There are compressed 1122 lb/hr of oxygen by a 13.92" x 14", double acting, motor driven compressor operating at 100 rpm. Considering the data of the system: P1 = 14.7 Psi, T1= 106°F and P2= 45 Psi. Compression and expansion is polytropic (n = 1.31). Determine a) Volumetric efficiency b) Heat rejected c) Work

There are compressed 1122 lb/hr of oxygen by a 13.92" x 14", double acting, motor driven compressor operating at 100 rpm. Considering the data of the system: P1 = 14.7 Psi, T1= 106°F and P2= 45 Psi. Compression and expansion is polytropic (n = 1.31). Determine a) Volumetric efficiency b) Heat rejected c) Work

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A centrifugal air compressor compresses 200 cfm from 12 psia to 90 psia. The initial specific volume is 12.6 ft3/lb and the final specific volume is 3.25 ft3/lb. If the inlet suction line is 4 in. ID and the discharge line is 2.5 in. ID, determine (a) the change in flow work between the boundaries, ft-lb/min; (b) the mass rate of flow, lb/min; and (c) the change in velocity. Answer: (a) 324,000, (b) 15.88, (c) -12.9 fps
A centrifugal air compressor handles 200 cfm from 12 psia to 90 psia. The initial specific volume is 12.6 cu ft/ lb and the final specific volume is 3.25 cu ft/lb. If the inlet suction line is 4-in ID and the discharge line is 2.5-in ID, determine (a) the change in flow energy between the boundaries, ft-lb/min, (b) the mass rate of flow, lb/min, and the (c) change in velocity. (draw a diagram)
Question. A boiler unit has forced draught fan maintaining draught of 90 mm of water column while discharging 38 m/s through outlet section of 1.9m² area. Ambient temperature is 300 K and assume mass of 1 m³ of air at NTP as 1.293 kg to find out power of motor of forced draught fan if for efficiency is 80%. Determine the power consumption if FD fan is substituted by ID fan of similar efficiency considering flue gas temperature of 450 K
A single-acting, single-cylinder air compressor is rated at 4.25 m3/min of air. The suction conditions are 1 atm and 27 C and discharge pressure is 1034 kPa. The compression process follows the equation PV1.35 = A. Determine the power, in kW, required to compress the air. B.)what is the engine kW power needed to drive the unit if the combined engine-compressor efficiency is 84%? C.)if the compressor is to run two-stage at optimum intercooler pressure with perfect intercooling, what will be percentage of power saved?
From a test of an air compressor driven directly by a steam engine , the following data and results were obtained: capacity, 800 cfm; suction at 14.7 psia; discharge at 110 psia; indicated work of the compressor, 155 hp; indicated work of steam engine, 172 hp. Calculate (a) the compression efficiency and (b) the overall efficiency. Ans. (a) 90.06%; (b) 81.16% with step by step please! thanks
What is the turbine output of 100m head and delivering 1 cu. m/ sec in a hydro electric power plant if turbine efficiency is 88%?
A centrifugal pump operating under steady flow conditions delivers 2,813 kg/min of water from an initial pressure of 86,976 Pa to a final pressure of 296,902 Pa. The diameter of the inlet pipe to the pump is 19.82 cm and the diameter of the discharge pipe is 11.28 cm. What is the work in J/s?
A two stage compressor with first stage piston displacement of 94,390 cu.m/sec is driven by a motor. Motor output is 35 HP, suction temperature 22 degC, volumetric efficiency is 85%, mechanical efficiency is 95%, the intercooler pressure is 30 psi gage. Air temperature in and out of the intercooler are 105deg C and 44 degC, respectively. Final discharge pressure is 100 psi gage, while suctionis estimated to be 14.4 psi. Determine the compression efficiency.
The capital cost of a hydro-power station of 50 MW capacity is Rs 1,000 per kW. The annual depreciation charges are 10% of the capital cost. A royalty of Re 1 per kW per year and Re 0·01 per kWh generated is to be paid for using the river water for generation of power. The maximum demand on the power station is 40 MW and annual load factor is 60%. Annual cost of salaries, maintenance charges etc. is Rs 7, 00,000. If 20% of this expense is also chargeable as fixed charges, calculate the generation cost in two part form.
a. Given the static head of 28.91 m, and static pressure head of 3.15 cm WC. What is the normal pressure, Pn? b. What is the Static efficiency of the fan if the air flow rate is equal to 3.8 5m /sec, total head of 68.72 m, velocity head of 30.86 m, mechanical efficiency and power are 39.12% and 35.72 KW at 30.69°C, respectively. c. Solve for the area at entrance of the fan blade, if the it has a 346mm diameter, flow of air is equal to 23.328 m/se and flow rate of 3.05 m³ /second.
A tidal power plant of single basin type, has a basin area of 25 x 10 to power 6 m2. The tide has a range of 10m. The turbine however, stops operating when the head on it falls below 2 m. Calculate the energy generated in one filling process, in KWh if the turbine generator efficiency is 75%. (Density of sea water = 1025 kg/m2)
Water flowing at 0.5 m3/min enters the turbine of a micro-hydroelectric generator and delivers a shaft work of W= 2,500 J/kg. What is the power delivered by the generator if it works at 95% efficiency, n = 0.95?