The graph of one complete period of a sine curve is given. y (a) Find the amplitude, period, and horizontal shift. (Assume the absolute value of the horizontal shift is less than the period.) amplitude 4 period horizontal shift (b) Write an equation that represents the curve in the form y = a sin(k(x – b)). y =

The graph of one complete period of a sine curve is given. y (a) Find the amplitude, period, and horizontal shift. (Assume the absolute value of the horizontal shift is less than the period.) amplitude 4 period horizontal shift (b) Write an equation that represents the curve in the form y = a sin(k(x – b)). y =

Name: q5 The graph of one complete period of a sine curve is given.yX(a) Fin
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: q5 The graph of one complete period of a sine curve is given.yX(a) Find the amplitude, period, and horizontal shift. (Assume the absolute value of the horizontal shift is less than the period.)amplitude4periodhorizontal shift(b) Write an equation tha

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter3: Oscillations

Section: Chapter Questions

Problem 3.5P: Obtain an expression for the fraction of a complete period that a simple harmonic oscillator spends...

See similar textbooks

Similar questions

Plot a velocity resonance curve for a driven, damped oscillator with Q = 6, and show that the full width of the curve between the points corresponding to is approximately equal to ω0/6.
C, N A uniform plank of length L and mass M is balanced on a fixed, semicircular bowl of radius R (Fig. P16.19). If the plank is tilted slightly from its equilibrium position and released, will it execute simple harmonic motion? If so, obtain the period of its oscillation.
Allow the motion in the preceding problem to take place in a resisting medium. After oscillating for 10 s, the maximum amplitude decreases to half the initial value. Calculate (a) the damping parameter β, (b) the frequency υ1 (compare with the undamped frequency υ0), and (c) the decrement of the motion.
In an engine, a piston oscillates with simple harmonic motion so that its position varies according to the expression x=5.00cos(2t+6) where x is in centimeters and t is in seconds. At t = 0, find (a) the position of the piston, (b) its velocity, and (c) its acceleration. Find (d) the period and (e) the amplitude of the motion.
Reproduce Figures 3-10b and c for the same values given in Example 3.2, but instead let = 0.1 s1 and = rad. How many times does the system cross the x = 0 line before the amplitude finally falls below 102 of its maximum value? Which plot, b or c, is more useful for determining this number? Explain.
An object of mass m on a spring of stiffness k oscillates with an amplitude A about its equilibrium position. Suppose that m = 300 g, k = 10 N/m, and A = 10 cm. (a) Find the total energy. (b) Find the mechanical frequency of vibration of the mass. (c) Calculate the change in amplitude when the system loses one quantum of energy.
Obtain an expression for the fraction of a complete period that a simple harmonic oscillator spends within a small interval Δx at a position x. Sketch curves of this function versus x for several different amplitudes. Discuss the physical significance of the results. Comment on the areas under the various curves.
The total energy of a simple harmonic oscillator with amplitude 3.00 cm is 0.500 J. a. What is the kinetic energy of the system when the position of the oscillator is 0.750 cm? b. What is the potential energy of the system at this position? c. What is the position for which the potential energy of the system is equal to its kinetic energy? d. For a simple harmonic oscillator, what, if any, are the positions for which the kinetic energy of the system exceeds the maximum potential energy of the system? Explain your answer. FIGURE P16.73
Let the initial position and speed of an overdamped, nondriven oscillator be x0 and v0, respectively. (a) Show that the values of the amplitudes A1 and A2 in Equation 3.44 have the values A1=2x0+v021 and A2=1x0+v021 where 1 = 2 and 2 = + 2. (b) Show that when A1 = 0, the phase paths of Figure 3-11 must be along the dashed curve given by x=2x, otherwise the asymptotic paths are along the other dashed curve given by x=1x. Hint: Note that 2 1 and find the asymptotic paths when t .
A small object is attached to the end of a string to form a simple pendulum. The period of its harmonic motion is measured for small angular displacements and three lengths. For lengths of 1.000 m, 0.750 m, and 0.500 m, total time intervals for 50 oscillations of 99.8 s, 86.6 s, and 71.1s are measured with a stopwatch. (a) Determine the period of motion for each length. (b) Determine the mean value of g obtained from these three independent measurements and compare it with the accepted value. (c) Plot T2 versus L and obtain a value for g from the slope of your best-fit straight-line graph. (d) Compare the value found in part (c) with that obtained in part (b).
An automobile with a mass of 1000 kg, including passengers, settles 1.0 cm closer to the road for every additional 100 kg of passengers. It is driven with a constant horizontal component of speed 20 km/h over a washboard road with sinusoidal bumps. The amplitude and wavelength of the sine curve are 5.0 cm and 20 cm, respectively. The distance between the front and back wheels is 2.4 m. Find the amplitude of oscillation of the automobile, assuming it moves vertically as an undamped driven harmonic oscillator. Neglect the mass of the wheels and springs and assume that the wheels are always in contact with the road.
Show that, if a driven oscillator is only lightly damped and driven near resonance, the Q of the system is approximately Q2(TotalenergyEnergylossduringoneperiod)