Answered: Consider a load that has an impedance…

Consider a load that has an impedance given by Z = 130 – j70 N. The current flowing through this load is I = 15/2 Z30° A. %3D

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.22P: The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is...

See similar textbooks

Related questions

Q: Estimate the Power factor of a load, by considering the impedance diagram given below. 18 Q 15 0 R…

Q: ll R=IDD C= 20 Mt 120 Vams 100 Hz Coo 20 MF ) Total Impedance d the circuit,Z+ ☺ I RMs through the…

Q: The circuit shown consists of a source driving a load that consists of the parallel connection of…

A: The circuit diagram is shown below: a) The complex power of the load A is given by the expression…

Q: In the circuit diagram given in the figure below, L=5 mH, C= 33.33 µF and R = 20 Q. For a voltage…

A: Given circuit shown with L=5 mHC=33.33 μFR=20 ΩVoltage sourcev(t)=28.3cos3000t+45° v

Q: The following information are given in the circuit shown: R = 250 ohms, L = 1.2mH, C = 1.80µF and V,…

Q: A load of 120 +j 60 is connected to a source of 120 V with a phase angle of 300, through a…

Q: The circuit shown consists of a source driving a load that consists of the parallel connection of…

A: It is given that: SA=9.216+j6.912 VAZB=42.426∠45°vt=24cos5t+30°V

Q: Three loads are connected in parallel to a 220/0°Vrms ac source. Load 1 absorbs 80kVars at 0.85 pf…

Q: In the RL circuit shown below the total series impedance is known to be R=1.0 N and L = 10.61mH. The…

A: Given R=1 ohm L=10.61 mH v(t)=20000 sin(377t+α)

Q: The below circuit is operated with driven angular frequency of wd = 120 (rad/s). The circuit has…

Q: . Given the circuit below and the associated set of voltages and currents, the reactive Power…

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with…

Q: 6. A 120Vrms 60HZ source supplies four loads connected in parallel as shown below Load 1: 150 kVA,…

Q: 2 A sinusoidal Source supplies 35 kvar reactive power to the load 2= 300-500 Determine @ Power…

Q: Find the admittance Y_ab in the circuit seen in the figure. Express your answer in both polar and…

A: given here a electrical network and asked to find the Yab .

Q: 4) Determine the real power, reactive power, apparent power, and complex power absorbed by each…

Q: 3. A 60 cycles current 2.8+j 0 flows in a series circuit having a resistance of 40 ohms, an…

Q: AC power suppye (1)3Dr(t).i(t)%3DV_I cosot.cos(of -0. power can be introduced as a function real…

A: The instantaneous power is the power at a given instant.…

Q: A capacitor that supplies 800 VARs is connected in parallel with the impedance Z=10<60° Ω. Find the…

A: An electric circuit, the transients are due to energy storing elements. If the network contains only…

Q: 2. Using the Illustration below. Compute the total impedance (Z), the total current (1), the voltage…

Q: Example: The current in a circuit is given by: i(t)=141.4 sin 377t A. Find the value of: a- the rms…

A: According to the question we have to find the value of the rms current, frequency and instantaneous…

Q: Q18. In the R-L-C series circuit shown, suppose R = 200 2, L = 70 mH, C = 2.0 μF, Vmax=80V and the…

A: As per guidelines given to us we can only provide the solution of first three subpart in multi part…

Q: The three-phase in the figure is 50 Hz, phase-to-phase 380 V, the impedance of the inductive load is…

A: It is given that; F=50Hz VL=380V Z=22.98+J19.28 Ω ϕ2=0.98

Q: A 500 MVA, 11 kV,50 Hz, 3-phase generator feeds an infinite bus with voltage of 11kV. The transfer…

Q: A circuit comprises of an impedance Z, = (2 + j0) 2 n series with the parallel combination of two…

A: In the question, Z1 is connected to series of the parallel of Z2&Z3. Total current suppied by…

Q: 11 Q 33 mH 128 322230° Z13 mH Z2 5Ω. 66 µF

A: Let the value of frequency is f = 50 Hz. The expression for the impedance Z1 is given by,…

Q: Impedances Z1 = 5.83∠- 59° ohms and Z2 = 8.94∠63.43° ohms are in series and carry an effective…

A: This a simple question of power calculation. Solution given below.

Q: The series capacitors reactive compensation methods are attractive for decreasing the power…

Q: 1 In the circuit of Figure. Z, = 60Z– 30°N · and· Z, = 40Z45°Q. %3D (1)-Find the phasors İ,,İ‚‚İ¸.…

A: Given circuit,

Q: i where z, = 6 - j28 N, = 20 - j15 SN, and Z = 150 2, z, = 24 + j60 N, z, = 6 + j8 2, z, v = 120/2…

Q: Reactance of a circuit is always expressed as real number and comprised the imaginary part of the…

A: In the question, Choose the correct option. Impedance Z= R+jX Where R resistance X Reactance

Q: 364 14.27 Three loads are connected in parallel across a Load 1: An impedance of 15 + j8 Q. Load 2:…

Q: A coil of resistance 60Ω and inductance 400mH is connected in parallel with a 15uF capacitor across…

A: Note: As per Bartleby guidelines, we are supposed to provide solution of first three sub-parts only…

Q: 1. A series combination of R = 10 ohms and L = 20 mH has a current i = 5 cos (500t + 10degrees) A.…

Q: An impedance coil is connected in parallel with a capacitance C of 12.5 μF. The input voltage to the…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: A 500 MVA, 11 kV,50 Hz, 3-phase generator feeds an infinite bus with voltage of 11kV. The transfer…

A: we need to find out maximum steady state power.

