Answered: What is the best estimate of the…

Science

Physics

What is the best estimate of the internal resistance r of a depleted (also called "flat") used battery?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 46P: An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C...

See similar textbooks

Related questions

Q: Dry air is a pretty decent insulator; it has a very high resistivity of 3 × 1013 N. m. Consider a…

Q: If R-202, then the equivalent resistance (in 2) between points A and B is:

Q: Two conductors are made of the same material and have the same length. Con- ductor A is a solid wire…

Q: Which of the following graphs represents Ohm's law for a solid conductor at the constant…

A: Option (B) is correct.

Q: If you touch the terminal of a battery, the small area of contact means that the skin resistance…

Q: We have referred to resistorsdissipat-ingheat, i.e., we have assumed thatP=I∆V is always greater…

A: Question : We have referred to resistors dissipating heat, i.e., we have assumed that P=I∆V is…

Q: TA wire A wire B se/2 Assume thot same voltage is applied Current density accras these for wines…

Q: Consider a resistor network connected to a 32.0-V battery as shown. The battery has negligible…

Q: determines he resistance Conducter? Of a

A: Resistance of a conductor is defined as the property of a conductor to oppose the flow of current.…

Q: What can be concluded from the computed average percent error with reference to the 5% tolerance of…

A: Percent error is the difference between estimated value and the actual value in comparison to the…

Q: The interior of thehuman body has an electrical resistivity of 0.15 Ω # m. (a) Estimatethe…

Q: The time needed for fully charging of the capacitor is 50ms for an RC charging circuit. If the…

A: Time , T = 50 ms = 50 x 10-3 s Capacitance , C = 17 x 10-6 F To find = resistance

Q: Why the resistivity of Copper Wire cannot found by Analogue Ammeter??

A: Resistivity is constant for the given material that is resistivity of different copper wires of any…

Q: What is the voltage drop across the 5 ohm resistor? Your answer 60 U ww 42 v=? What is the voltage…

Q: . A certain lightbulb has a tungsten filament with a resistance of 19.0 N when at 20.0°C and 140 N…

Q: ce of the combination of the r

A: GivenRA=25 ΩRB=30 ΩRC=15 ΩRD=10 Ω

Q: Let V' = 6V , and assume all the resistors are identical. Determine the potential difference Va –…

A: Kirchhoff's current law states that the algebraic sum of currents meeting at a junction in a closed…

Q: What is the equivalent resistance e xplain be tween pts A * B f the netubnk Shown n the figure?…

Q: Nichrome wire of cross-sectional diameter 0.499 mm is to be used as a so-called heater wire. The…

Q: The Nichrome unit (ρ = 660) in a toaster has a resistance of 24 ohms. What is the resistance of a…

A: Given resistivity of Nichrome wire = ρn = 660 Ω.m resistance of Nichrome wire= Rn = 24 Ω length of…

Q: Determine the active and reactive power in the load and the power factor if it is known that the…

A: active power=12V0I0cos(φ) reactive power=12V0I0sin(φ) where V0 is the peak voltage and I0 is peak…

Q: Calculate the voltage across a 1.0 k Q resistor when the current through it is indicated by the…

A: Given data: Resistance (R) = 1.0 kΩ Current (I) = 10 mA Required: Voltage (V)

Q: Rank the following arrangements of three identical resistors according to decreasong equivalent…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: What should be the internal resistance in a battery to provide the maximum power transfer to the…

A: internal resistance

Q: A voltage of Vo is applied from the battery to the RC circuit as shown in the figure. The potential…

Q: The wires of our appliances are insulated with a material mixed with rubber, which has a very high…

A: Since you are not mention which question to answer. I answer the first question. Please…

Q: What sp

A: Ohm's law is one of the fundamental relationships that is found in maximum electronic circuits.…

Q: If three cells of 1V, 1.5V, 2V are connected in series, then the total e.m.f will be:

A: Given, Three celss are connected in series

Q: Unreasonable ResultsTwo resistors, one having a resistance of 145 Ω , are connected in parallel to…

A: R1 = 145 ohm R = 150 ohm

Q: typical smartphone Li-Ion battery has a nominal voltage of 3.7 V and is rated at 4200 mAh. Assuming…

A: Charge q = It

Q: Can you think a situation in which measurement of a resistor’s value would be important?

A: When we apply potential difference across a circuit then current flows through the circuit. To…

Q: Calculate the collector-emitter voltage for this emitter-stabilized circuit. +15V

Q: A circuit design calls for a 1.5-kΩ resistor to have 4.7 V across its terminals. What would he the…

A: Current i=voltage/resistance Voltage=4.7volt Resistance=1.5×10^3 Ohm=1500 Ohm So i=4.7/1500…

Q: Consider a hollow spherical conductor of inner radius a and outer radius 3a. The conductivity…

A: (a) Write the formula for the resistance.

Q: (a) Digital medical thermometers determine temperature by measuring the resistance of a…

Q: Given n resistors each of resistance R, how will you combine them to get the (i) maximum (ii)…

A: Given: n resistors each of resistance R

Q: Integrated ConceptsIf you wish to take a picture of a bullet traveling at 500 m/s, then a very brief…

A: The time constant of an RC circuit is τ=RC where R= resistance, and C= capacitance.

Q: The pitential at the terminals of the battery falls from aV on arcost to a volts when a resistar of…

A: Given EMF E = 9 Volt External resistance R = 10 0hm Terminal potential V = 6 volt

Question

What is the best estimate of the internal resistance r of a depleted (also called "flat") used battery?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

To determine:

VIEW

Explanation of the solution:

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check Your Understanding A strain gauge is an electrical device to measure strain, as shown below. It consists of a flexible, insulating backing that supports a conduction foil pattern. The resistance of the foil changes as the backing is stretched. How does the strain gauge resistance change? Is the strain gauge affected by temperature changes?
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
Check Your Understanding In considering the following schematic and the power supplied and consumed by a circuit, will a voltage source always provide power to the circuit, or can a voltage source consume power?
What special relationship can be observed if you a have a number of resistors with same ohmic value?
I have a non-ohmic resistor that is modeled by I=AeBV, and I was asked to calculate the resistance at 4.5V using the formula R=dV/dI. I'm confused as to how to set this up.
Using the exact exponential treatment, find how much time is required to discharge a 268-µF capacitor through a 498-Ω resistor down to 1.00% of its original voltage?____ s
Equation P = I2R Seems to suggest that rate of increase of internal energy in a resistor is reduced, if the resistance is made less. Equation P = V2/R seams to suggest just the opposite. How do you reconcile this apparent paradox?
Assuming a constant temperature coefficient of resistivity, what is the maximum percent decrease in the resistance of a constantan wire starting at 20.0ºC ?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 132 pF capacitor through a 73 MΩ resistor to 90% of its final voltage.
A high tension (HT) supply of, say, 6 kV must have a very large internal resistance. Why?
In the circuit shown,Determine the following:A. Magnitude and direction of the currentB. The potential differences Vad, Vcf and Vhe
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M Ω resistor to 90.0% of its final voltage.