Answered: TLC technique is classified as: Select…

TLC technique is classified as: Select one: O a. Qualitative analysis technique O b. Complicated analysis technique O c. Quantitative analysis technique

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter18: Acids And Bases

Section: Chapter Questions

Problem 59A: Explain the meaning of the relative sizes of the two shaded areas to the right of the dark vertical...

See similar textbooks

Related questions

Q: Prelaboratory Assignment for Paper Chromatography 0 The 1 SAYIY

A: Note : Compound A is more soluble in mobile phase. Therefore compound A is less polar and having…

Q: Focusing Lenses Radiation Source Wavelength Selector Detector Atomizer Signal Processor Amplifier…

A: 5) The capillary column are more efficient than packed columns in GC.

Q: The following results were obtained from an analysis of copper content in four representative…

A: Accuracy relates the obtained data to its true value telling how close the true value and measured…

Q: How will mistakenly using solution 1 to calibrate the spectrophotometer, instead of the blank effect…

A: Blank solution is used to calibrate the absorbance with Transmittance(%T) and set a zero value by…

Q: 1. State the reasons for reading the absorbance of unknown against reagent water blank or against…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: economical purification technique that ca n be pure material? O Distillation O Another extraction…

Q: Which of the following matches is/are incorrect regarding the paper chromatography experiment? a.…

Q: Which of the following is not a problem with linking an MS to HPLC? Select one: O a. The inorganic…

A: HPLC means high performance liquid chromatography which is a type of column chromatography that…

Q: 3 Briefly describe the process of liquid-liquid extraction. 4 Differentiate between extraction and…

A: The process of Liquid–liquid extraction which is also known as the solvent extraction and…

Q: Mass spectrometry and UV/Vis absorbance spectroscopy can both be used as detectors for liquid…

A: Mass spectrometry is an important analytical technique that is used to measure mass to charge ratio.…

Q: How to improve the sensitivity and selectivity of AFS for Hg detection? Please explain.

A: If we increase the intensity of excitation source in AFS , high sensitivity will be…

Q: d. A 30.0 mL portion of the water sample was titrated with the standardized EDTA solution. Total…

A: The total hardness in a water sample can be determined by titrating the water sample with EDTA, and…

Q: pH has an effect on the this/these mode/s of chromatography

A: Ans: HILIC

Q: a. What does ECD mean. b. Discuss how column temperature influences separation in a chromatography…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: C. >) Order the compound A, B and C from lowest to highest Rr. The sample is spotted on a silica gel…

Q: On a 125cm retention times Long column. operated at look these. are obtained. octane 1.43 Air peak…

A: Since you have asked multiple questions we will answer the first one for you. To get the remaining…

Q: A newly synthesized drug was found to have a carboxyl group, an imide and a sulfonamide group. The…

A: Weakly acidic pharmaceutical substances are titrated effectively by making use of a suitable…

Q: The dehydration of cyclohexanol can also be monitored by reverse phese HPLC. The retention time for…

Q: A 25.00 mL sample containing an unknown amount of A13+ and Pb2+ required 20.51 mL of 0.04633 M EDTA…

Q: In spectophotometry, what will happen to the %T if the concentration is doubled?

A: Spectrophotometry is a branch of electromagnetic spectroscopy concerned with the measurement of the…

Q: What would happen to the retention time of a compound if the followingchanges were made?a. Decrease…

A: Chromatography is the technique to separate components of a mixture.

Q: föllowing analysis of a compounds (A-D) by were obtaine HPLC: Peak Retention time (min) Width of…

A: The full form of HPLC is high performance liquid chromatography. It is used to identify or separate…

Q: (c). What is the dynamic range of the method? Hint: it is NOT the entire concentration range. (d). A…

A: Atomic absorption spectroscopy is a quantitative spectroscopic method to determine the concentration…

Q: Determination of Iron Content using Flame Atomic Absorption Spectrophotometry QUESTIONS: Why is…

A: Flame atomic absorption spectroscopy is used to determine the presence of metals and metalloids in…

Q: All of the following are classified as an instrumental method of analysis EXCEPT: O A.…

A: Answer: Different methods are used In chemical analysis and they can be classified into two…

Q: Linear Regression

A: b. Make sure you choose ''linear regression'' curve fit.

Q: systematic

A: The separation of compounds under the influence of the mobile phase and the stationary phase is…

Q: Choose suitable detector when you need analyse multi-analyte with multi wavelength. O a.…

A: The detector needed to analyze multi analyte with multi wavelength is given below.

Q: The mode in liquid-liquid chromatography is all of the above a O reversed phase b O size exclusion…

A: All the Above.

Q: The retention times for A and B compounds on the 20 m capillary column are 8.04 and 8.26 min,…

Q: 6. What does a low retention factor imply in the analysis? he pigment of interest is well carried by…

A: Here, multiple questions are given. As per Bartleby guidelines, I am allowed to answer one question…

Q: create a qulaitative analysis separations flow chart for the separation of Zn2+, Al3+, Fe3+

A: The branch of chemistry which deals with the identification of elements or grouping of elements…

Q: Liquid column chromatography on alumina would separate p-nitrotoluene and p-nitroaniline O A. with…

Q: Which of the following matches is/are incorrec regarding the paper chromatography experiment? A.…

A: In paper chromatography The mobile phase is generally the solvent also called as chromatography…

Q: Which Is The Most Commonly Used Detector In High Performance Liquid Chromatography And Why

A: High Performance Liquid Chromatography is abbreviated as HPLC. High performance liquid…

Q: A 25.00 mL sample containing an unknown amount of Al3+ and Pb2+ required 19.13 mL of 0.04842 M EDTA…

