Answered: V1 = 150(0.5+j0.866) V 150 j150 V2 =…

Engineering

Electrical Engineering

V1 = 150(0.5+j0.866) V 150 j150 V2 = 180(1-j) V Find the phase angle of current 'T with respect to voltage V2.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.11MCQ: The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said...

See similar textbooks

Related questions

Q: 2. Find the rms value of Hhe current wareform vhown below. i, A 10 T- 88- 4 t, s 14

Q: Problem 1 [5+5] Find the phase difference between these two. Also mention which one is leading. I =…

Q: Using i(t)=2 sin(wt) as a reference, sketch the voltages given on single phasor diagram,…

A: The following voltages are- v(t)=10sin(wt+56∘) v(t)=7.5cos(wt+25°) the following are the phasor…

Q: Given: R, X1, X3. ーjX。 10 A jX1 jX1 08 Determine I,. Give your answer in rectangular form. 09…

Q: j16 Ω 8 Ω 10 Ω 2Ω ww -j5 Ω Figure 1 -j4Ω Vs rms

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin400Ot) Volt is applied to the circuit…

A: The total current supplied by the source is calculated as iT=eTzT where zT is the total impedance of…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

Q: A voltage of 2500 is applied to an inductive circuit of impedance (5+j10)Q Determine circuit current…

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: A sinusoidal source is v(t)=2 sin 500t. Determine the Vmax.

Q: Compute the reactive power for -j25Ω with a voltage source, Vg = 240∠0⁰ (rms)

A: To find reactive power by -j25 ohm

Q: What is the value of the equivelent impedance? 250 j150 30 2 202 j102 0.46+0.21j None of the answers…

Q: A 30 Ω resistor , a 40 Ω inductive reactance, and a 60 Ω capacitive reactance are connected in…

Q: *30. Find the average power loss and power factor for each o the circuits whose input current and…

A: In this question voltage and current is given....We have to find out average power and power…

Q: •1 www 50 0-01 H

Q: Determine the PHASOR values of V1. 20/60° V Vị V2 15/0° V j42 2Ω

A: Nodal Analysis - It is used to find node voltage using Kirchhoff's current law. Kirchhoff's current…

Q: Convert the following to their phasor equivalent values type "cis" instead of the symbol "Z" e.g.…

Q: Kr=0.31+jo.31 and Zo=50 Using the law below find the Value of Zv Zr Kr= Zr-20 Zr + Zo

A: We need to find out the value of load resistor for given reflection coefficient

Q: A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t-0.5sin4000t) A is applied to the…

Q: Given the following currents: i 1 = 25 cos(wt + 30°); i 2 = -15 sin(wt – 30°); i 3 = -35cos(wt +…

A: In this question We need to Determine the equation of the resultant current using only function of…

Q: 62 Find power factor of given circuit ww- 30/0° V rms

Q: What is the value of the equivelent impedance? 250 j1SA w m 302 20 j102 51.09 +9.8j 0.46+0.21j…

A: Choose the correct option Find the equivalent impedance across the terminal as shwon in the figure.…

Q: If the frequency were doubled, what would be the new impedance? R www R = 121 ohms XL = 41 ohms Xc =…

A: given here a circuit of RLC series circuit and asked to find the impedance of the circuit when…

Q: Determine the voltage Vo in the circuit below. j12 42 ww 100/45° V j82 10Ω V,

Q: Use the results of Problem 5 to find the value of phase o that minimizes the (peak value of) current…

A: The solution is given in picture

Q: A non-sinusoidal voltage (e=20+15sin2000t+ 10sin6000t+5sin8000t) Volt is applied to the circuit…

Q: Problem 8: For the circuit shown below, determine the real, reactive and apparent power for each…

A: Here first we Apply KVL and find corresponding voltages across the elements and common current in…

Q: State which one is leading by determining the phase angle between the two sinusoids below. V1 = -10…

Q: Q1: (A) In AC circuits the phase difference between the current and voltage waveforms is very…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: For the circuit shown, determine the current through the 2+j5 ohms impedance. 1 jsn 252 um 2 •…

A: The detailed solution is provided below.

Q: Jetermine the voltage V, in the circuit shown below j32 j20 j6N Vo 10V j42 12

Q: j22 -j62 4Ω V /0° V j82 j10 Ω j42 For the circuit shown, if V=259, the value of reflected impedance…

A: First we have to obtain equivalent circuit of given magnetic coupled circuit as shown in figure…

Q: Impedances Calculate the impedance between points A and B. -j20 ww 102 -j 30 HH j20 ww 30 -j5n ww…

A: Series addition of impedances: Zeq=Z1+Z2 Parallel addition of impedances: Zeq=Z1×Z2Z1+Z2

Q: 640 Ω 8.02-15° kV -j1600 2 j960 2 Given: A 8 kV circuit has a load consisting of 640 N of resistance…

A: The circuit diagram is: The equivalent impedance of the circuit is determined as follows:

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is ?applied to the circuit…

A: For this problem first we need to find RMS value of voltage and then current.