Q: one source supplies 20kVAR reactive power to the load with impedance Z=250/–75 a-)power factor…

Q: A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a…

A: Reactive power represents the stored power. An reactive power is a imaginary power whose load is…

Q: A three–branch parallel circuit, with Z1 = 25 ∠ 150 Ω, Z2 = 15 ∠ 600 Ω, and Z3 =15 ∠ 900 Ω, has an…

A: Fig: Given circuit Calculate current flowing through given loads…

Q: Ic 102 200 V 3202 Figure 1: Figure for problems 1-6 The loads Z1 = 100 + jo n and Z2 = 10 + j20 2…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 8 + 12.5 Ω www Camuto 2011 και άλλοι 15 Ω -j25 Ω The voltage V₂ is 360 at angle 0° Vrms (360 Vrms at…

A: Given circuit: Vg=360∠0° V

Q: The current in an a.c. circuit at any time 't' seconds is given by, i = 120 sin (100xt + 0.36) A.…

Q: An impedance Z(s) is subjected to an input, as shown in the following figure. As a result, the…

Q: For the circuit shown below, an impedance having a constant phase angle of -36.87° is connected…

A: The solution is given below

Q: (5) Figure below shows the RL circuit. (a) Calculate the Apparent Power S, Reactive Power Q True…

A: Solution of this question discusses about RL circuit & RLC circuit. Also, discusses the concept…

Q: For the circuit shown in the image: • What is the value of Sa, Sɛ, Sc, Sp and Srotal (give answer in…

Q: IV. A impedance of Z = 25453.13°Q is connected across a source with a voltage of 169.706 sin…

Q: Identify: a. A 40 μF capacitor is supplied with a 100 V, 60 Hz source. Find the resulting current.…

Q: tWo loads impedance 41 and Z2 in parallel. Choose the correct statement(s): Select one: O a. The…

A: If the two loads are parallel and impedance Z1 and Z2 then

Question

Consider a load that has an impedance given by Z=130−j70ΩZ=130−j70Ω. The current flowing through this load is II = 152–√∠2∠ 30∘∘ AA.

Determine the power factor.

Determine the reactive power.

Determine the power.

Determine the apparent power delivered to the load.

Consider a load that has an impedance given by
Z = 130 – j70 N. The current flowing through
this load is I = 15/2 Z30° A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is 1000 W. Determine (a) the real power absorbed by each of the impedances and (b) the source current.
1.1 We have two loads in delta and another in star in parallel, the impedances of the branches of the delta are equal and we have that RΔ=1p.u. and XΔ=0.75 p.u., while in the star we have equal values of the branches, but formed by admittances where we have the conductance in parallel GY=0.64 p.u. and inductive susceptance of BY=-j0.48 p.u. If the loads are being supplied by a positive sequence balanced three-phase source with line-to-line voltage of phases a and b of Vab=1∠ 30º, if the base values are line-to-line base voltage of 1kV and three-phase base power of 100kW. DetermineA) Line and phase voltages, line and phase currents of the load in delta, line and phase voltages of the star, line and phase currents of the star.B) Obtain separately the phasor diagram of the delta and star load with the values obtained in A), indicate on the scale that these are 1 p.u.=5cm for example.C) obtain the power triangle and the power factor separately for each load. D) Obtain the power…
Consider the current i(t)= 30sin(100t+90o) mA. is applied the circuit given below. a) Find and draw phasor equivalent of the circuit b) Find Iload and Vload phasors and and draw them on the real-imaginary axis. Find iload(t) and vload(t) via inverse phasor, comment phase angles c)Find active, reactive and complex power (P,Q,S) absorbed by the load. please fast
(a) Calculate the equivalent impedance of the circuit given below, if the source voltage is v(t) = 60cos1000t (b) Calculate the source current flowing in the circuit (c) Draw the phasor diagram of the current and input voltage
The load impedance ZL for the circuit shown is adjusted until maximum average power is delivered to ZL.1. a) Find the maximum average power delivered to ZL.2. b) What percentage of the total power developed in the circuit isdelivered to ZL?
A 25- W resistor and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor and capacitor; (c) the total current; (d) true power and capacitive reactive power; (e) apparent power, power factor, and power factor.
. Determine the capacitance value that, when placed in parallel with this load, would produce a unity power factor. Assume that the source is 230 V at 60 Hz. The Q shown is a positive Inductive reactive power, which would have to be “offset” by the same value of Reactive Capacitance Power.
in the figure below, find a) The p.d across j5 ohmn inductance b)The p.d across -j10 ohmn capacitance c) the current in 20 ohmn resitance d) the current in (12+j160 ohmn impedance e) the complex power for (12+j16) ohmn impedance
The line with symmetrical spacing then the equilateral spacing (Deq) for the three-phase inductance calculation is D12=D23=D31=D. Select one: True False
The load ZL in the circuit of Figure consistsof a 25-Ω resistor in series with a 0.1-H inductor.Assuming f = 60 Hz, calculate the following.a. The apparent power supplied by the source.b. The apparent power delivered to the load.c. The power factor of the load.
Calculate ZL for maximum average power transfer in the circuit, and find the maximum average power delivered to the load. The given answer is ZL=2-j2 Ω, PL=45 W
Consider a load that has an impedance given by Z=100-j50 Ω. The current flowing through this load is I= 152 ∠30° A. Is the load inductive or capacitive? Determine the power factor, power, reactive power, and apparent power delivered to the load.