 0.25 mm thick silica gel stationary phase and a 98.5:1.5 methanol:concentrated ammonia mobile phase, a spot was observed to have traveled 3.52 cm when the solvent front traveled 8.81 cm. What is the retardation factor (?F)for the compound that composes this spot?
You are provided with a stock standard with a concentration of 100 mg/L, and a solution of unknown concentration. Prepare calibration standards using a 10 mL volumetric flask and a 1 mL piston pipette, and measure on the UV/Vis spectrophotometer (400 nm). Determine the concentration of the unknown after a 1:40 dilution, and provide the concentration of the initial solution. i need to learn how to do the calculations and draw a calibration curve to find concentration of unknown sample after i find the absorbances.
The flame-ionization detector is used in gas chromatography because the eluates cannot be detected by UV. True False
Why Rf value is important in Chromatography? Please shortly answer at your own words. Answer should be the point (specific 4-5 lines).
the efficiency of a chromatographic column improves the measure thata.increases the height of the theoretical dishesb.decreases the number of theoretical platesc.platform height is reducedd.None of the above Please explain it Provide clear handwriting and clear image
Use the following information collected from a SIZE-EXCLUSION CHROMATOGRAPHY experiment to answer the questions below. MW Standards Molecular Weight (kDa) Elution Volume (mL) blue dextran 1000 85 myoglobin 17.2 200 TIM 53.3 178 hemoglobin 62.2 156 IgG 140 122 ATCase 307.9 94 Prepare a graph showing the linear relationship between log function of molecular weight against Ve/Vo. The R2value must be 0.9 or higher. What is the linear equation from the standards given? What is the R2value?