Q: = (13 - j7.5) ohms, Z, = (R + j10) ohms. Determine the value of Rif the power factor is: (a) 1; and…

Q: In the circuit shown in figure beside, (i=5+20sin1000t+ 10sin2000t+5sin3000t) Amp. Wnte the…

Q: Q1/ Determine the voltage V, in the circuit shown below j32 j22 10V -j42 Vo

Q: Problem 8: For the circuit shown below, determine the real, reactive and apparent power for each…

A: Calculate current I, I=2402∠600-2802∠300(5+8j)I=20.99∠93.02 A For element 5 ohm, S5Ω=|I|2R+j0…

Q: D2 SI D1 D3 V1 VSINE RL ZS D4 K ZENER v1 = + 19 V, R = 3 kQ, RL = 13,7 and zener voltage 5,1 What is…

A: Since in the negative cycle the germanium diode becomes reverse biased so ooen circuited means no…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

A: Given:- e=20+15sin1000t+10sin3000t+5sin4000t Formula used:- Power :-V2Z

Q: What is the phase difference between the following pairs of voltages and currents? Draw them on a…

A: Note :As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: Two branch currents in a network are known to i¡ (t) = 4.5 sin (600t +45°) A, i2 (t)=2 cos (600t…

A: To know the phase difference between the two given currents, we have to convert both either to sine…

Q: For the circuit below, find the complex power delivered by the source (separate magnitude and angle…

Q: 17 For the circuit shown below, the value of the phase current la is.A. Take Van as your reference.…

A: Three phase circuit

Q: Referring to the circuit shown below, determine the following: (a) The voltage between points e and…

Q: For the circuit shown below, detemine the voltage of the -j10 2 capacitive reactance. -js a jl0n…

Q: SQ j100 ww 20 wwo 60/120° V j202 15.9-16.9j -89.5+59.1j -20+87.7j None of the answers

Q: j40 4Ω -j 102 v /0° V j82 Esa (1) 10 2 V. For the circuit shown, if V-205, the value of reflected…

A: In the circuit shown below

Q: DIRECTIONS: Draw the following sinusoidal waveforms: 1. e= 220sin(ωt -500) 2. i = -30 cos (ωt + π/4)…

Question

V1 = 150(0.5+j0.866) V
150
j150
V2 = 180(1-j) V
Find the phase angle of current 'T with respect to voltage V2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The power factor for a capacitive circuit (R-C load), in which the current leads the voltage, is said to be (a) Lagging (b) Leading (c) One
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
When you are converting an instantaneous current to a phasor, how does the phase angle being positive or negative affect solving the problem i.e. the representation being (wt - the phase angle in degrees) or (wt + the phase angle in degrees)?
For the circuit below in phasor form with R1 = 13Ω, X1 =-7, A=8 and B=39, calculate the average power dissipated in the circuit in Watts.
Find the phase angle between i1 = -4 sin (377t + 55) and i2 = 5 cos (377t - 65). Indicate whether i1 is leading or lagging behind i2. And also, if v1 = -10 sin (ωt - 30) V and v2 = 20 cos (ωt + 45) V, find v1 + v2.
Impedances Z1 = 5.83 at angle of -59 deg. and Z2 = 8.94 at an angle of 63.43 deg. are in series and carry an effective current of 5A. Determine the Power and power factor of the circuit indicating if it is leading or lagging.
An alternating voltage is given by v-80 sin(345t + 4) volts. Find (i) RMS value (ii) frequency (iii) Phase angle (0) in degrees if the instantaneous value is 20 V at t = 6 ms. (iv) Instantaneous value of voltage for the sin(345t) at 6 ms. (V) Draw the waveform for the equation 80 sin(345t) at least one complete cycle showing important points.
The signal V1=100 cos(500t - 30°) and the signal V2=20 sin (500t +45°) compared in phase would be a) V1 15° ahead of V2 b) V1 75° behind V2 c) V2 15° ahead of V1 d) None of the above
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
A 15ohms resistor connected in parallel with an impedance of 8 - j2 across an AC source. The entire circuit takes a total average power of 2000 watts. What is the average power in the 15ohms resistor?
In the series RL circuit of figure shown, the sinusoidal source is given by v = 100 sin (500t + Φ) volts. Determine the resulting current if the switch is closed when Φ = 0. Electrical
Find the sum of the voltages and its phase angle and the angle difference of e1=-12 cos wt + 50oV and e2=15 sin wt - 10oV Answer: et= 26.09∠23.60o V θpd=e2 leads e1 by 30o or θpd=e1 leads e2 by 30o