The oxidation of ethylene to produce ethylene oxide proceeds according to the equation2C 2H 4 +O 2 ! 2C 2H 4OThe feed to a reactor contains 100 kmol C 2H 4 and 100 kmol O 2. If the reaction proceeds to completion, how much of the excess reactant will be left; how much C 2H 4O will be formed; and what is the extent of reaction?

Q: A steel cylinder containing compressed air is stored in a fermentation laboratory ready to provide…

A: Introduction-

Q: Hydrogen can be obtained from methane by the steam methane reforming reaction: CH4 + H,O CO + 3H2 A…

A: The balanced reaction given is, => CH4 + H2O ------> CO + 3 H2  Given: Basis  = 100 moles of…

Q: Suppose a sample of refrigerant gas consisting of a simple mixture of the gases pentafluoroethane…

A: In this question we will first find out the average molecular mass, given the density(d),…

Q: A new dam has been built with a reservoir capacity of 1,000,000 AF when full. The river flowing into…

A: Here there different units are given so to solve easily we convert all unit in one particular unit.

Q: Lactic acid is an important pharmaceutical product that is manufactured by fermentation of glucose.…

A: Given : Initial flow rate of mixture = 6456 Kg/hr. Initial concentration of lactic acid in mixture =…

Q: Some self-contained breathing apparati chemically regenerate oxygen using potassium superoxide. 4…

A: Given reaction:

Q: Use only the first decimal points (X.X) for atomic masses. R = 8.314 L*kPa/mole*K. In a reactor at…

A: The given reaction is: The limiting reactant can be found out by the following steps: 1. The molar…

Q: #3 acid via the oxidation of ammonia is: The first step in the reaction sequence for the production…

A: Balanced chemical equation, 4 NH3 +5 O2 ⇔4 NO + 6H2O

Q: An experiment on the growth rate of certain organisms requires an environment of humid air enriched…

A: Specific growth rate represents dynamic behaviour of microorganisms. Specific growth rate is used as…

Q: A chemical manufacturer produces ethylene oxide by burning ethylene gas with air in the presence of…

A:

Q: Feed gas containing of 78.5mol % H₂, 21% of N₂ & 0.5% of Ar is mixed with recycle gas and enters a…

A: NH3 is produced by Heber's cycle. Material balance method used here.

Q: Use only the first decimal points (X.X) for atomic masses. R = 8.314 L*kPa/mole*K . In a reactor at…

A: Given:R=8.314 L kPA/mole KMass of hydrogen=51.2 gMass of oxygen=392 g

Q: Use only the first decimal points (X.X) for atomic masses. R = 8.314 L*kPa/mole*K. In a reactor at…

A: The given reaction is: The limiting reactant can be found out by the following steps: 1. The molar…

Q: What is the final pressure, in atmospheres, when the fire extinguisher is used at a temperature of…

A: since initial pressure is not provided in the question. initial pressure of fire extinguisher at…

Q: The gas entering an NH3 reactor are in mole ratio of 4H2 :1N2 The mole ratio of the gases in the…

A:

Q: Gypsum (plaster of Paris : CaSO,. 2H,0) is produced by the reaction of calcium carbonate and…

A: Gypsum is prepared by the reaction between calcium carbonate and sulfuric acid. CaCO3 + H2SO4…

Q: An important process for the production of acrylonitrile (C3H3N) (U.S. production is greater than…

A: In this problem, we have to calculate the mass of acrylonitrile. For this, first of all, we have to…

Q: Gaseous ammonia is injected into the exhaust stream of a coalburning power plant to reduce the…

A:

Q: A 500 m2 botanical garden which harvest 1000 flowers per day of 15 variations, in a year the average…

A: You have posted multipart of question as per the guidelines i have solved first three subparts…

Q: Urea (H2NCONH2) is used extensively as a nitrogen source in fertilizers. It is produced commercially…

A: The reaction for the above process is given below. 2NH3(g)     +    CO2(g)        →∆…