Q: What would your main concern be if you accidentally used wash buffer (10mM imidazole) instead of…

A: Answer is explained below. We know that, for binding to the metal-charged resin Imidazole competes…

Q: Derivatiztion of sample is carried out to: a) Improve analyte peak shape analyte resolution b)…

A: Derivatization of sample is carried out to, (a) Improve analyte peak shape (b) Increase the detector…

Q: What four values are needed to calibrate a CO2 sensor (IRGA)? B. Briefly describe how to obtain…

A: These sensors depends on the IR light source and detects the quantity of CO2 molecules. Calibration…

Q: could products be isolated for further analysis suing TLC (thin-layer chromotography) as a…

A: Chromatography is a laboratory technique for the separation of a mixture into its components. The…

Q: Two students A, B did the Flame photometric analysis by different atomization methods in which the…

A: Flame Atomic Absorption Spectroscopy (FAAS), commonly called flame spectroscopy is a branch of…

Q: Name the ionization techniques for solid and liquid samples.

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In a chromatographic experiment, a mix of 3 compounds are separated. The following data are…

A: The mass percentage of compound C is needed to be calculated from the given chromatographic data.

Q: state/hexane, the sample showed a single spot at 3.4 cm (relative to vent had risen to 7.1 cm…

A: TLC ( thin layer chromatography) is the technique used in chemistry laboratories to identify the…

Q: a) If an unknown sample containing FeSCN2+ has an absorbance of 0.542, what is the concentration of…

A: According to Lambert-beers law : Absorbance = Absorptivity × Concentration × Path length

Q: A peak with a retention time of 10 minutes has a width at half-height of 7.6 s neighboring peak is…

Q: A 25.00 mL sample containing an unknown amount of Al and Pb* required 15.40 mL of 0.05788 M EDTA to…

Q: Comments on choice of a paper and solvent are main back bones of paper chromatography.

A: Paper Chromatography is mailny based on the choice of paper and solvent used. In this technique,…

Q: in high preformance liquied chromarography, what is a Bi phenyl , and what its application and…

A: Generally, C18 columns offer the ability to resolve a wide variety of analytes without issue.…

Concept explainers

Applications of Molecular Spectroscopy

When light sources pass through the diffraction grating then light splits into different wavelengths. The light source produces two types of patterns that are shown as destructive and non-destructive. The light source is in the form of quanta that is quantitation.

Question

242021-2020
TLC technique is classified as:
Select one:
O a. Qualitative analysis technique
O b. Complicated analysis technique
O c. Quantitative analysis technique

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Data Table 3: Complexometric Titration of Soft Water 5 ml of water 1ml of buffer Hard Water Trial 1 Hard Water Trial 2 Hard Water Trial 3 Initial Syringe Reading (mL) 1ml 1ml 1ml Final Syringe Reading (mL) 77ml 79ml 75ml Volume of EDTA Consumed (mL) .23ml .21ml .25ml Water Hardness ppm CaCO3 (mg/L) Average ppm CaCO3 (mg/L):
Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value (ET) for the quantity being sought by writing either <, >, or = on the space provided TOPIC: Determination of Molar Concentration of each component (Double Indicator Titration)1. No blank correction Ex _______ET2. Bubbles trapped in the tip of burette: EX ______ ET3. Measuring the sample volume using a volumetric pipet while looking downwards at the meniscus: EX _____ ET
hexamethylenetetramine. Qualitative and quantitative analysis?
create a qulaitative analysis separations flow chart for the separation of Sb3+ and Cd2+
4. The molar absorptivities of the indicator weak acid HIn (K_{a} = 1.42 * 10 ^ - 5) and its conjugate base In at 570 were determined as epsilon(HIn) = 7120 and ε(In) = 961. The optical length b = 1.00 cm. (a) What is the absorbance of an unbuffered indicator solution having total indicator concentration 8.0 * 10 ^ - 5 (b) What is the absorbance of a buffered indicator solution having total indicator concentration 8.0 * 10 ^ - 5 and pH = 6.5 .
Trial 1: Initial pH= 3.92mL Mass of KHP and Paper= 0.868g Mass of paper= 0.357g Mass of KHP= 0.511g Trial 2: Initial pH= 4.09ml Mass of KHP and Paper= 0.870g Mass of paper= 0.359g Mass of KHP= 0.511g 1)Use Kb, the number of moles of C8H4O4^2- at the equivalence point, and the total volume at that point to calculate the pH for each sample at the equivalence point. Compare these calculated results with the experimental results.
How does diphenylamine sulfonate indicator work? What chemical reaction causes the color change?
Data Table 3: Complexometric Titration of Soft Water 6ml of water used (1ml of buffer and 5ml of soft water) Hard Water Trial 1 Hard Water Trial 2 Hard Water Trial 3 Initial Syringe Reading (mL) 1ml 1ml 1ml Final Syringe Reading (mL) 77ml 79ml 75ml Volume of EDTA Consumed (mL) .23ml .21ml .25ml Water Hardness ppm CaCO3 (mg/L) Average ppm CaCO3 (mg/L):
Answer the following question. DRAW THE TITRIMETRIC PROFILE for better understanding
What is a Zimm plot?
19,20 plzz
The water hardness of tap water has been determined to be 120 (= 120 mg CaCO3 per 1 L of water). After the tap water has run through the ion exchange column, titration of a 20.00 mL sample used only 0.70 mL of 0.0100 M EDTA, to reach the endpoint. Calculate the effectiveness of the ion exchange column: what is the % of the calcium, removed by the ion exchange column? Provide your answer in % and without decimal. ( Please type answer note write by hend)