Answered: The uniform 5-m-long round wooden rod…

The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the string. The fluid specific gravity S-0.68. D=8 cm Fluid 4 m String

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter9: Moments And Products Of Inertia Of Areas

Section: Chapter Questions

Problem 9.33P: The plane region A is submerged in a ï¬‚uid of weight density . The resultant force of the ï¬‚uid...

See similar textbooks

Related questions

Q: Note: Solve the problem as stated below. Draw the FBD. PROBLEMS Figure: 1. In the figure shown, a…

Q: HYDROSTATIC FORCE ON CURVE SURFACE AN EMPTY TANK WAS THROWN IN A BODY OF FLUID WITH sg = 0.8. IF THE…

A: In the given condition, the upward thrust of force acting on the tank due to weight of the tank…

Q: The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the…

A: the rod weight acts at the middle 2.5m from the point C while the buoyancy is 2m from C W is the…

Q: QI: In Figure below find the resultant pressure force and the depth of the centre of pressure on the…

A: GivenThe depth of the centre of pressure D=4ftCircular hole diameter d=0.9ftspecific gravity…

Q: A triangular lamina is immersed vertically in water in such a way that its 6m wide horizontal base…

Q: Ql: In Figure below find the resultant pressure force and the depth of the centre of pressure on the…

A: Dgate=4ft and dhole=.9ft since1 ft=.3048 mso Dgate=4×.3048=1.2192 m and dhole=.9×.3048=.2743 ms=.8…

Q: Air Question 5. 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of…

A: Given: Width of the gate is 1.2 m. Gauge pressure measured is -10 kN/m2. SG of oil is 0.75.

Q: 7. A diver goes to the sea and goes to a depth of 10m below sea level. If the seawater has SG 1.024,…

Q: Find the force P required to hold the gate in the position as shown in the figure. The gate is 5…

A: Given data: H=2 mR=2 mWg=5 m Need to determine the force P required to hold the gate in the position

Q: . Supposed that air (std.) has a uniform density of 1.2kg/m^3, estimate how high (meters) above the…

Q: Find a) the total force on gate AB in KN and b) the position of the center of pressure in m with…

A: First of all we need to transform the closed chamber into an open vessel, both having the same…

Q: PROBLEM 2: A rectangular plane, 1.2 m by 1.8 m is submerged in water and makes an angle of 30° with…

Q: 7. An open tank contains 5.7 m of water covered with 2.8 m of kerosene (y=8.0 kN/m³ ). Find the…

Q: Practice Problem 2: The figure shows the water pressure acting on the sides of a dam that is 20-m…

A: h=Length of the Dam=20 mq1=750 N/m2q2=1217 N/m2

Q: Pressurized water fi lls the tank in Fig. . Compute thenet hydrostatic force on the conical surface…

A: Calculate the height of the water column corresponding to the given gauge pressure shown in the…

Q: Q2: calculate the percentage of the cylinder(m=2kg) that floats in the water tank shown below if the…

Q: Compute force P (in kN) if the triangular gate is hinged at point A. Oil, SG = 0.83 3 m Im Gate 2 m…

Q: An open tank contains y1 = 8.7m of water covered with y2 = 5.7m of kerosene (y=8 kn/m^3). Find the…

Q: An open tank contains 5.8 m of water covered with 3.2 m of kerosene (y = 8). Find the pressure (kPa)…

A: Given Data - In Open tank Water up to a depth of 5.8m cover with kerosene with a depth of 3.2m The…

Q: The system in the figure is in equilibrium. Calculate the gauge pressure (P g= … kPa) measured on…

Q: The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to the floor…

Q: In Fig., the hydrostatic force F is the same on thebottom of all three containers, even though the…

A: Hydrostatic force It is the resultant force which is caused due to pressure loading acted by liquid…

Q: Derive the formula used in determining experimental hydrostatic force using the center of pressure…

A: In this experiment, when the quadrant is immersed by adding water to the tank, the hydrostatic force…

Q: [Stability] A 10-cm by 10-cm wood (sg = 0.65) with a length of 2 m is placed in water. Determine the…

A: Given data cross-section dimension of wood is 10 cm*10cm the specific gravity of wood (S.G) = 0.65…

Q: A trapezoidal plate measuring 2m at top edge and 3m at the bottom edge is immersed in water with the…

Q: In the figure below, the level of the water in the reservoir is controlled with a weightless gate,…

A: The radius of the weightless gate of quarter of a circle cross section: r = 0.5 mThe gate is hinged…

Q: Pa) that suspends the elevator car in its shaft is 2500 N. How many mm will the elevator cable…

A: To find :- Cable strech

Q: A 30-m vertical column of fluid (density = 1878 kg/m*3) is located where g = 9.65 mps^2. Find the…

Q: The tank in Fig. 2/is 3 m wide into the paper. Compute the hydrostatic (a) horizontal force…

Q: :Two plungers are installed into a tank filled in with liquid. Plunger diameters are di=40 mm and…

A: Pascal's Law: According to this law, pressure at a point in a fluid system is equally distributed in…

Q: A 10-in diameter cylinder is composed of material with specific gravity 0.8. Will it float in water…

Q: A 10cm x 10 cm x 10cm block of steel (ρsteel = 7900 kg/m3) is suspended from a spring scale. The…

