Which flow chart is correct? a. evaporati on. depositi on Gas (Liqui d) Gas Solid condensation sublim ati on b. d. melting freezing Solid (Liquid) Solid (Liqui d) condensati on melting A. В O o o o

Q: It is the property of liquids to resist flowing because of the friction and cohesive forces between…

A: Surface tension : is the property of a liquid at rest to acquire minimum surface area. Viscosity :…

Q: Nitroglycerine ( C3H5N3O9) is a very strong explosive that degrades over time and is too shock…

A: The balanced explosion reaction taking place is given as, => 4 C3H5N3O9 (l) ---------> 6 N2…

Q: On an expedition trip, you were carrying some close system containers containing some unknown…

A:

Q: A liquid property responsible for its resistance to flow is called what?   a. viscosity b. density…

A:

Q: Antarctica contains 26.5 million cubic kilometers of ice. Assume the temperature is -20 degrees…

A: SOLUTION: Step 1: The density of ice at -20 degree Celsius = 920 Kg/m3 =9.2 ×1011 Kg/Km3. The volume…

Q: 11. Write a Claim/Evidence/Reasoning response to answer the question: What state of matter would you…

A: Goldilocks zone or circumstellar habitable zone is the range of orbit from a star in which a life…

Q: Which of the following is not considered a non-Newtonian fluid?   A. Ketchup   B. Silly putty   C.…

A: A fluid is a material that continuously deforms (flows) in the presence of shear stress or an…

Q: 9. Write a Claim/Evidence/Reasoning response to answer the question: What state of matter would you…

A: There are mainly three states of matter,  such as solid , liquid and gases .

Q: F, E. B. Temp. (°C) 150 135 120 |D 105 06 75 C. 09 45 30 15 Heat (kJ) Created by E. Lee for Virtual…

A: Answer: Given curve represents pattern of the increase in temperature of the crystalline substance…

Q: O A В D -bserved to be a mixture of solid, liquid ks the temperature and pressure? O E F G H O A В D…

A: Phase diagram is drawn between pressure and temperature, to identify the phases of substance at…

Q: Normality

A: Normality in chemistry is one of the expressions used to measure the concentration of a solution. It…

Q: An experiment was set up to test the hypothesis that increasing the temperature increases the rate…

A:

Q: List the factors that affect the rate of diffusion?

A: Diffusion can be defined as a process in which there is movement of substances from region of higher…

Q: . Describe the shape, volume, and particle movement in different phases.

A: a) Solids In solids, particles are tightly packed. Also these particles have strong inter molecular…

Q: In this set-up, what will happen to the liquid in the glass tubing when the contents of the vial has…

A: A question based on physical chemistry, which is to be accomplished.

Q: ____________________ is the separation of material according to density.   a. Accretion   b.…

A: Separation of material according to density is called :

Q: If the scale-pan of weighing balance is not well cleaned during preparations, it could lead to the…

A: 1. Cross contamination is correct answer .

Q: How do you set up the water flow for the apparatus shown below? C O flow in through B, out through A…

A: Various apparatus are being used in the laboratory to perform different experiments, some of them…

Q: Given below is the figure of contact angles of a liquid sample. Which among these contact angles…

A:

Q: Water and ethanol, although they are both clear liquids, can be distinguished from each other by…

A: Water and ethanol have different properties like ethanol ignite easily in presence of oxygen and…

Q: The most convenient method of determining specific gravity of solids heavier than and insoluble…

A: The most convenient method of determining specific gravity of solids heavier than and insoluble…

Q: Graph the following data Temperature (°c) ( x axis) Pressure (torr) ( y axis) 550 25 678 40 800 65…

A: y = 6.357x + 550.0 R2 = 0.9945

Q: Explain the difference between constant rate filtration and constant pressure difference filtration…

A: Answer - According to the question - Given - filtration - Filtration is a physical separation…

Q: Capillary action is the process of water moving up plants, against gravity. Two different properties…

A: Explained as follows

Q: Wet deposition is a continuous process, while dry removal of air pollutants can be realized only in…

A: Wet deposition is a process in which the rain , particles , sleet , and snow become slightly acidic…

Q: How does the ramp rate affect the actual AND observed melting point?

A: Thermal rate effect the actual melting point of subtance, higher the ramp rate higher the observed…

Q: If the boiling point of a liquid is more, its rate of evaporation should be O depending on the kind…

A:

Q: In simple distillation the thermometer bulb should be placed only a few millimeters below the side…

A: Distillation is an analytical process to separate two liquids based on the volatility of the liquid.…

Q: In this set-up, what will happen to the liquid in the glass tubing when the contents of the vial has…

A: The flask appears to be empty. However, a liquid level is maintained in the glass tubing initially.…

Q: Solids have a shape and are definite, compressible definite, incompressible indefinite, compressible…

A: Substances can exist in three basic states of matter. One of the states is solid, which is the…

Q: Dispersed Phase Dispersed Medium Example(s) N/A Name Gas Gas N/A Gas Fog Solid Solid Aerosol Gas…

A: A suspension of particles ( solids, liquid or gas ) in a medium ( solid, liquid or gas ) is called a…

Q: The melting point is the temperature where a solid becomes liquid. The melting point of acetone is…

A:

Q: 2. The viscous force the relative ..... ....... motion between the adjacent layers of a fluid in…

A:

Q: 1. Moisture content dry basis (MC db) is the amount of solid per unit mass of dry solids present in…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In the separation of the Naphthalene experiment.  A student accidentally let some of the vapor…

A:

Q: For solids lighter than water, specific gravity determination is by method. Select one: a. neither…

A: Both methods are useful for determination of specific gravity.

Q: A tank with 43.2 kg of water is leaking at a rate of 0.0135 kg/s. How many hours will it take until…

A: Given, Initial mass of water in the tank = 43.2 kg           Rate of water leakage = 0.0135 kg/sec

Q: eleemn. louple dí ngnam poceu by taling Draw the toanspoot luithe exa mple.

A:

Q: A What is A? Does tap water enter at B or C? What is D called? What process happens at E? What…

A: This is the apparatus showing us the experiment of fractional distillation  Fractional distillation…

Q: The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 poise. Calculate the mean path in…

A:

Q: A student has two rubber balls of different masses to perform an experiment. Which experiment can…

A:

Q: Use the particle model to explain how the size of the particles would affect the rate of diffusion.

A: * particle  therory of matter is a model used to describe movements and arrangements  of atom. *…

Q: Calculate the normality of sulfuric acid has a density of 1.84 g/cm3 and is 95.0% (w/w) H2SO4. Mwt…

A:

Q: More is the surface area of a liquid, high will be its rate of evaporation. Select one: True False

A: The phenomenon of change of a liquid into vapours at any temperature below its boiling point is…

Q: (a) Powder metallurgy (PM) is a net-shape forming process by which fine powdered materials are…

A: 1. Because Powder metallurgy is like casting with powder so we can make any complex shapes which are…

Q: Match the letter on the diagram, with the term that identifies that point 1.00- 0.00o 600 001 Too 00…

A: When there is study of different phases of a component, it will come under the study of phase…

Q: Given: Fresh Mass of soil (FM) = 100 grams; %Moisture Content (MC) = 8%; Bulk Volume (Vb) = 95 cm3.…

A:

Q: Which physical property of liquid is measured using stalagmometer?

A: Stalagmometer is based on the principle of drop method . The weight of the drop falling from the…