2. The viscous force the relative ..... ....... motion between the adjacent layers of a fluid in motion. Which one of the flowing fits best in the sentence? * O a) opposes O b) never affects O c) facilitates O d) may effect under certain conditions

2. The viscous force the relative ..... ....... motion between the adjacent layers of a fluid in motion. Which one of the flowing fits best in the sentence? * O a) opposes O b) never affects O c) facilitates O d) may effect under certain conditions

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter6: Equilibria In Single-component Systems

Section: Chapter Questions

Problem 6.29E

See similar textbooks

Related questions

Q: A right circular cone of base radius R, height H, and known density ρs floats base down in a liquid…

A: Archimedes principle states that the upward buoyant force exerted on a body immersed in a fluid,…

Q: What is a fluid? Discuss some examples of fluids and give an example each Draw a graph (not to…

A: "Since there are multiple sub-parts in this question and it is not mentioned that which one has to…

Q: According to the SI how would you define temperature?a) As the average kinetic energy of particles…

A: According to the SI units the temperature is defined as the average kinetic energy of particles…

Q: Which of the following is not considered a non-Newtonian fluid? A. Ketchup B. Silly putty C.…

A: A fluid is a material that continuously deforms (flows) in the presence of shear stress or an…

Q: The CSA powder pattern is characterized by: A. Siso, Saniso and n B. the three principal values of…

Q: can diffusion be reversed

A: Yes diffusion can be reversed.

Q: Is this whole section correct?

A: The calculation you have done for the finding mass of water is not correct.

Q: If the volume changes due to evaporation between trials 1&2, do you think it will significantly…

A: A question based on properties of liquids that is to be accomplished.

Q: What can you conclude about the strength of the interactions between water particles compared to the…

A: Heat of vaporization Hvap The enthalpy of vaporization, also known as the heat of vaporization or…

Q: hase present at 1 atm e slope between solid i liquid boundary

A: Phase diagram is a type of graph plots to show conditions at which thermodynamically distinct phases…

Q: why spontainiety occur??

A: Spontaneous reaction is the reactions, it occurs without the support of any external force. Gibbs…

Q: "In the figure, a washer on a string (string not shown) moves in the circular path shown in red.…

A: Answer is option b( arrow B).

Q: DETERMINATION OF ABSOLUTE VISCOSITY USING OSTWALD VISCOMETER: A group of students enrolled in a…

A: Given: density of water at 296 K = 997.532 kg/m3 = 0.9975 g/mL absolute viscosity of water at 296 K…

Q: An experiment was set up to test the hypothesis that increasing the temperature increases the rate…

Q: 1. How can the water displacement method be used to measure the density of tan irregularly-shaped…

A: Water displacement method is a method to determine the volume of any solid substance . In this…

Q: surfaces?

A: Microscopes that are used to view metal surfaces are scanning tunneling microscopes. It is termed…

Q: The stalactites and stalagmites in the picture are an example of water... O A. As a transpaent…

A: they are an example of water as an action of density in action in nature. stalagmites grow up in…

Q: How does temperature affect diffusion rate, and why?

A: Diffusion is the movement of substance down its concentration gradient. Particles travels from…

Q: Use the dimensional analysis method, convert 10000000 pound-force in to megapascal.

A: 1 pound-force = 0.00689 MPa

Q: 1. The symbol, , on organic glassware means O (c) standard taper joint O (b) standard size glassware…

A: 1) We have to write the meaning of the symbol given

Q: Would you expect viscosity and diffusion rate to be affected by change in temperature? Why or why…

A: Viscosity and diffusion rate are affected by changes in the temperature

Q: Using the calculated experimental average density of the liquid samples as reference, what is the…

A: Density = (Mass ÷ Volume)

Q: Why are refrigerants used within the vapour-compression system instead of water? They are easier to…

A: The solution is given below -

Q: The process of separating the solid from the liquid can also be accomplished by gravity filtration.…

A: it is quicker ( vaccum filteration is faster than gravity filteration)

Q: uqnecies of trhe bridge to move. This condition is called

A: Three option are given

Q: Compare columns I and II, and write A if the value in column I is greater than in II B if the value…

Q: Build a two-dimensional crystal that contains six formula units of sodium chloride in the solid…

A: Ionic crystal is formed from the ions. The cation is surrounded by a definite number of anions and…

Q: What is the surface tension of benzene(in micro-Newton/m), if it rises to a height of 1.06299 inch…

Q: The graduated cylinders shown here contain equal amounts of the different plant oils. Identical…

A: Viscosity:- Viscosity of fluid is measured of its resistance to flow. Formula F = μA .u/y Where F…

Q: The figures below are of temperature monitos with blue fluid in which a tube (that was also been…

A: Temperature is a physical quantity that expresses hot and cold nature. It is the manifestation of…

Q: Repolarization is caused by rapid outward:

A: Given : To find cause of Repolarization.

