Two containers A and B of volume V are connected by a thin tube. A cock is equipped in the thin tube, and is closed initially. A gas of a pressure P and a temperature T is contained in the container A, and a gas of a pressure 2P and a temperature 37 is contained in the container B. Exchange of thermal energies between the gas and the containers may be ignored. The volume of the thin tube may be ignored. The gas may be considered as an ideal gas composed of monatomic molecules. The universal gas constant is denoted as R. Answer the following questions. A 2P 3T B++ PT V Fig. 4 V

Two containers A and B of volume V are connected by a thin tube. A cock is equipped in the thin tube, and is closed initially. A gas of a pressure P and a temperature T is contained in the container A, and a gas of a pressure 2P and a temperature 37 is contained in the container B. Exchange of thermal energies between the gas and the containers may be ignored. The volume of the thin tube may be ignored. The gas may be considered as an ideal gas composed of monatomic molecules. The universal gas constant is denoted as R. Answer the following questions. A 2P 3T B++ PT V Fig. 4 V

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter2: Steady Heat Conduction

Section: Chapter Questions

Problem 2.33P

See similar textbooks

Similar questions

2.15 Suppose that a pipe carrying a hot fluid with an external temperature of and outer radius is to be insulated with an insulation material of thermal conductivity k and outer radius . Show that if the convection heat transfer coefficient on the outside of the insulation is and the environmental temperature is , the addition of insulation actually increases the rate of heat loss if , and the maximum heat loss occurs when . This radius, is often called the critical radius.
2.2 A small dam, which is idealized by a large slab 1.2 m thick, is to be completely poured in a short Period of time. The hydration of the concrete results in the equivalent of a distributed source of constant strength of 100 W/m3. If both dam surfaces are at 16°C, determine the maximum temperature to which the concrete will be subjected, assuming steady-state conditions. The thermal conductivity of the wet concrete can be taken as 0.84 W/m K.
How long should it take to boil an egg? Model the egg as a sphere with radius of 2.3 cm that has properties similar to water with a density of = 1000 kg/m3 and thermal conductivity of k = 0.606 Watts/(mC) and specific heat of c = 4182 J/(kg C). Suppose that an egg is fully cooked when the temperature at the center reaches 70 C. Initially the egg is taken out of the fridge at 4 C and placed in the boiling water at 100 C. Since the egg shell is very thin assume that it quickly reaches a temperature of 100 C. The protein in the egg effectively immobilizes the water so the heat conduction is purely conduction (no convection). Plot the temperature of the egg over time and use the data tooltip in MATLAB to make your conclusion on the time it takes to cook the egg in minutes.
Q4. Two long rods of the same diameter, one of brass(k= 85 W/mK) and the other of copper (k=375 W/mK) have one of their ends inserted in a furnace and the other ends exposed to the same atmosphere. At a distance of 105mm away from the furnace, the temperature of the brass rod is 120' C. Find the distance from the furnace in which the copper rod have the same temperature.
1. 4000L/hr of distillates are cooled from 21 to 12 degrees Celsius, and wax is separated 12% by weight at 15 degrees Celsius. Oil has a specific heat of 2kJ/kg C and a specific gravity of 0.87. The latent heat of fusion is 290kJ/kg, and the specific heat of wax is 2.5. Allow 10% for losses and calculate the refrigerating machine's capacity in TOR.
A closed stirred-tank reactor with two compartmentsis shown in Fig. The basic idea is to feed the reactants continuously into the first compartment, where they will be preheated by energy liberated in the exothermic reaction,which is anticipated to occur primarily in the second com-partment. The wall separating the two compartments is quite thin, thus allowing heat transfer; the outside of thereactor is well insulated; and a cooling coil is built intothe second compartment to remove excess energy liberated inthe reaction. Both tanks are completely full at all times.Tests are to be conducted initially with a single-component feed (i.e., no reaction) to evaluate the reactor’s thermalcharacteristics.(a)Develop a dynamic model for this process under the conditions of no reaction. Assume that q0,Ti,andTc all may vary.(b)Make a degrees of freedom analysis for your model—identifying all parameters, outputs, and inputs that must beknown functions of time in order to obtain a solution.(c)In…
i) Determine the cutoff ratio. ii) Determine the heat rejection per unit mass. iii) Determine the thermal efficiency.
find the driving pressure for a stack that has a height of 18 m and carry a hot gas mixture with an average density of 1.2 k/m3. If you know that the total heat rejection by the stack is 1450 KJ and the c, of the hot gas is 1.8 KJ/Kg.K while the hot gas inlet and outlet temperature are 650 K and 500 K respectively. Assume the hot gas pressure as 2.3 bar while the ambient pressure is 1 bar.
The walls of the flat furnace are connected by two insulating layers A and B. The temperature of the insulating layer A facing the inside of the Furnace is 800°C and the temperature of the outside air is 60°C. Find the temperature of the interface between the two insulation layers when the thickness of insulation layer A is 150 mm, its thermal conductivity is 0.05 W/m℃, the thickness of insulation layer B is 240 mm, and its thermal conductivity is 0.15 W/m℃
A child opens the door of the freezer that is turned off, to observe its operation. If the ambient temperature is 30°, what will be the behavior of the internal temperature of the freezer when it is opened and why? a. does not change, since there is no material between the environment and the interior of the freezer for heat exchange b. is increasing, because the convection between the environment and the air inside the refrigerator does not transfer heat from the outside to the center c. does not change, since there is no contact between the surface of the meat and the external environment d. increases, because sunlight falls on the meat, increasing the energy. Then, when turning on the freezer again, it is observed that the back of the freezer gradually warms up, and remains warm during the operation of the machine. The amount of thermal energy emitted by the freezer must be: a. equal to 0; the heating is due to a problem with the freezer b. Less than the energy drawn from inside the…
An engineer receives a schematic fora reversible heat engine with three reservoirs at the temperatures shown to the right. The heat engine produces 1800 kW work as it pulls 3200 kW of heat from the 600K reservoir. The engineer wonders if the schematic is drawn correctly (in other words, are the arrows going the correct directions?) To answer this question, (a) calculate the heat interactions of the HE with the other two reservoirs. (b)If necessary, draw an updated diagram with the correct directionalities indicating the rates of heat transfer.
Q5Two large containers A and B of the same size are filled with different fluids. The fluids in containers A and B are maintainedat 0° C and 100° C, respectively. A small metal bar, whose initial temperature is 100° C, is lowered into container A. After1 minute the temperature of the bar is 90° C. After 2 minutes the bar is removed and instantly transferred to the othercontainer. After 1 minute in container B, the temperature of the bar rises 10°. How long, measured from the start of theentire process, will it take the bar to reach 99.9° C?