Answered: The peak current passing through an…

The peak current passing through an inductor is 2.0 A. What is the peak current ifa. The peak emf ε0 is doubled?b. The inductance L is doubled?c. The frequency f is doubled?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 83PE: (a) Find me current through a 0.500 H inductor connected to a 60.0 Hz, 430 V AC source. (b) What...

See similar textbooks

Related questions

Q: A 1.5 - kΩ resistor is connected to an AC voltage source with anrms voltage of 120 V. (a) What is…

A: a)This is an AC source. Thus the rms voltage is given by

Q: A 24.0 nF capacitor is connected across an AC generator that produces a peak voltage of 5.90 V. a.…

A: a)In capacitor, peak current and peak voltage is related as,

Q: A step-up transformer connected to a 200 V line is used to supply a hydrogen-gas discharge tube with…

A: here we use power = Vrms x Irms P = VI = constant

Q: The time constants for a series RC circuit with a capacitance of 3.50 µF and a series RL circuit…

A: Given data The capacitance is given as C=3.5 μF. The inductance is given as L = 2.10 H. a) The…

Q: 30.55 An L-C circuit consists of a 60-mH inductor and a 250-microFarad capacitor. The initial…

A: Since there are multiple subparts, we will answer the first three subparts.

Q: = 25.8 V and wd = 385 rad/s, In the figure, an ac generator with emf E = Em sin wot, where Em Is…

Q: L ll R R L + V L ell

A: Please see the answer below

Q: of 2.20 H are identical. (a) What is the resistance R in the two circuits? Ω (b) What is the…

A: Time constant for RC circuit Time constant =RC C=3.70 µF Time constant for RL circuit Time…

Q: A 10-mH inductor and a 25uF capacitor are connected in parallel. The combination is in series with a…

A: a. Here the capacitor and inductor are connected in parallel, so the effective impedance is

Q: Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 MΩ. (a)…

A: a) Characteristic time constant, τ=LR20×10-9=L5×106L=0.1H

Q: A coil of inductance 0.50 H and resistance 100 Ω is connected to a 240 V, 50 Hz ac supply.(a) What…

A: Given: Inductance, L = 0.5 H Resistance, R = 100 ohm RMS voltage, Vrms = 240 V frequency, f = 50…

Q: An RLC circuit consists of a (150 resistor), a (21 F capacitor), and a (460-mH inductor), connected…

Q: A 45.0 mH inductor has a reactance of 1.30 k. (a) What is its operating frequency? (b) What is the…

A: Hey, since there are multiple subparts question posted, we will answer three first questions. If you…

Q: An RLC series circuit has a 1.00 kΩ resistor, a 150 µH inductor, and a 25.0 nF capacitor. (a) Find…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The peak current through a capacitor is 2.0 A. What is the peak current ifa. The peak emf ε0 is…

Q: In the circuit, the capacitor is fully charged when switch ?S is closed. Calculate the time needed…

A: Energy stored in the inductor UL = 12Li2 Energy stored in the…

Q: An RLC circuit consists of an alternating voltage source with RMS voltage 120 V and frequency 60 Hz,…

Q: 4. A) Reduce the given circuit to the fewest possible components thru series/parallel combinations…

Q: 1. An inductor of 4 H and a resistor of 10 ohms are connected to a 20 V battery. The switch…

Q: An inductor that has an inductance of 14.0 H and a resistance of 40.0 is connected across a 100 V…

Q: Consider a 27 mH inductor that has a resistance of 4.25 Ω. Part (a) What is the time constant, τ,…

A: Concept We have given a LR circuit, with inductance L = 27mH = 0.027 H , and resistance R = 4.25 Ω…

Q: A 524-turn solenoid has a radius of 8.65 mm and an overall length of 13.8 cm. (a) What is its…

Q: n inductor has a peak current of 330 A when the peak potential is 2.2V at 45 MHz. What is the…

Q: A 500 mH inductor is connected across an AC generator that produces a peak voltage of 5.0 V.a. At…

A: Given: The inductance is 500 mH. The peak voltage is 5.0 V. The peak current is 50 mA.

Q: A 10-mH inductor is connected in series with a 10-ohm resistor, a switch, and a 6-volt battery. What…

Q: In the figure shown, a circuit contains two identical resistors with resistance R = 5 Q and an…

Q: For an RLC circuit in the limit of very high frequency, what is the effective behavior of the…

Q: A 15.0 mH inductor is connected across an AC generator that produces a peak voltage of 9.60 V. a.…

A: Given values:Inductance, L = 15.0 mH = 15.0 x 10-3 HPeak voltage Vo = 9.60 Hz

Q: It has been proposed to use large inductors as energy storage devices. (a) How much electrical…

Q: 6. In a LR circuit, impedance (Z) is: a. VR? + Xc? R +X |R² +(X_ - Xc} C. d. R

A: The LR circuit is a combination of the resistance and inductance in the series connection. The…

Q: A 510-turn solenoid has a radius of 8.00 mm and an overall length of 14.0 cm. (a) What is its…

Q: A 15.0 kHz, 32.0 V source connected to an inductor produces a 1.90 A current. What is the inductance…

Q: A 2.0 micronFarad capacitor has a reactance of 1.0 kohms. a) What is the frequency of the applied…

Q: A series RLC circuit driven by a source with an amplitude of 120.0 V and a frequency of 50.0 Hz has…

Q: The current in the RL circuit shown below reaches half its maximum value in 1.75 ms after the switch…

Q: If the inductance in the circuit shown below is 250mH and the current in the circuit reaches half…

Q: -mH inductor and a 25 MF (micro F) capacitor are connected in parallel. The combination is in series…

A: Given values:- Inductance,(L)=10 mH=0.01 H ----(1) Capacistance,(C)=25 μF=25 x 10-6 F ----(2)…

Q: An inductor that has an inductance of 19.0 H and a resistance of 26.0 N is connected across a 100 V…

Question

The peak current passing through an inductor is 2.0 A. What is the peak current if
a. The peak emf ε₀ is doubled?
b. The inductance L is doubled?
c. The frequency f is doubled?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) An inductor designed to filter high-frequency noise from power supplied to a personal computer is placed in series with the computer. What minimum inductance should it have to produce a 2.00 k(reactance for 15.0 kHz noise? (b) What is its reactance at 60.0 Hz?
A 7.0-mH induct is connected across a 60-Hz ac source whose voltage amplitude is 50 V. (a) What is the maximum current through the inductor? (b) What is the phase relationship between the current through and the potential difference across the inductor?
(a) What current flows when a 60.0 Hz, 480 V AC source is connected to a 0.250 (F capacitor? (b) What would the current be at 25.0 kHz?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
(a) Find me current through a 0.500 H inductor connected to a 60.0 Hz, 430 V AC source. (b) What would the current be at 100 kHz?
(a) What is the resistance of a 220-V AC short circuit that generates a peak power of 96.8 kW? (b) What would the average power be if the average power be if the voltage was 120 V AC?
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
An ac source of emf delivers 5.0 mW of power at an rms current of 2.0 mA when it is connected to the primary cod of a transformer. The rms voltage across the secondary coil is 20 V. (a) What are die voltage across the primary coil and the current through the secondary coil? (b) What is the ratio of secondary to primary turns for the transformer?