Q: A fuel contains 78wt% carbon and 22wt% hydrogen (H). Combustion results in the following composition…

A: Percent by volume - CO2 = 9.41 % CO = 1.69 % O2 = 3.8 % N2 = 85.1 % In combustion there is balanced…

Q: Sulfuric acid is a very important chemical and an indicator of a nation's industrial strength. World…

A:

Q: Methods that employ separation of the product chemically through precipitation, with purification,…

A:

Q: 100 millimoles of Ethane, C2H6 underwent compkete combustion in a furnace. If dry air used in the…

A:

Q: Mass of salicylic acid: 1.00 g Mass of 50 mL beaker plus dry product: 30.6078 g Mass of 50 mL…

A: Given data,Mass of salicylic acid=1gMass of product=0.9144gLimiting reagent=salicylic acid

Q: Metabolic engineering Consider the engineering design of microbial cell culture and growth in the…

A: Given:Reaction is: C2H5OH + aO2  +  bNH3   ----->   cCH3.5N0.15O0.4  +  dH2O  +  eCO2 By mass…

Q: Long-term space missions require reclamation of the oxygen in the carbon dioxide exhaled by the…

A: The required mole ratio for the formation of CH4 from CO2 is: 1 mol CH41 mol CO2 or 11

Q: Use only the first decimal points (X.X) for atomic masses. R = 8.314 L*kPa/mole*K . In a reactor at…

A: For the reaction’

Q: A schematic flow sheet of a process is shown in figure below. The following table gives the…

A:

Q: The following coal composition was found when burnt in a furnace. C = 70.9 %/ H = 4.5% S = 0.9% N =…

A: Composition of  burnt coal: C: 70.9% H: 4.5% S: 0.9 % N: 1.8% O:  6.8% Ash: 4.4% Water: 10.7%

Q: chemical formula of the fuel burned

A: SOLUTION

Q: A gaseous fuel containing methane and ethane is burned with excess air. The fuel enters the furnace…

A:

Q: C2H4(g) + H2 (g) Catalyst C2H6 (= CH4 flows into a catalytic reactor at 28.7 14.8 kg C2 He is…

A: According to the question, Ethene is converted to ethane by the reaction: C2H4(g) + H2(g)  ---->…

Q: C6H1206(aq) 2C,H,OH(aq) + 2CO,(9) is not 100% efficient and produces many by products. The reaction…

A: Given dataMass of glucose=3.604KgMolar mass of…

Q: Calculate the partial pressure in atm of each gas in a mixture of gases. In a tank containing 16.00…

A: Calculation of no. of mol of each gas: Total mol can be calculated as follows:

Q: Using the data provided and assuming complete combustion, estimate the mass of CO2 and SO2 produced…

A:

Q: //Ethane (CnH2n+2 ) is burned with atmospheric air. The analysis of the products on a dry basis is…

A: Given in following question ethene is burned with atmospheric air given 1.CO2 =9.7% ,O2=1.7%…

Q: An underfeed stoker feeds coal to a boiler at the rate of 100 kg/hr. The ultimate analysis of coal…

A:

Q: Methanol (CH3OH) is produced in the reaction of carbon dioxide and hydrogen via the reaction and…

A: Detailed answer in step 2 and 3.

Q: only your final answer in a box whenever appropriate. Correctness of units and number of significant…

A:

Q: 1. Acrylonitrile is produced by the reaction of propylene, ammonia, and oxygen. C; H, + NH3 + 3/2…

A: 100 mol feeds gas mol C3H6=15mol NH3=15mol air=15 Note that air is 21 mol% O2, if follows that mol…

Q: 4. Producer gas from bituminous coal (see table below) is burned with 20% excess air. Calculate the…

A:

Q: Write the stoichiometric combustion equation for C7H14 with air. Assume complete combustion. Assume…

A:

Q: Question Completion Status The following process describes the complete combustion reaction of…

A:

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.