The FM radio band is broadcast between 88.0 MHz and 108 MHz. What is the minimum capacitance that must be used to tune in these signals if an inductor of 2.90 µH is used? What is the maximum capacitance that must be used to tune in these signals if an inductor of 2.90 µH is used?

The FM radio band is broadcast between 88.0 MHz and 108 MHz. What is the minimum capacitance that must be used to tune in these signals if an inductor of 2.90 µH is used? What is the maximum capacitance that must be used to tune in these signals if an inductor of 2.90 µH is used?

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section: Chapter Questions

Problem 30P

See similar textbooks

Similar questions

(i) When a particular inductor is connected to a source of sinusoidally varying emf with constant amplitude and a frequency of 60.0 Hz, the rms current is 3.00 A. What is the rms current if the source frequency is doubled? (a) 12.0 A (b) 6.00 A (c) 4.24 A (d) 3.00 A (e) 1.50 A (ii) Repeat part (i) assuming the load is a capacitor instead of an inductor. (iii) Repeat part (i) assuming the load is a resistor instead of an inductor.
An LC circuit in an AM tuner (in a car stereo) uses a coil with an inductance of 2.5 mH and a variable capacitor. If the natural frequency of the circuit is to be adjustable over the range 540 to 1600 kHz (the AM broadcast band), that range of capacitance is required?
The self-inductance and capacitance of an LC circuit e 0.20 mH and 5.0 pF. What is the angular frequency at which the circuit oscillates?
(a) What capacitance will resonate with a one-turn loop of inductance 400. pH to give a radar wave of wavelength 3.0 cm? (b) If the capacitor has square parallel plates separated by 1.0 mm of air, what should the edge length of the plants be? (c) What is the common reactance of the loop and capacitor at resonance?
(a) An inductor designed to filter high-frequency noise from power supplied to a personal computer is placed in series with the computer. What minimum inductance should it have to produce a 2.00 k(reactance for 15.0 kHz noise? (b) What is its reactance at 60.0 Hz?
In an oscillating LC circuit, the maximum charge on the capacitor is qm. Determine the charge on the capacitor and the current through the inductor den energy is shared equally between the electric and magnetic fields. Express your answer in terms of qm, L, and C.
Problems 71 and 72 paired. Figure P33.71 shows a series RLC circuit with a 25.0- resistor, a 430.0-mH inductor, and a 24.0-F capacitor connected to an AC source with Vmax = 60.0 V operating at 60.0 Hz. What is the maximum voltage across the a. resistor, b. inductor, and c. capacitor in the circuit? FIGURE P33.71 Problems 71 and 72.
In the circuit shown below, S1is opened and S2is dosed simultaneously. Determine (a) the frequency of the resulting oscillations, (b) the maximum charge on the capacitor, (c) the maximum current through the inductor, and (d) the electromagnetic energy of the oscillating circuit.
The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a tuning circuit for a radio, what are the extremes that a capacitor must reach in order to cover the complete band of frequencies? Cmax = nF Cmin = n
You've decided to build a radio to listen to your favourite FM radio station, which broadcasts at 90.90 MHz. For the tuner, you'll be using an RLC circuit, but the only inductor you happen to have on hand has a value of 0.630 μH. Unfortunately, there's another radio station — which you don't want to listen to — at a nearby frequency of 90.50 MHz. To prevent any interference from this 90.50 MHz radio station, you want the peak current from it to be no more than 0.310% of the peak current from your favourite 90.90 MHz station. What value of resistor should you use in your RLC circuit? (Assume the two stations have the same strength.) Hint:You'll have to first calculate the value of the capacitor so that the radio tunes to 90.90 MHz.
An FM radio station broadcasts at a frequency of 95.5 MHz. What inductance (in uH) should be paired with a 13.0 pF capacitor to build a receiver circuit for this station?
What capacitance is needed in series with an 800−µH inductor to form a circuit that radiates a wavelength of 196 m?