What conditions must be followed to perform complexometric titration?

Q: In what molar ratio do the titrant and KHP react

A: Given:   Trial-1 Trial-2 Trial- Mass of KHP (g) 0.3130 0.3040  0.3059 Final burette reading…

Q: In Standardization of HCI with Na,CO3 titration we use: Select one: O a. Potassium chromate…

A: When HCl solution is standardized by using sodium Carbonate Solution, then HCl is added with sodium…

Q: titration curve in acid-base titration is all acid-base indicator are suitable for use .a weak acid…

A: The question is based on the concept of titrations. we have to identify the correct statement…

Q: How many milliliters of 0.0991 M LiOH are required

A: Given :- Molarity of LiOH solution = 0.0991 M  Molarity of HCl solution = 0.0839 M  Volume of HCl…

Q: Create a schemantic diagram of qualitative analysis for NaCl.

A: NaCl contains Na+ as the metal cation and Cl- as the nonmetal anion.

Q: An unknown solution is red with phenol red and colourless with thymolphthalein. From that…

A:

Q: purpose of a dropwise rate

A: The purpose of titration to determine the concentration of unknown acid or base.

Q: Explain the difference between the equivalence point and the end point ofa titration.

A: The difference between the equivalence point and the end point of a titration has to be given.

Q: why we use methyl orange as indicator in titration of strong base with weak base and not the…

A: NOTE : There is a typo error in the question. The correct question will be, "why we use methyl…

Q: Use acid-base titration to determine the concentration of: – A weak acid: CH3COOH 0.100 M NaOH…

A: Since the given data is of strong acid only, thus concentration of strong acid has been determined.…

Q: In the titration of 50.00 mL 0.0200M weak base B using 0.0150 M HCI, which indicator is the best one…

A: Given: Weak base = 0.0200 M Volume of weak base = 50.0 mL Concentration of base = 0.0150 M pKb of…

Q: Draw the conductometric titration curve of the titration of a weak base with a weak acid in equal…

A: Conductance measurements are frequently  employed to find the endpoints of acid-base and other…

Q: 3. In the conductometric titration, the concentration of alkali is five time stronger than the…

A: conductometric titration

Q: How would the titration curves differ if the volume of the acid used was halved?

A: Answer - Titration curve - A titration curve is a graph that shows both the volume of a chemical and…

Q: Titration Titrant Reductant/ Oxidant Analyte Standardizing Indicator Reagent COD BOD INDIRECT…

A: Given:- Titration Titrant Reductant/ Oxidant Analyte Standardizing Indicator Reagent COD BOD…

Q: encountered during the analysis in double indicator titration (determining of carbonates in a…

A:

Q: 20 In conductometric titration the titrant must be less concentrated then analyte. * 1 Point) True…

A: 20) The given statement is, In conductometric titration, the titrant must be less concentrated then…

Q: Discuss the role of indicators for the titration procedure

A: Indicators are a type of organic compound that changes color according to the change in pH. These…

Q: Which of the following statements regarding complexometric titrations is incorrect ?

A: Complexometric titrations: It is a kind of Volumetric analysis , where formation of colored complex…

Q: 1) What is the different between volumetric titration and condumetric titration?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Which reagent directly reacts with substance to be titrated? Method – bromometry: Br2: I2; KBr;…

A:

Q: 25 mL of a mixture of NaOH and Na 2 CO 3 was titrated with 0.1 HCI using enolphthalein indicator…

A: This question belongs to the titration of a mixture of the strong and weak base against strong acid…

Q: When you titrate a weak acid, use an indicator with a. None of these b. Basic transition range c.…

A: Weak acids are very weakly dissociated to give H+(aq) when dissolved in water.  Examples of weal…

Q: What is the pH at exactly 1/2 of the volume required to reach the equivalence point in the titration…

A: Since you have asked multiple questions we will solve 1st one for you. If you want an answer to…

Q: The color change at the endpoint should persist for 30 seconds. Explain why the time lapse is a good…

A: Solution-  Some chemical reaction occure more slowely thanusual due to1.when mixing of reactant is…

Q: Which one is not the correct experimental condition for complexometric titration? a) Need strong…

A: Following option is not correct for complexometric titration :

Q: Draw the conductometric titration curve for the titration of an equal concentration of a strong base…

A: We know that  Conductometric titration : Conductometric titration is a type of titration in which…

Q: C Complexometric Titration

A: One of the main problems in laboratory soil analysis is the selection of the determination system of…

Q: How is the equivalence point determined in potentiometric titrations? Please explain briefly.

A: Answer is explained below.

Q: 3. distinguish between: a) the equivalence and the end titration b) direct titration titration point…

A: A question based on acid-base titration that is to be accomplished.

Q: Why does an acid-base titration curve (pH versus volume of titrant) have an abrupt change at the…

A: Please find your solution below : Equivalence point is a point in titration at which the amount of…

Q: What is the difference between endpoint and equivalence point in acid-base titration?

A:

Q: Which of the following indicates buffering in the titration given in the image below? 12 11 10 Point…

A: The word buffer has the ability of being able to resist drastic changes in pH upon addition of…

Q: What would be an appropriate indicator to use to measure the endpoint volume for a titration with a…

A: While choosing an indicator for acid-base titrations, an indicator whose pH range falls within the…

Q: What is the difference between 1X and 5X buffer solution that have the same recipe?

A: The strength of a stock solution is expressed with the symbol X. This notation is more beneficial to…

Q: 13.In sampling, a producer's risk (type 1 error) is usually occur when a bad batch was accepted 14.A…

A: Producer's Risk is the basically the probability of rejecting a compliant lot ,having a level of…

Q: Which type of indicator is used in permanganatometry titrant plays role of indicator by itself;…

A: There are many techniques which are used to determine the quantitative analysis of analyte.…

Q: Hatsume Mei wanted to maintain the pH of a certain solution within a specified range. What should…

A:

Q: How would you know which argentometric titration is best to use?

A: The process of determination of the content of the substance based on the precipitation reaction…

Q: Create a schemantic diagram for qualitative analysis for NiS2O3.

A:

Q: Classification (acidic/basic & bufferisolution) Observed Color & Volume of Solution Calculated pH…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: What Volume of the titrant is needed to reach the End Point having 5g of sample and 1N H2SO4 as a…

A: According to law of equivalence, an acid exactly neutralizes the same number of equivalents of base…

Q: Topic: Acid-Base Titration What is a primary standard? What are the requirements to consider a…

A: In titration, primary standard is a chemical solution which is used to determine the unknown…

Q: Create a schemantic diagram of qualitative analysis for CoCO3.

A:

Q: Complexometric titration must be performed at pH 10.0

A: Complexometric Titration is basically a type of volumetric titration where a colored complex is…

Q: What is the commonly employed titrant in nonaqueous acidimetry

A: Generally solution of HClO4 in either glacial acetic acid or dioxane solution is used for titration…

Q: How to distinguish between an Acidic Buffer and Acidic Solution as well as Basic Buffer and Basic…

A: An acidic solution will have a pH anywhere from 0-6 and upon addition of a small amount of strong…