Time t < 0, the circuit is in DC Steady State. The switch is opened instantly at time t=0. When t<0, I₂ = 7 A, and I₃ = 9 A. R₁ = 5 Ω, R₂ = 4 Ω, and R₃ = 4 Ω. The solution for I₂ is I2 = I 0 e^ − R t / L. With several resistors in the circuit, the question is, what resistance do we use for R? Answer this question (in Ohms).

Time t < 0, the circuit is in DC Steady State. The switch is opened instantly at time t=0. When t<0, I₂ = 7 A, and I₃ = 9 A. R₁ = 5 Ω, R₂ = 4 Ω, and R₃ = 4 Ω. The solution for I₂ is I2 = I 0 e^ − R t / L. With several resistors in the circuit, the question is, what resistance do we use for R? Answer this question (in Ohms).

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter21: Alternating-Current Circuits And Electromagnetic Waves

Section: Chapter Questions

Problem 16CQ: An inductor and a resistor are connected in series across an AC generator, as shown in Figure...

See similar textbooks

Similar questions

In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
An inductor and a resistor are connected in series across an AC generator, as shown in Figure CQ21.16. Immediately after the switch is closed, which of the following statements is true? (a) The current is V/R. (b) The voltage across the inductor is zero. (c) The current in the circuit is zero. (d) The voltage across the resistor is V. (e) The voltage across the inductor is half its maximum value. Figure CQ21.16
In a purely inductive AC circuit as shown in Figure P21.15, Vmax = 100. V. (a) The maximum current is 7.50 A at 50.0 Hz. Calculate the inductance L. (b) At what angular frequency is the maximum current 2.50A? Figure p21.15
In a purely inductive AC circuit as shown in Figure P21.15, Vmax = 100. V. (a) The maximum current is 7.50 A at 50.0 Hz. Calculate the inductance L. (b) At what angular frequency is the maximum current 2.50A? Figure p21.15
Consider the RL circuit in the figure with R=10.00 Ω, L1=1.80 H, L2=3.90 H, and V=5.0 V. At time t=0, the switch is closed to connect the circuit to a constant emf. How long (in seconds) does it take for the current to reach a value of Imax/2.71828 of its maximum value, where Imax is the maximum current through the circuit?
An inductor with inductance 10.23 H and a resistor with resistance 3.24 ohms are connected in series to a battery with emf of 2V. At what time (s) is the current flowing in the circuit equal to 50% of the final steady state current ( I= Emf/R)?
What is the frequency of oscillation of a DC LRC circuit with L = 5.00 H, R = 10.0 Q, and C = 0.0200 F?
The inductor has a reactance of 50 Ohm and an inductance of 220 mH. An 80-Ohm resistor and a capacitor whose reactance is 160 Ohm are also in the circuit, and the rms current in the circuit is 2.2 A. What is the voltage amplitude across the capacitor? A. 770 V B. 630 V C. 210 V D. 350 V E. 500 V
In an oscillating LC circuit with C = 64.0 mF, the current is given by i= (1.60) sin(2500t+ 0.680), where t is in seconds, i in amperes, and the phase constant in radians. (a) How soon after t = 0 will the current reach its maximum value? What are (b) the inductance L and (c) the total energy?
an rlc circuit has voltage supplied to it at a frequency of 9.0 kHz with a phase difference between the current and voltage of magnitude 0.20 rad. if the circuit capacitance is 4.0 uF and an inductance of 0.040 H, the resistance is (komega) i) 0.20 ii) 10 iii) 0.05 iv) 11
A precision laboratory resistor is made of a coil of wire. The coil is 1.3 cm in diameter, 4.25 cm long, and has 500 turns. Part (a) What is its self-inductance in millihenries? Part (b) What average emf in volts is induced if a 12.0 A current through it is turned on in 5.00 ms (one-fourth of a cycle for 50 Hz AC)? Part (c) What is its inductance in millihenries if it is shortened to half its length and its 500 turns are counter-wound (wound as two oppositely-directed layers of 250 turns each)?
In a purely inductive AC circuit as shown in the figure, ΔVmax = 100 V. (a) The maximum current is 7.5 A at 50 Hz. Calculate the inductance L. 0.0236 H 0.0424 H 0.1231 H 0.0594 H (b) At what angular frequency ω is the maximum current 2.5 A? 300 rad/sec 785 rad/sec 2,356 rad/sec 942 rad/sec