Q: A car, travelling from Kangar to Padang Besar, has met an accident near the dam. The driver has…

Q: The pressure outside the droplet of water of diameter 0.04 mm is 10.32 N/cm² (atmospheric pressure).…

Q: The U pipe in the figure has a diameter of 1 cm and stands in balance as shown in the figure. When…

A: Given: Diameter of the tube D=1cm The volume of water added in the right tube V=20cm3 Relative…

Q: Air Question 5. 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of…

Q: 3.6 A 125-ml. cube of solid oak is held submerged by a tether as shown. Calculate the force of the…

Q: Find the surface tension of the water droplet of 30 mm diameter when the inside pressure is 3.5 N/m2…

A: Given Data: The radius of the water droplet is r=15 mm=0.015 m The excess pressure inside the…

Q: A cubical buoy (2 m each side) weighs 687N and is anchored to the sea floor with a cable. The buoy…

Q: Calculate the resultant of hydrostatic force on the gate. What vertical force P is necessary to lift…

A: Concepts of hydrostatic forces on submerged bodies will be used in this question. Hydrostatic force…

Q: 13)A trapezoidal plate 4 feet wide at the bottom, 7 feet wide at the top and 3 feet high is…

Q: 3. The gate shown is a quarter circle 2.5m wide. Find the force F enough to prevent rotation about…

Q: Q3) A solid wood cylinder of diameter 2 ft and height of 4 ft as shown in Fig.3,the specific gravity…

A: d=2 ft ,H= 4ft and s.gwood=.6 , and s.goil=.85 γwater=62.4 lbft2 Since weight of cylinder =wieght…

Q: 3. A fine (thin) ring with a radius 50 mm is being pulled from the surface of water. If the ring has…

Q: A cylindrical steel container 8m high and 3m in diameter is reinforced with two hoops a meter from…

A: Givendiameter=3mheight =8m

Q: Q3) A solid wood cylinder of diameter 2 ft and height of 4 ft as shown in Fig.3,the specific gravity…

A: Given: Diameter of the cylinder (D)=2ft Height of the cylinder (H)=4ft specific gravity of wood…

Q: The gate shown is 3.0 wide. Find the value of the weight required for the gate to be in equilibrium.…

A: Given data :- Length of gate (l) = 5 m Height of water(h) = 4 m

Q: ô FLUID 100cm Figure Q1b 200cm Fluid with weight of 25 kN is filled into a container of width 100 cm…

A: Given data, Fluid weight = 25 KN, width = 100 cm, We have to find density and specific weight of…

Q: A vertical plate is submerged in water and has the shape as seen in the picture. Using the facts…

A: Given data, Density of water, ρ = 1000 Kg/m3 Diameter of the circular plate, D = 20 m Radius of the…

Concept explainers

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.

Question

The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the string. The
fluid specific gravity S-0.68.
D=8 cm
Fluid
4 m
Suring
Select one:
Oa. 40.45884
O b. 26.82484
O C. 33.89684
O d. 20.09284
O e. 13.15684

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A concrete seawater dam is shown in cross section. Is the dam safe against tipping about edge A? The mass densities are 24000kg/m3 for concrete and 1030kg/m3 for seawater.
Compute the surface area of the axi-symmetric domed structure.
Using the method of composite areas, find the dimension h that maximizes the centroid coordinate y of the plane region shown.
The plane region A is submerged in a ï¬‚uid of weight density . The resultant force of the ï¬‚uid pressure on the region is R acting at the point C (called the pressure center) located at the distance h below the surface of the ï¬‚uid. Show that R=Qa and h=Ia/Qa, where Qa and Ia are the first and second moments of A about the axis a-a.
Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
Figure (a) shows the cross-sectional dimensions for the structural steel section known as C1020 (channel with a nominal depth of 10 in., weighing 201b/ft). The American Institute of Steel Construction Structural Steel Handbook lists the following properties for the cross section: A=5.88in.2,Ix=78.9in.4, and Iy=2.81in.4. If two of these channels are welded together as shown in Fig. (b), find Ix and Iy for the resulting cross section.
The parametric equations of the plane curve known as a cycloid are x=a(sin) and y=a(1cos). Use integration to find the coordinates of the centroid of the cycloid obtained by varying from 0 to 2 rad.
A 27 m vertical column of fluid (density 1878 kg.m3) is located where g= 9.65 m/sec2. Find the pressure at the base of the column.Ans. 489.313 kPa Please give me the solution.
Show the derivation of the girth and longitudinalstresses of the thin-walled cylindrical container shownbelow. Say p is the internal pressure, d is the insidediameter of the container, and t is wall thickness.
The concrete graviy" dam is heid in place by its awn weight (Egute.1) The density of concrote is pc=2.5Mg/m2 and water has a density of ρw=1.0Mg/m3. Suppose that a=1⋅m ,h=8 m Figure Part A Determinn the setillest dimension d that will prevent the dam hom overturning about is end A. Express your answer to three significant figures and include the appropriate units: d=_______
Find a) the total force on gate AB in KN and b) the position of the center of pressure in m with respect to the bottom of the pond. Assume that the gate is 8 feet wide, that 1ft = 0.3048m, and that 1 psi = 6897.1 Pa. Relative density salt water 1.025.
Answer with complete solution and a Free Body Diagram.