What is the potential energy of a 300 kg body if it strikes the ground from a 50 m elevation? A. 127.15 KJ B. 137.15 KJ C. 147.15 KJ D. 157.15 KJ

Q: PROBLEM 3. The aluminum rod has a solid circular cross-section and supports the loading shown.…

A:

Q: 1.A boiler burns fuel oil with 20% excess air. The fuel oil may be represented by C15H32.Calculate…

A: Given data: excess air=20% Need to determine the air fuel ratio by weight.

Q: Given that T = 50 kN and W = 40 kN, determine the magnitude and sense of the moments about point B…

A:

Q: Air passes from a fan exit into a turbofan engine core at the rate of 62 kg/s. The air then passes…

A:

Q: Consider a cold air-standard Diesel cycle. Operating data at principal states in the cycle are given…

A:

Q: A certain fighter aircraft is set to travel at a speed of 3200km/h. The ambient temperature is…

A:

Q: Determine the tension in the cord and reaction. on the sphere of (50N) of inclion plane acting…

A: When an object hanged on the rope or the chain, then the force act on the rope will act in the…

Q: Consider a cold air-standard Diesel cycle. Operating data at principal states in the cycle are given…

A:

Q: A new fuel for combustion was found to have the following composition: carbon 71.6%, hydrogen 4.8%,…

A:

Q: A car has a natural frequency of 20 m/s without passengers, when there are passengers inside it has…

A: Natural frequency of car without passenger is given by, ωn=km rad/sec where, k = stiffness of car…

Q: 17-102. The 25-lb slender rod has a length of 6 ft. Using a collar of negligible mass, its end A is…

A:

Q: stone has initial velocity of 200 fps up to the right at a slope of 4 to 3.  The components of…

A: Given DataVi=200 fpsax=-12 fps2ay=-20 fps2 To find  Acceleration at top path

Q: Q2: Determine the state of stresses at point A on the cross section of the pipe shown in Fig. D=50mm…

A:

Q: If the maximum permissible shearing stress is 10,000 psi, how many 3/8'' bolts arranged in a 5''…

A: Shear stress can be understood as the force which tends to cause deformation of a material by…

Q: Calculate the elongation of a solid steel shaft of SAE 1030 carbon steel 2 7/8 inches in diameter by…

A: Elastic modulus is often referred to as tensile modulus or elastic modulus. Every material has a…

Q: Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator…

A:

Q: Write TRUE is the statement/s is True. If the statement is false, identify the word/s that makes the…

A: The chip compression ratio can be defined as the ratio of the chip thickness and uncut chip…

Q: Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The…

A:

Q: 4. Calculate the total turbine work of the cycle. a. 1,936.2 kJ/kg b. 1,293.6 kJ/kg c. 1,629.3 kJ/kg…

A: Given: →h1=3348.4 KJ/Kg ; →h2=2963.5 KJ/Kg→h3=hf+xhfg@0.7MPa=697.22+0.9895×2066.3=2741.82…

Q: For the double slider mechanism shown in the following figure, the crank OA rotates at a uniform…

A:

Q: Draw the shear-force and bending-moment diagrams for the simply supported beam shown. Determine the…

A:

Q: ANCIENT INVENTION Mechanical Clock 725 A.D. Do and Answer the following Question: 1. Make a…

A: Given questions: 1. Make a description of Mechanical clock2. What is the invention?3. What are the…

Q: The beam shown has an overall length L of 2 metres. A uniform distributed load of 3.0 kN/m is…

A: Bending Moment at any section X-X is resultant algebraic sum of moments caused by transverse forces…

Q: Musical Instruments: A man wants to learn to play guitar. He finds a model he likes for $559. He…

A: When a string's end is fixed, the string's displacement at that end must be zero. A transverse wave…

Q: What is the potential energy of a 300 kg body if it strikes the ground from a 50 m elevation? A.…

A: Given : mass of body, m = 300 kg            elevation , h = 50 m To find : potential energy

Q: A structure formed by the two bars AB and BG, joined by means of a bolt at B. At C it has a…

A:

Q: Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The…

A:

Q: At C two cables are tied and loaded as shown in Fig. figure. Knowing that Q = 60 lb, determine the…

A:

Q: Water flows from a tank to atmosphere along a pipe length 40 m. At inlet pipe has a 17 m length and…

A: Total length of the pipe, L=40 mInlet pipe length, L1=17 mInlet pipe diameter, d1=50 mm =0.050…

Q: Draw the kinematic diagram of the given mechanism below. Calculate its mobility as well in terms of…

A: I

Q: Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 27 °C, with a…

A:

Q: 23.A/ A particle moves along the x axis. Its position varies with time according to he expression…

A:

Q: Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 27 °C, with a…

A:

Q: The asymmetric simple truss is loaded as shown. Determine the reactions at A and D. Neglect the…

A: When an object is placed under the push or the pull, then it is possible that the shape of the…

Q: Question (2): The spring-mounted 0.7-kg collar A oscillates along the horizontal rod, which is…

A: Given data as per the question Mass of collar =0.7 kg coefficient of kinetic friction =0.4

Q: A rectangular plate is 4 feet long and 2 feet wide. It is submerged vertically in water with the…

A: Consider a plane surface having area A is submerged in a static mass of liquid having weight density…

Q: Find the sum and angle of two displacement vectors A and B Laying in the XY- Plane and given by A =…

A: Given data The given vectors are :A→ = 2 i^ + 2j^B→ = 2i^ - 4j^ We have to find the sum and angle of…

Q: Nanometer is equal to ------------- meter.

A: To find : 1 Nanometer into meter

Q: Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 27 °C, with a…

A:

Q: two beads are sliding freely on a horizontal rod. Use the following conditions. mA = 3 kg, mB = 1…

A:

Q: State and prove Dimension Theorem.

A: In mathematics, the dimension theorem for vector spaces states that all bases of a vector space have…

Q: Consider the steady, two-dimensional velocity field given by V=(1.3+2.8x)/+(1.5-2.8y)/ Determine;…

A: Determine:   (i) the fluid speed at origin;   (ii) the location of stagnation point in the flow; and…

Q: A flat plate with a central hole is subjected to an axial tensile force F of 9.8 KN, as shown in the…

A:

Q: . Spring is hung vertically, and an object of mass (m) is attached to its lower end. spring…

A:

Q: Q1: A: A steam generator operates at 15 bar absolute pressure. The economizer receives the water at…

A:

Q: (iv) Show that the Kelvin-Planck and the Clausius expressions of the second law are equivalent.

A: To Show:-  Kelvin-Planck and Clausius expressions of the second law are equivalent.

Q: Two helical gears have shafts at 90° and a center distance of 364 mm. The speed ratio is 31 The…

A: helical gears are used to have a smooth operation. the two mating helical gears .they can be…

Q: soccer player's head. After the soccer player heads the ball, it has a velocity of 30 fps at 20° to…

A:

Q: A Particle undergoes simple harmonic motion with a frequency of 10 HZ. Find the displacement X at…

A: This problem is related to the simple harmonic motion. If X is the displacement and time t, then the…

Q: If the density of a gas is 0.003 slug/ft³, what is the specific weight of the gas? a) 15.2 N/m³ d)…

A:

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.