When a person stands on tiptoe (a strenuous position), the position of the foot is as shown in Figure a. The total gravitational force on the body, F is supported by the force n exerted by the floor on the toes of one foot. A mechanical model of the situation is shown in Figure b, where T is the force exerted by the Achilles tendon on the foot and R is the force exerted by the tibia on the foot. Find the values of T, R, and e when F, =n = 675 N. (For e, enter the smaller of the two possible values between 0° and 90°.) Achilles tendon Tibia 15.0°- 18.0 cm 25.0 cm a T = N R =| Need Help? Read It

When a person stands on tiptoe (a strenuous position), the position of the foot is as shown in Figure a. The total gravitational force on the body, F is supported by the force n exerted by the floor on the toes of one foot. A mechanical model of the situation is shown in Figure b, where T is the force exerted by the Achilles tendon on the foot and R is the force exerted by the tibia on the foot. Find the values of T, R, and e when F, =n = 675 N. (For e, enter the smaller of the two possible values between 0° and 90°.) Achilles tendon Tibia 15.0°- 18.0 cm 25.0 cm a T = N R =| Need Help? Read It

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter8: Rotational Equilibrium And Dynamics

Section: Chapter Questions

Problem 24P: When a person stands on tiptoe (a strenuous position), the position of the foot is as shown in...

See similar textbooks

Similar questions

BIO The arm in Figure P10.35 weighs 41.5 N. The gravitational force on the arm acts through point A. Determine the magnitudes of the tension force F1 in the deltoid muscle and the force Fs exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. Figure P10.35
When a person stands on tiptoe (a strenuous position), the position of the foot is as shown in Figure P8.24a. The total gravitational force on the body, Fg, is supported by the force n exerted by the floor on the toes of one foot. A mechanical model of the situation is shown in Figure P8.24b, where T is the force exerted by the Achilles tendon on the foot and R is the force exerted by the tibia on the foot. Find the values of T, R, and when Fg = n = 700. N. Figure P8.24
A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the floor (Fig. P14.64). A rope is attached to the other end of the rod. Find the magnitude of the tension in the rope if the angle between the rod and the rope is 90.
BIO When a gymnast performing on the rings executes the iron cross, he maintains the position at rest shown in Figure P10.85a. In this maneuver, the gymnasts feet (not shown) are off the floor. The primary muscles involved in supporting this position are the latissimus dorsi (lats) and the pectoralis major (pecs). One of the rings exerts an upward fore Fh on a hand as shown in Figure P10.85b. The force Fs is exerted by the shoulder joint on the arm. The latissimus dorsi and pectoralis major muscles exert a total force Fm on the arm. (a) Using the information in the figure, find the magnitude of the force Fm. (b) Suppose an athlete in training cannot perform the iron cross but can hold a position similar to the figure in which the arms make a 45 angle with the horizontal rather than being horizontal. Why is this position easier for the athlete? Figure P10.85
The Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.
The Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.
An auto magazine reports that a certain sports car has 53% of its weight on the front wheels and 47% on its rear wheels. (That is, the total normal forces on the front and rear wheels are 0.53w and 0.47w, respectively, where w is the car’s weight). The distance between the axles is 2.46 m. How far in front of the rear axle is the car’s center of gravity?
A lunch tray is being held in one hand, as the drawing illustrates. The mass of the tray itself is 0.300 kg, and its center of gravity is located at its geometrical center. On the tray is a 1.00 kg plate of food and a 0.330 kg cup of coffee. Obtain the force T exerted by the thumb and the force F exerted by the four fingers. Both forces act perpendicular to the tray, which is being held parallel to the ground.T = N (downward)F = N (upward)
You hold a softball with a weight of 1.80 N in your hand as shown in the figure. Your arm is moving, but at the instant shown, your arm is horizontal. Consider your forearm and hand to be a uniform rod with a mass of 1.65 kg and the distance between your elbow joint and the ball in your hand is 2L = 26.0 cm. Your biceps exerts an upward, vertical force of 13.5 N on your forearm and is attached a distance of d = 2.60 cm from your elbow. (a) Using your elbow joint as the axis of rotation, determine the magnitude of the net torque acting about your elbow due to the weight of your forearm/hand, the weight of the ball, and the force applied by your bicep. N · m (b) In which direction will your forearm and hand rotate, given the signed value of the net torque calculated in part (a)? clockwise counterclockwise no rotation
A uniform ladder stands on a rough floor and rests against a frictionless wall as shown in the figure. Since the floor is rough, it exerts both a normal force N1 and a frictional force f1 on the ladder. However, since the wall is frictionless, it exerts only a normal force N2 on the ladder. The ladder has a length of L = 4.4 m, a weight of WL = 53.5 N, and rests against the wall a distance d = 3.75 m above the floor. If a person with a mass of m = 90kg is standing on the ladder, determine the following. (a) the forces exerted on the ladder when the person is halfway up the ladder (Enter the magnitude only.) N1 = ? N N2 = ? N f1 = ? N (b) the forces exerted on the ladder when the person is three-fourths of the way up the ladder (Enter the magnitude only.) N1 = ? N N2 = ? N f1 = ? N
A 15 kg monkey climbs a uniform ladder with weight 1.2 *10^2 N and length L=3.00 m. The ladder rests against the wall and makes an angle of theta= 60.0 degrees with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope. HInt : Draw a force diagram for the ladder and the normal forces from the ground and wall acting on the ladder. A) find the tension in the rope when the monkey is two-thirds of the way up the ladder. B) The rope is frayed and can support a maximum tension of only 80N. Find the maximum distance that the monkey can climb up the ladder before the rope breaks. C) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (a) and (b)
A uniform ladder stands on a rough floor and rests against a frictionless wall as shown in the figure. Since the floor is rough, it exerts both a normal force N1 and a frictional force f1 on the ladder. However, since the wall is frictionless, it exerts only a normal force N2 on the ladder. The ladder has a length of L = 4.1 m, a weight of WL = 61.0 N, and rests against the wall a distance d = 3.75 m above the floor. If a person with a mass of m = 90 kg is standing on the ladder, determine the following. (a) the forces exerted on the ladder when the person is halfway up the ladder (Enter the magnitude only.) N1 = N N2 = N f1 = N (b) the forces exerted on the ladder when the person is three-fourths of the way up the ladder (Enter the magnitude only.) N1 = N N2 = N f1 = N