Find the velocity of flow in pipe in m/s.

Q: Water is flowing steadily through a closed pipe system of constant diameter. Station 2 is 1 m higher…

A: Given data: The height of station 2 is, z2 = 1 m. The velocity at station 1 is, v1 = 3 m/s. The…

Q: Problem Solving: Input your final answer on the space provide. Water flows through the piping…

A:

Q: For the water shooting out of the pipe and nozzle as shown in Fig. find 1- the flow rate (Q) through…

A: (1) To find: The flow rate through the pipe. Given: The diameter at A is DA=200 mm. The diameter at…

Q: What power can be delivered by the turbine if its efficiency is 100%? The water flow rate is 0.01…

A: Q=0.01m3/shL=13.0 mρ=1000kg/m3μ=0.001kg/m.s

Q: EL:5.50m EL:4.00m Tank-A EL:1.00m- A siphon consist a 15 cm diameter of pipe which is used to empty…

A: To calculate the required result in this question, we must apply the Bernoulli's equation which is…

Q: Water flows through the elbow. It exits to the atmosphere at section 2. The inlet and exit pipe…

A: solution is given below.

Q: Inlet and throat diameters of a horizontal venturimeter are 350 mm and 150mm respectively. The…

A:

Q: Water flows downwards in a vertical pipeline of gradually varying section from point 1 to point 2,…

A:

Q: Water flows from a tap at a pressure of 250 kPa above atmospheric prrssure. What is the velocity of…

A: Use Bernoulli equation to determine velocity of jet Assumptions V1 is negligible Z1=Z2 P2 =…

Q: Q.1 Water enters a pump impeller radially. It leaves the impeller with a tangential component of…

A:

Q: A fan draws 1.42m3 per second of air at a static pressure of 2.54 cm of water through a duct 300 mm…

A: Given Data ⇒ Discharge of fan (Q)=1.42 m3s Static pressure (P)=2.54 cm of water Diameter of the duct…

Q: (b) Two reservoirs are connected by a pipeline consisting of pipe 1, pipe 2, pipe 3 connected in…

A: Given: Length of the pipe 1→L1=170 m Length of the pipe 2→L2=300 m Length of the pipe 3→L3=210 m…

Q: A fire brigade pump delivers water through a hose of 200 m length and 8 cm diameter to a nozzle…

A:

Q: Q2- Water ( p= 990 kg/m' & u= 0.001 pa.s) is pumping from a water tank to water injection well with…

A:

Q: Show in Figure 1 is the water flow system. The velocity head difference is = 2.0m. Volume flow rate…

A: Given data as per the question velocity head =2 m volume flow rate =0.5 m3/s h1 =1 m h2 =2 m hA = 3…

Q: Shown below is an inverted U-tube which is used to drain alcohol from a tank reservoir. The bend of…

A:

Q: Water flows upwards in a vertical pipeline of gradually varying section from point 1 to point 2,…

A:

Q: Find the flow rate in pipe (kJ) if the temperature difference is (10 C) 2.2 kW 1.7 kW F E M 1.7 kW…

A:

Q: . A pressurized tank discharges to the atmosphere. Determine the initial discharge rate. 450 kPa h=…

A:

Q: The maximum allowable volume flow rate, in liters / s, of water at 20C that must be delivered…

A:

Q: A large tank discharges water through an orifice of 5 cm diameter at its bottom as shown in Fig.…

A: Given data:-theoretical diameter, dth=5cm=0.05mactual diameter, dact=4.95cm=0.0495mdepth of water,…

Q: Water at 20°C and p = 998 kg/m³ flows through a 5-cm-diameter pipe that has a 180° vertical bend, as…

A:

Q: ztion XVII: A reservoir leads to 8 nozzles whose elevation is 210 m below that of the reservölf The…

A: Given: The number of nozzles, n = 8 The elevation of nozzle, z = 210 m The diameter of pipe, D = 1.8…

Q: Air flows isentropically from the reservoir where p=300 kPa, and T= 500 K, to section 1 of the…