Q: swer with the appropriate units. Hint(s)

A: Dear student I have given answer to your question in the image format.

Q: In the separation of the Naphthalene experiment. A student accidentally let some of the vapor…

Q: Calculate the degree of flocculation.

A: The degree of flocculation is defined as the ratio: β=Sedimentation volume of flocculated…

Q: In this viscometer, a liquid is allowed to flow through its capillary tube between two etched marks…

Q: Use the particle model to explain how the size of the particles would affect the rate of diffusion.

A: * particle therory of matter is a model used to describe movements and arrangements of atom. *…

Q: The Miller index for the figure is:

A: wiess indices can be derived by dividing intercept by that of vector. Miller indices will be…

Q: Liquid A is known to have a lower surface tension and lower viscosity than Liquid B. Use these facts…

A: Surface tension is defined as the attractive forces experienced by the surface molecules of a liquid…

Q: For whole blood flowing in a capillary of radius 1.9x10-4 cm, estimate the maximum velocity for…

Q: vork that cc

Q: State “Hardy Schulze Rule” with one example.

A: A colloidal solution can be coagulated if an electrolyte is added to it. Hardy Schulze rule gives…

Q: Does saturated fatty acid has density and viscosity at room temperature. If has what are viscosity…

A: A saturated fatty acid is a fatty acid that does not contain any double bonds.

Q: What intermolecular forces are present in the alkanes ?

A: The intermolecular forces present in the alkanes are to be identified.

Q: The deviation of Raoult's law is associated with the unequal adhesive and cohesive forces-Justify…

A: Raoult’s law states that a solvent’s partial vapour pressure in a solution (or mixture) is equal or…

Q: Liquid X is known to have a lower viscosity and lower surface tension than Liquid Y. Use these facts…

A: Given that liquid-X has a lower viscosity and lower surface tension than liquid-Y.

Q: What does the magnitude of the dispersion force depend on?

A: Intermolecular forces refer to the type of interactions which are present in between atoms or…

Q: Ostwald viscometer is also known as ocillating sphere viscometer falling sphere viscometer glass…

A: Ostwald viscometer is also known as Glass capillary viscometer

Q: What is the principle in involved the centrifugation?

A: Centrifugation is a technique which is used to separate the particles from the solution according to…

Question

Fast I will give u like within 5 min plz

2. The viscous force . . the relative
..... .....
motion between the adjacent layers of a
fluid in motion. Which one of the flowing
fits best in the sentence? *
a) opposes
b) never affects
O c) facilitates
O d) may effect under certain conditions

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Determine Re-face and Si-face?
Solve ASAP with explanation of all parts
What is the surface tension of benzene(in micro-Newton/m), if it rises to a height of 1.06299 inch in a capillart tube with a circumference of 1.570796 mm. The density of benzene is 54.477 lb/ft³. With the contact angle to be 0°.
A right circular cone of base radius R, height H, and known density ρs floats base down in a liquid of unknown density ρf . A height h of the cone is above the liquid surface. Derive a formula for ρf in terms of ρs, R, and h/H, simplifying it algebraically to the greatest possible extent. [Recall Archimedes’ principle, stated in the preceding problem, and note that the volume of a cone equals (base area)(height)/3.]
Calculate the degree of flocculation.
Do parts d,e,f
Would you expect viscosity and diffusion rate to be affected by change in temperature? Why or why not? If so, what is the effect of increased temperature on each property?
When i attempted to submit the answer is shows as incorrect, it states that a phase in the result is incorrect
Please help fill in the rest of the table using the provided data. Show your work.
Four solid metal balls fit snugly inside a cylindrical can. A geometrystudent claims that two extra balls of the same size can be put into the can. provided all six balls can be melted and the molten liquidpoured into the can. Is the student correct? (Hinr. Let the radius ofeach ball be r.)
6.14. As a follow-up to the previous exercise, liquids can be made to freeze if enough vapor is forcibly removed from them and removing heat, say by using a vacuum. Assuming the vapor pressure of remains constant as it cools (a very bad assumption, but see exercise), estimate the mass of ice that will form as vapors are pulled off of ofstarting at . In addition to the data from exercise, use .
1. The rate of the flow of water through a cylindrical tube that has an inner radius of 0.12 cm and a length of 26 cm is 364 cm3 in 88s. The pressure drop between the ends of the tube is 57 torr. Please calculate the liquid's viscosity.