water flows through a horizontal venturyi meter whose inlet diameter is 33 cm. and throat diameter is 21 cm. the pressure at the inlet is 775 kpa and at the throat is 584 kPa. determine the discharge in L/s. ne

water flows through a horizontal venturyi meter whose inlet diameter is 33 cm. and throat diameter is 21 cm. the pressure at the inlet is 775 kpa and at the throat is 584 kPa. determine the discharge in L/s. ne

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A 90-cm ID pipeline (f = 0.020) of length 3000 m connects a reservoir whose water surface elevation…

Q: A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450 mm at…

A: Given data Specific gravity(SG) = 0.877 Diameter at section 1 = 150 mm Diameter at section 2 = 450…

Q: Water is delivered through a horizontal 20-cm-diameter pipe at a flow rate of 0.5 m3/s. If a…

A: Answer: The pitot probe positioned downstream of the manometer would indicate a pressure of 176.65…

Q: C2. A conical tube is fixed vertically with its smaller end upwards and it forms a part of the…

A: Since you have asked multiple subparts, only the first three subparts are solved for you. If you…

Q: Which of the following head is neglected in ideal Bernoulli's Energy equation O 1. Head loss due to…

Q: eter is A petroleum product is pumped at a rate of 2.32 x 10'm/s from a reservoir under atniospheric…

A: Given: The flow rate, Q = 2.32 x 10-3 m^3/s The height to be pumped, hd = 177 cm = 1.77 m The pump…

Q: Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and…

A: Given: Flow rate, Q=12 L/s Inlet diameter of venturimeter, D=4 cm Throat diameter of venturimeter,…

Q: the flow rate in each pipe (+ is out and - is into the reservoir) Assume hA = 60 m, hg = 90 m, hc =…

A: To given…

Q: i. Water is flowing through a pipe having diameters 30 cm and 15 cm at the bottom and upper end…

A: To obtain the solutions of the above question, we must apply two equations which are- 1. The…

Q: From the figure, find the flow rate of water flowing into the atmosphere, given H = 30 m, and give…

Q: (a) A pump draws water (50°F) from a reservoir, where the water-surface elevation is 520 ft and…

A: The overall pressure losses incurred by the fluid as it moves from the suction point to the…

Q: Water is flowing in a conical tube. the inlet conditions are D=100mm, v=1m/s & density = 1000kg/m3.…

Q: A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450mm at…

A: Given, Q=150 lit/secS.G=0.877d1=150 mmd2=450 mmz1=0z2=3.6 mp1=90 kPap2=60 kPa

Q: 1. Water flows through a venturi meter. At the constricted section where the area is 24cm², the…

A: Given data:-Area at section 2-2, a2=24cm2=0.0024m2Pressure at section 2-2,…

Q: Q1: A pipe connecting a reservoir to a turbine which discharges water to the down through another…

Q: Water flows downwards in a vertical pipeline of gradually varying section from point 1 to point 2,…

Q: Determine the head loss in a pipeline with friction factor of 0.01, length of 0.8 km, diameter of…

A: Given data: friction factor (f) = 0.01 Length (L) = 0.8 km Diameter (D) = 0.9 m Speed (V) = 8 m/s

Q: A turbine installed below the free surface of a large reservoir filled with water of density 1000…

Q: The water system in a suburban area consists of an old 200mm pipeline 760m long which conveys water…

A: Given data: The diameter of the old pipe is D1=200 mm=0.2 m The length of the pipe is L=760 m The…

Q: Using the pump selection table below to determine the best pump for the given condition: • A flow of…

A: Option ( C ) is correct 100-80/20

Q: Water flows through a venturi meter whose inlet diameter is 31 cm and throat diameter is 19 cm. The…

A: Given:Inlet diameter, d1=31 cm or 0.31 mthroat diameter, d2=19 cm or 0.19 mInlet pressure, P1=755…

Q: Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and…

A: Q. Flow rate Q=12 LS=12×10-3 m3SInlet diaD=4.0 cm=4×10-2 m;& throat dia d=35cm=3.5×10-2…

Q: 1. A pipe carrying oil of specific gravity of 0.877 changes in size from 150 mm at section 1 and 450…

A: GivenS.G=0.877d1=150mmd2=450mmZ2=3.6mP1=90kPaP2=60kPaQ=150L/s=0.150 m3/s

Q: Water flows through a horizontal Venturi meter whose inlet diameter is 31 cm. and throat diameter is…

Q: A 15-cm pipeline, 730 m long, has its discharge end 6 m below the water surface in the reservoir…

Q: A Francis turbine is installed with a vertical draft tube. The top of the draft is 1 m below…

A: Given:- Tailrace water level=3m Elevation of water, Z1-Z2=50m Discharge, Q=2.5m3/sec Velocity,…

Q: Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and…

A: Given: The flow rate is 12 L/s. The height of water column are: L1=74.6 cmL3=50 cm

Q: In a Francis turbine, the pressure gage in the turbine casing reads 480 kpa. The elevation above the…

A: The pressure gage in turbine casing, P = 480 kPa The elevation above the tailrace to the center of…

Q: Water at 20°C is flowing through a horizontal nozzle at a flow rate of 0.005 m3/s. At the nozzle…

Q: Q2. The turbine shown in figure 2 develops 3000 kW when the water flowrate is 24 Is. The head loss…

Q: Explain how flow rate is measured with a turbine flowmeter, and discuss how they compare to other…

A: For measuring flow rate we have many flow meter and one of them is Turbine flow meter. As from the…

Q: Water flows through a horizontal verturi meter whos inlet diameter is 31 cm and throat diameter is…