A:

Q: vertical draft tube. The top of the draft is 1 m below the centerline of the spiral casing while the…

A:

Q: Q3: Water (p= 990 kg/m³ & μ= 0.0013 Pa.s) is pumping from an atmospheric water tank to wa with…

A:

Q: The initial condition of air in an air compressor is 97 kPa and 27 oC and discharges air at 350 kPa.…

A: Given Data The initial pressure is: P1=97 kPa The final pressure is: P2=350 kPa The length is:…

Q: 3. Water is pumped through three pipes in series. Compute the discharge if the power delivered to…

A:

Q: A horizontal pipe carries cooling water at 10°C for a thermal power plant. what is the pressure in…

A:

Q: Water flows through a 2.5 cm pipe at115 L/min and o.15 bar pressure. It vents vertically 1 m above…

A: Given data as per question Diameter of pipe =2.5 cm Flow rate =115 L/min =0.115/60 m3/s Vent height…

Q: Water is to be siphoned from a tank at the rate of 0.095 m3/s. The flowing end of the siphon pipe is…

A: Given: the flow rate of water, Q=0.09 m3s Head load from the summit to end, hf2-3=1.25V22g Heat loss…

Q: uppose the pump of Fig. P14–23 is operating atfree delivery conditions. The pipe, both upstream and…

A: To find : Evaluate the volume flow rate through this piping system.  Given : inner diameter of the…

Q: Air at 300k passes through a 10mm diameter of fixed orifice having a flow capacity constant of 7.4.…

A:

Q: 8.59 Two tanks A and B, of constant cross-sectiona! area of 10 m² and 2.5 m², respectively, are…

A:

Q: Water at 16,2°C is to be discharged from a reservoir at a rate of 16,2 L/s using two horizontal cast…

A: The diagram of the above system is given as, On applying Bernoulli’s equation at points 1 and 3,

Q: Water flows at the rate of 0.015 m/sec from open reservoir A to open reservoir B (both are large…

A: Given: The flow rate of the water is 0.015 m3/s. Dimensions of the pipes are: L1=800 mD1=16 cmL2=200…

Q: Three pipes are connected in parallel. The difference in heads in each pipe is 40 m. Pipes Diameter…

A:

Q: A conical tube is fixed vertically with its smaller end upwards and it forms a part of the pipeline.…

A: Given: D1 = 245 mm D2 = 467 mm L = 1.8 m Q˙= 128 litres/s = 0.128 m3/s

Q: Calculate the hourly energy cost for pumping riverwater at 288.706K, from a river to a hilltop,…

A:

Q: Question-1 In the transmission system shown in Figure below, EA = 155 m and ED = 175 m. The…

A: Given Pipe AB  L=120m   and d=60cm       Pipe CD  L=850m   and d=60cm Pipe BC1  L=200m   and d=30cm…

Q: The properties of the air in the inlet section with A1 = 0.2562 m2 in a converging-diverging channel…

A: Given data, The schematic diagram of given system is shown below –

Q: 70. A siphon (an inverted U-tube) is used to steadily withdraw water from a large reservoir. The top…

A:

Q: In the figure shown below there are 125 ft of 2-in pipe, 75 ft of 6-in pipe, and 150 ft of 3-in…

A:

Q: As shown in Fig. 4.33, the pipe diameter is d = 25 mm. l1 = 8 m; l2 = 1 m; H = 5 m. The nozzle…

A:

Q: 5.101 (wLa A horizontal Venturi flow meter consists of a con- verging-diverging conduit as indicated…

A: Question: to calculate flow rate through venturimeter Methodology: Bernoulli's theorem is first…

Q: A sump pump (used to drain water from the basement of houses built below the water table) is…

A: m• = 0.85 L/s = 0.85 × 10-3 m3/s  P = 3.05 × 105 Pa. a) di = 2.8 cm = 0.028 m  ∆h = 2.4 m = 2.4 m…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.