Q: For the same velocity, the entrance loss is of exit loss in the constant diameter pipe O 0.5 times O…

Q: hydroelectric power generating system is shown in the figure. Water flows from an upper reservoir to…

A: Given:Discharge, Q=286 L/sQ=0.286 m3/sPipe length, L=186 mPipe diameter, d=346 mm or 0.346 mHazen…

Q: Water is to be siphoned from a tank at the rate of 0.095 m3/s. The flowing end of the siphon pipe is…

A: Given: the flow rate of water, Q=0.09 m3s Head load from the summit to end, hf2-3=1.25V22g Heat loss…

Q: Water is flowing in a conical tube. the inlet conditions are D=100mm, v=1m/s & density = 1000kg/m3.…

Q: C2. A conical tube is fixed vertically with its smaller end upwards and it forms a part of the…

A: As per bartleby guidelines we are allowed to solve only 1st 3 subpart of a question. Please post…

Q: Water flows at the rate of 0.015 m/sec from open reservoir A to open reservoir B (both are large…

A: Given: The flow rate of the water is 0.015 m3/s. Dimensions of the pipes are: L1=800 mD1=16 cmL2=200…

Q: Water flows through a horizontal verturi meter whose inlet diameter is 31 cm and throat diameter is…

Q: A conical tube is fixed vertically with its smaller end upwards and it forms a part of the pipeline.…

A: Given: D1 = 245 mm D2 = 467 mm L = 1.8 m Q˙= 128 litres/s = 0.128 m3/s

Q: Water is flowing in a conical tube. the inlet conditions are D=100mm, v=1m/s & density = 1000kg/m3.…

Q: Q3. Water enters a tank of diameter DT steadily at a mass flow rate of min. An orifice at the bottom…

A: Drawing the figure as shown below - In sections 1 & 2 the tank is open to atmosphere and…

Q: Water enters a tank of diameter D7 steadily at a mass flow rate of m: An orifice at the bottom with…

Q: A Francis turbine is installed with a vertical draft tube. The top of the draft is 1.0 m below the…

A: Given Data The head of the water elevation is: Hw=50 m The height of the water level is: HT=3 m The…

Q: The water system in a suburban area consists of an old 200mm pipeline 760m long which conveys water…

Q: a fan draws 1.42m3 per second of air at a static pressure of 2.54 cm of water through a duct 300 mm…

A: Determine the static head by using the below expression. Here γw is the specific weight of water,…

Q: A 90-cm ID pipeline (f = 0.020) of length 3000 m connects a reservoir whose water surface elevation…

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: 3.82 JP-4 fuel (SG = 0.77) flows through the Venturi meter shown in Fig. P3.82 with a velocity of 15…

A: Calculate the velocity using continuity equation, A1V1=A2V2 π4d12V1=π4d22V262×15=42×V2V2=33.75 ft/s

Q: Find the velocity of flow in pipe in m/s.

A: Flow = area * velocity

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450mm at section 2. Section 1 is 3.6 m below section 2 and the pressures are 90 KPa and 60 KPa, respectively If the discharge is 150 lit/sec, determine the head lost and the direction of flow.
Water flows through a horizontal verturi meter whose inlet diameter is 31 cm and throat diameter is 19 cm. The pressure at the inlet is 755 kPa and at the throat is 550 kPa.Neglecting head lost. Determine the velocity in the throat in m/s
A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450 mm at section 2. Section 1 is 3.6 m below section 2 and the pressures are 90 KPa and 60 KPa, respectively. If the discharge is 150 lit/sec, determine the head lost and the direction of flow.
Water flows through a venturi meter whose inlet diameter is 31 cm and throat diameter is 19 cm. The pressure at the inlet is 755kPa and at the throat 550 kPa. Determine the discharge in cumecs. Neglect head loss.
Water flows through a horizontal Venturi meter whose inlet diameter is 31 cm. and throat diameter is 19 cm. The pressure at the inlet is 755 kPa and at the throat is 550 kPa. Neglect head lost. Determine the velocity in the throat, in m/s. Round off to three decimal places.
Calculate the total head of the system below. Assume a flow of 70 m³/h and that the pressure drops in the suction and discharge are 3 m and 4 m, respectively. ZA = 15m, ZB = 5m and ZC = 5m.
Water flows through a horizontal Venturi meter whose inlet diameter is 33 cm. and throat diameter is 21 cm. The pressure at the inlet is 770 kPa and at the throat is 585 kPa. Determine the discharge in L/s. Neglect head lost. Only accepted answer is 728.658. Show solution.
Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level inside the tank remains constant at 3m and the pressure at the top of the tank is 30KPa. If the jet strikes the ground horizontally by 4.5m and below the vena contracta by 1m, determine the coefficient of velocity.
O1: A stream of water of diameter d = 0.1 m flows steadily from a tank of diameter D= 1.0 m. Determine The Weight Flowrate, needed from the inflow pipe if the water depth remains constant, 0 — d=010m
A diverging tube discharges water from reservoir at a depth of 10m below the water surface. The diameter of the tube graduallyincreases from 150 mm at the throat to 225 mm at the outlet.Neglecting friction, determine the maximum possible rate ofdischarge through this tube.
A water turbine operating at 85% efficiency is under a head of 100 m. If the constant discharge is 1000 gallon/sec, evaluate the operating speed of the turbine.
A U-tube acts like a water siphon. The elbow in the tube is 1 m above the water surface, the tube outlet is L from point A below. When the length L is 5 m, the water emerges from the bottom of the siphon as free jet at atmospheric pressure. Determine the speed of the free jet and the minimum absolute pressure of the water at the elbow. (Patm= 101325 Pa, dsu=1000 kg/m3)